Find a reliable appliance technician in Grange QLD

Install new rubber seal and remove old one

We have an automatic gate for our driveway as well as an automatic garage door. We have new remote controllers that need programming so that they can open both gate and garage door. We have 2 , remotes for front gate and 1 x garage door.

I have a washing machine that needs disconnecting and removing and swapped with another one in the house. Both require disconnecting old one to be dumped and other one installed in new area of the house

Need help assembling a home gym. It's an all in one gym with smith machine.

Dishwasher is erroring. F70 on a miele

Fix freezer compartment of Miele fridge which is not cooling.

I need someone to come and take apart my Dyson stick vac, clean it, and put it back together

Need a plumber to lower this pipe as close to floor wall corner as possible; install T pieces or similar for dishwasher inlet; connect dishwasher waste water pipe to U piece; connect all cables and pipes and slide in dishwasher. Clean job, plenty of working space. Only one elbow required on left side as pipe flexes down on the right. Hole already cut to pass thorough pipes. We have plenty of ongoing work.

Tap under sink for washing machine leaking after old hose and machine removed. Suspect a washer but don’t have right tools to remove. Copper pipe a little bent in attempt.

Our ceiling fans are not rotating quickly enough. They used to rotate more quickly. Hoping that a service could fix with the issue…? There are 5 fans.

Haier 450L Bottom Mount Fridge HRF450BW2. Door display no longer working, fridge and freezer seems a lot colder since it stopped working. This is where you adjust settings. It's been fixed once before. The wiring going through the door hinge was worn and thus stripped back and re-covered, which did the trick until now.

Need help today to lift 90kg heat pump from back of Ute on to trolley. Then help to lift it over very small brick wall into position. Should be about 10 min work. Must be able to lift 40-50kg.

The bulb is still working, but the lamp is down. It needs to be repaired.

My Baby Brezza advanced pro formula machine has error code 3 and it won’t work until it’s resolved. It was working perfectly well yesterday. I’ve tried to resolve it myself without any luck.

Installing a shower in a pool room with a lifting pump. Need to have it connected.

Swann camera installation - Due date: Flexible

Remove Miele dishwasher and take it away, install Westinghouse dishwasher - Due date: Needs to be done on Wednesday, 28 June 2023

Oven burner won’t stay lit; need to replace thermocouple for Eurolec E8973009NG Gas Oven. - Due date: Before Monday, 5 June 2023

I want to install a vacuum drawer under my oven but need to cut out room for this. - Due date: Flexible

my rangehood food doesn't work, too much grease in it, it probably needs a deep clean. I just wonder if you can get rid of the grease first then check the motor if it can still work. - Due date: Flexible