Find a reliable appliance technician in Epping VIC

I think it’s been over loaded and is unbalanced plus needs a service, I clean the filter and put a machine wash through it but something is still not right.

I have an issue with my Solar. Solar panels are working, but converter not working. Need fixed.

I was hoping to have 6 camera installed for my recently purchased home in Whittlesea, if you can help with camera installation please. Can you give me a quote for 6 camera installation, will provide camera and Dvr set up. Hoping to install REOLINK. Will need to run data cable for installation, house is single storey, tin roof.

Fridge not cooling. Freezer is fine

already brought the light only need to installed

Task 1. Installing an additional drawer in preexisting kitchen cupboards underneath oven and elevating the oven above. Task 2. Patch an unused heating vent in floor.

Water dripping from the vent on the top next to the tray. Vent shown in the photo

Westinghouse built-in oven • Gas ignites but doesn’t stay on • Suspect issue with thermocouple or gas control, but need an expert to confirm & Fix

Hi, the tap in laundry that you connect washing machine to is leaking from the actual tap fixture part closest to handle. Tried patching diy with plumber tape but didnt seal or rectify the issue. Both the cold/hot side have the same issue. Thanks, Located in Watsonia, VIC. Picture attached. Thanks.

Garage door malfunction. Mcknight GDS 800. Got reset while pairing new remote. Unable to set and save open and close limit. Open limit not saved leading to garage pulled all the way back to motor and ending up releasing manually. Working with remote.

Installation of a dashcam in a Kia cerato, front and back cameras - wired dashcam

Technika Electric inbuilt oven: Yesterday, I set the oven to preheat. After about 2 minutes, it suddenly stopped working and appears to have lost electrical connection. There is no display.

Need this VEVOR slushy machine fixed, it’s not working

JOB DESCRIPTION -> Current cooktop/cooker burner is faulty. Fault Description: - One or more burners on the gas cooktop/cooker are faulty, which may include:* Burners not igniting or failing to stay lit.* Irregular or weak flame patterns.* Gas leaks or improper combustion (e.g., yellow or orange flames).* Damaged burner components (e.g., caps, rings, or jets). Relevant Regulation AS/NZS 5601.1 Gas Installations - Part 1: General installations Contractor Fault Notes: Left hand burner not staying on Below two are the solutions recommended - 1.) Either repair the existing faulty burner OR 2.) Replace cooktop with a 600mm generic make and model; including infill to fit in the new cooktop.

Repair -> Faulty burner cooktop/cooker (gas). Non Compliant Fault Location Cooktop Fault Description One or more burners on the gas cooktop/cooker are faulty, which may include:* Burners not igniting or failing to stay lit.* Irregular or weak flame patterns.* Gas leaks or improper combustion (e.g., yellow or orange flames).* Damaged burner components (e.g., caps, rings, or jets). Relevant Regulation AS/NZS 5601.1 Gas Installations - Part 1: General installations Contractor Fault Notes Left hand burner not staying on

So I had a faulty cablemod extension cable go faulty and it melted my connector. I can get the gpu to work but I have to leave a little force on the connector which im not comfortable with doing? Anyone have connectors on hand and willing to do it for me? Can come to you

Rangehood filter is damaged and needs a replacement

Looking for qualified technician who can install new rangehood. I know it will heavy for one person to grab it so I am happy to assist.

I need to get the rangehood changed at my parents house. Ideally supply and fitted or I can supply own rangehood if easier. Current rangehood dimensions 900mm width 55mm height 500 depth (roughly)

I need help to disconnect a free standing gas cooktop. Location is Epping VIC. Please let me know if you can help. Thank you.