Find a reliable appliance technician in St Ives NSW

Replace our existing 96cm built in rangehood with the 90cm built in new rangehood.The new rangehood is supplied by us. Fill in the gaps (as the new rangehood is smaller than the existing one) professionally with necessary tools and materials so it is properly fixed. You need to be a qualified carpenter/handyman to carry out this job. New rangehood Link: https://www.designerappliances.com.au/schweigen-90cm-undermount-rangehood-stainless-steel-666017

My built-in gas fireplace ignites and operates normally, however the blower fan does not start even after the unit becomes hot. Possible issues may include: blower fan motor snap disc / thermal switch fan controller dust blockage The unit appears quite dusty internally and may require inspection and cleaning. Looking for someone experienced with gas fireplaces and blower fan systems to: diagnose the issue inspect blower/fan area test thermal switch / snap disc advise whether repair or replacement is needed I prefer repair if possible rather than full replacement.

I have a washing machine that needs to be serviced it is off balance.

Miele dishwasher not draining and flashing the f11 error. Removed the micro filter tray and the reverse valve to clean but none of them are causing the water to still drain. Need to come in to help with fixing the dishwasher Model - Miele Jubilee SC

We just moved houses, the connector of machine pipe to the sink pipe is broken during the move. I bought the spare part but hard to fit it. I need someone with more experience to do it

Replace 90cm canopy rangehood (existing duct & wiring)

LG heat pump dryer is working fine but it makes noise when I spins

Hi, I have a Fagor built-in microwave (model 6H-570ATCX). The unit turns on, the light and timer work, and the turntable rotates, but it is not heating. Could you please advise what the likely issue is and provide an estimated repair cost incl. parts? Thank you.

I'm planning to get my gas cooktop replaced with induction. To support this, I need to the electrical connection upgraded from 10 amps to 30 amps. The switchboard is above the fridge, next to the counter with the cooktop. a couple metres distance, maybe a bit more to go behind cupboards.

Need to drill a hole or enlarge a hole in the cabinet and connect the washing machine

Replace wire ring on seal on front loader washing machine . Fisher and paykel smart wash .

Please note scope adjustment - in short I no longer need 15m for the water piping, just 3m. I am after a plumber/gasfitter to replace approximately 15m of gas piping, and 3m of water piping. Water piping is exposed or has been excavated per the images. The gas pipe needs to be installed in the same trench, and the area within 3m of the meter just needs to be rerouted and be re-joined to the existing pipe. If you are able to repurpose the existing 15m of gas piping then that will help save on materials. Digging has already been done and pipework is already in place under the house, which has good access. I have attached a new image to show the changes to help with estimating.

E8 error on Fisher and Paykel dishwasher drawers (top drawer only)

The filter of my washing machine is jammed inside the socket. The handle on the filter has broken off making it difficult to remove. I have a replacement filter so dismantling the filter further won’t be an issue.

License has fitter to convert and connect bbq to natural gas. Need to convert jets on bqq and connect the bbq to the gas socket

Washing machine not working - think the motor is stuck, something may have got down and into it.

This nut is really tight and won’t move. Could someone please loosen it for me?”

Install a 4mm or 6mm for induction cooktop, it will require to the wire from switch box outside of garage to the kitchen, the wire length will be around 30-40m. pls quote supply and install

BDF1410X Beko 60cm Freestanding Dishwasher BDF1410X 14 Place Setting is leaking from the hose at the back

I need an electrician to help me to install Tesla wall connector