Book a trusted oven repair and installation expert in Sydney

I am looking for an experienced and qualified installer to remove my existing kitchen appliances and replace them with two new LG models. What needs to be done: Removal: Disconnect the old built-under dishwasher and built-in oven, slide them out, and move them down to the building's loading dock. Installation: Unpack and properly install the new LG Dishwasher and LG Oven into the existing cavities. Fitment: Ensure both units are securely mounted, perfectly level, and neatly aligned with the cabinetry. Logistics & Setup: Disposal: You do not need to take the old appliances away in a truck or pay tip fees. They just need to be left at the loading dock. Infrastructure: The space is already configured for built-in appliances. Existing plumbing, drainage, and power connections are already in place from the old units. Requirements: Please confirm if you are licensed to disconnect/reconnect the electrical and plumbing for these appliances.

The issue is that the temperature seems much higher than the setting. For example, when it’s set to 150°C, the oven gets extremely hot and doesn’t appear to be regulating the temperature properly. It may need the thermostat or temperature control checked. I’m located in Forest Lodge NSW.

I'm going to order a new 60cm Westinghouse electric oven for my kitchen and wanted to see if a licensed electrician can install it for me. This is replacing an existing 60cm oven. Same size replacement, just an upgraded one.

Our oven isn’t working (and hasn’t been for some time). It keeps shorting the circuit when we turn it on. I think what happened some time ago is I may have over-vigorously cleaned it and I think maybe the thermometer or something has been dislodged and is causing it to short.

There is a combie commical oven that need to be removed and broked down into to get out of kitchen that has closed down. Plus commical wok that needs to be out there as well. Would suit some that has the exoerance dismatling refixing equipment in commical kitchen. Price is flexiable a little

Remove existing Westinghouse built-in electric oven and install new Westinghouse WVE6516DD. Existing hard-wired oven. Dedicated stove circuit already installed. Licensed electrician only. Certificate of Compliance required.

Repair wolf oven and cook top

Wolf cook top and oven both don’t work

Pizza oven exhaust pipe that is connected to wall has a smoke leakage need to seal it with heat resistant material

My oven is over heating. Set at 125 the temperature goes to over 300. It’s a calibration or temperature probe. The oven is a ILVE T906WMP

We have one switch which controls the bathroom extractor fan and also the laundry cupboard light. The extractor fan works, but the light doesn’t we have replaced the bulb which has not helped. Could be a faulty switch that needs replacing. Regarding the oven bulb, sometimes the light works and sometimes it doesn’t.

Need a smeg technician to repair stove cooktop( flame is not properly working on bigger cooktop) and repair buttons on the oven. The oven also needs light replacement

URGENT – Commercial Oven Technician Needed Today Looking for an experienced technician or electrician to install a new Tecnodom commercial oven arriving today at our restaurant in Potts Point, Sydney. Must have experience with commercial kitchen equipment and preferably 3-phase ovens. Need someone able to connect, test, and ensure everything is running correctly. Please message with your experience, availability today, and installation price. Potential ongoing hospitality equipment work available.

Oven repair - grill works but baking function doesn’t

We need a technician/equipment repairer to replace the rubber door seal on our commercial oven. We believe the internal vent/fan panel or surrounding trim may need to be partially removed to access and fit the new seal. We will provide rubber/seal.

Oven has broken, baking no longer works. Heating element possibly broken or the controller. Fan works, light works, grill works. Model number: Blanco BSO 402 W

Need a cast iron hinge on a pizza oven welded

One of the screws on the door handle has come loose and needs to be reattached. This requires removal of the oven door and glass panel inside.

Safely and professionally. Must be certified/qualified. Scope of Works – Disconnections for Disposal 1. Safely disconnect and isolate the oven to allow for disposal. 2. Safely disconnect and isolate the gas cooktop to allow for disposal. 3. Disconnect and cap off the kitchen sink taps as required for removal. 4. Disconnect and cap off both bathroom sink taps to enable disposal of the cabinets.

Oven isn't working, keeps tripping the breaker. Still functions in the microwave mode but not in oven mode for more than 5 minutes. Can be fixed either this afternoon Monday 19 Jan or Tuesday 20 Jan.