Find a reliable appliance technician in Brisbane

Bought a new induction stove and require an electrician to remove the old electric stove and put in the new induction one. 600mm in size, currently have a 600mm in, and shouldn't need any modifications. Its currently got a 32amp power supply wired in.

Looking for a qualified commercial refrigeration technician who may be available ASAP to diagnose and repair a Sanden SPC-1207A two door underbench commercial fridge at our cafe in Newstead. The fridge is still cooling, but very slowly and struggling to maintain temperature during normal use. Symptoms: * Set to 2degrees * Has previously reached around 2.9–3 degrees overnight when left untouched * During normal cafe use it has been rising to around 10–15C+ * Compressor and condenser fan are running, but cooling/pull down is very slow * Air from the evaporator feels cool, but not particularly cold * Condenser has already been cleaned * Both condenser and internal evaporator fans appear to be operating * Area around the fridge is approximately 27–28C, so not excessively hot * Temperature logger shows some regular temperature rises approximately every 6 hours, possibly normal off cycle defrost * Restarting the controller brings the compressor back on, but the fridge still cools slowly * Door seals are also being replaced tomorrow The unit uses R134a. We’re looking for someone who can properly diagnose the refrigeration system, refrigerant charge/leak, restriction, compressor performance, airflow, controller/defrost etc. — rather than simply adding refrigerant without testing. This is an important milk fridge for our cafe, so we’re hoping to find someone who can attend before Tuesday if possible. Please let me know your availability, call out/diagnostic fee and whether you work on commercial refrigeration.

Reaching out to see if you can help us sort out a coffee cart setup (or if you can recommend someone who can). We are looking at getting the below done: Electrical Setup / Power Compatibility: Our coffee machine is 20A (Bezzera Ellisse 2-group), but the cart is currently set up for 15A. We need to look at our options to safely power it. Coffee Machine Service & Testing: Full service, test, and tune-up to get the Bezzera Ellisse running properly & Grinder. Cart & Water System Check: Test the cart's electrics and get the side water pump system hooked up and operational. Would love to know if you have availability for this and if you could provide a rough quote to get us up and running.

Hi! I'm looking for someone to help reverse the door opening direction on my bottom-freezer fridge. The fridge currently opens from one side, and I'd like to switch the hinges so that both the fridge and freezer doors open from the opposite side. LG GB-450UPLE - Capacity: 450L - Bottom-freezer configuration - Finish: Dark Graphite - Width: 700 mm - Height: 1724 mm This is the type of work I'm looking to have done: https://www.youtube.com/watch?v=utp7FVhH0N8 Ideally looking for someone who: - Has experience reversing fridge doors, particularly bottom-freezer models - Has their own tools - Can safely remove, reposition and reinstall both doors, ensuring they close and seal properly Located in West End. Flexible with timing. Thanks!

Robatherm RM1434 needs to be checked and repaired. It turns on, Stop/Reset button works, but the screen is off with the rest of the buttons

My Dyson stick vacuum needs cleaning/detailing

I need my Dyson stick vacuum cleaned and detailed

My Dyson stick vacuum needs a thorough clean/detail

Looking for someone experienced to remove and dispose of our existing washing machine and wall-mounted dryer, and install our new washing machine and dryer. The job involves: Removing our existing washing machine and wall-mounted dryer. Taking both old appliances away for disposal. Installing and connecting our new front-loading washing machine. Wall-mounting and installing our new dryer above the washing machine. Checking whether the existing dryer bracket can be reused. We’re unsure if it’s compatible, so we’d need your advice and potentially a new bracket. Safely disconnecting/reconnecting the water supply to the washing machine (including turning off the apartment’s water if needed). Testing both appliances to make sure everything is working properly, with no leaks and the dryer securely mounted. Access: We’re in an apartment building in Brisbane City, but access is very straightforward. If your vehicle is under 2.1m high, you can drive directly to our apartment door without needing to use the lift. A few things to note: Please come with the necessary tools and equipment, including anything required to safely lift and mount the dryer. I’ve attached photos of both the existing setup and the replacement appliances. We’d like someone who can handle the entire job, including removal, installation and disposal.

I need someone to come have a look at the fridge as it’s not cooling anything. May need a new part. Looking for fridge specialist

Licensed plumber needed to install two new washing machine taps to wall directly behind existing shower. See photos cold and hot water taps for shower clearly visible through opening in wall. Rough in and finish on the same day using copper pipes to match existing. Standard washing taps will be supplied by me. Photo are uploading now.

Water not draining properly, needing help to remove cap to clean filter, its very hard to undo, may be stuck closed. Please help!

Fisher and paykel 2-drawer dishwasher, top drawer not draining. Need it fixed

I need to get someone to fault find on my LG top load washing machine. it is currently not draining into the discharge drain during the rinse / spin cycle. It is draining onto the floor from the bottom of the machine. The drain and pipes have been cleaned and tightened. Once fault is identified, quote on repair.

Looking for an appropriately qualified/licensed appliance repairer or gas fitter to attend a short-term rental property in Windsor, Brisbane to diagnose and repair a gas cooktop ignition issue. Issue: - Gas is flowing to the burners normally - Burners are not electronically sparking/igniting - Guests can currently light the burners manually, but we need the ignition repaired - Make/model can be provided once confirmed We would like someone to attend as soon as possible this week, diagnose the fault and repair it where possible during the same attendance. Potential issue may relate to the ignition system, spark module, electrode or microswitch, however this will need to be professionally diagnosed. Please include in your offer: - Call-out/diagnostic fee - Your availability - Relevant licence/qualifications - Whether you can supply common replacement parts if required Please provide photos/details of the fault and completed repair for our property records.

We have a washing machine inlet that is leaking.

The rubber door seal (door boot/gasket) on my front loader washing machine has come off, along with the wire spring band that holds it in place. Nothing looks torn - it just needs to be put back on properly and the spring refitted. This video shows the kind of job: https://www.youtube.com/watch?v=l3KDqvOxemQ The rubber door seal (door boot/gasket) on my front loader washing machine has come off, along with the wire spring band that holds it in place. It should be repairable - it needs to be put back on properly and the spring refitted. This video shows the kind of job: https://www.youtube.com/watch?v=l3KDqvOxemQ If the seal or spring turns out to be damaged, let me know before buying any parts.f the seal or spring turns out to be damaged, let me know before buying any parts.

Looking for an electrician to install a new GPO below new laundry bench for washing machine. Current GPO to remain as shown in picture if possible.

Remove single draw Fisher & Paykel dishwasher and replace with another one

As it says on the headline. Can assist holding etc for IKEA tv stand. Needs to be this afternoon