Find a Bosch appliance repair expert in VIC

Bosch Maxx WAE24463AU with f:21 Fault. have attempted factory reset option, and cleaned all pipes and filters, most probably needs new Carbon Brushes

bosch super silence 46db check water light and error E15 & E14, water not draining after cycle

Remove E15 error from Bosch dishwasher. I've already removed the water in the relevant area but just can't remove the relevant unit that sits above the switch. See photos

Water is on, Got E15 code overnight Cleaned filter Unplugged for a while Turned back on no code But now it seems when the water is starting it shortly stops again

The washing machine was working but not draining so a friend helped me take apart the machine to see if something was stuck in the pump. There was nothing there so I ordered a replacement pump and was wondering if you could help replace it and putting the machine back together. Front, back and top panels were removed.

My Bosch dishwasher is showing E09 at the end of the cycle. The water is not heating properly, dishes are coming out cold and wet, and the drying cycle is not working. I suspect a heating / circulation / heat pump issue and may need the faulty part diagnosed and replaced. Looking for someone experienced with Bosch dishwasher repairs to inspect it, confirm the cause, and complete the repair if possible. What I need: 1. Diagnose Bosch dishwasher E09 error. Check heating system / heat pump / circulation pump / heater assembly. 2. Repair or replace the faulty component if needed. 3. Test the dishwasher after repair to confirm it heats and dries properly.

Hi, I have a Bosch induction cooktop. I recently replaced the touch control board with a new one. The cooktop powers on normally and the display works, but the touch controls are not very responsive after reinstallation. I believe the control board is not positioned correctly under the glass and needs to be aligned or refitted properly. I’m looking for someone with experience repairing or servicing Bosch induction cooktops. The job may include: * Inspecting the control board installation * Correctly positioning and securing the control board * Checking the touch sensor alignment * Testing that all touch buttons respond properly The replacement control board is already installed, so no parts need to be supplied.

My washing machine has been stuck and is not draining the water. The water is flowing in and I can start the cycle but it won’t drain.

Lock sign is flashing and no cycle will start We have tried: Holding the start button Turning machine off for 5 mins and back on Changing cycles Removing washing from machine

Door is broken and has fallen off. Needs a new rim due to being cracked.

The dishwasher stop midcycle and show error E15. Turn off and on power didnt help.

Need the seal replaced on the Bosch washing machine. I have already bought the seal from Bosch. Please see the existing seal and a photo of the seal I have purchased. Thanks

Looking for someone can fix our Bosch dishwasher series 4 displays E19 haven't use it since move in

1.Replace the inner frame of Bosch serie 4 washing machine front door (as seen in the picture I have ordered the part already and its ready to be fixed) 2.Fix the door on the washing machine hinges properly 3. Test the washing machine and it should work as normal

Bosch built-in oven, model HBF113BR0A/01. The temperature control shaft behind the right-hand knob has snapped off and the display now shows ‘SAFE’. I’ve been advised I need the temperature selector switch/thermostat assembly replaced. Please give me a quote.

Bosch Dryer Repair & Service Needed – Camberwell VIC (ASAP) Looking for a qualified appliance repair technician to inspect and repair our Bosch home dryer. Model: Bosch WTE84101AU/30 Issue: * Container warning light is flashing. * Water container has been emptied and cleaned. * Interior accessible areas have been dried. * Dryer will start but shuts down after approximately one minute. * Based on a previous repair, we suspect moisture has built up internally and the machine may need to be opened, dried out, cleaned and serviced. What we need: * Diagnose fault * Open machine if required * Dry internal components if necessary * General service and maintenance check * Advise if any parts need replacing Location: Camberwell VIC (Riversdale Road) Access: * Townhouse * Easy access * Good parking available Looking for someone experienced with Bosch dryers and available ASAP. Please include your experience, availability and call-out fee when applying. I’d also suggest adding a clear budget range (e.g. “$100–$200 plus parts if required”) as Airtasker ads with a budget generally get better responses.

Bosch Maxx 8 condenser dryer (WTE86302AU). The dryer starts normally, the drum spins and runs for about 1 minute, then stops and the “Container” warning light comes on. I have already: * Cleaned the lint filter * Cleaned the condenser/heat exchanger * Cleaned internal ducts and lint build-up * Unplugged and reset the machine The machine has been partially disassembled and thoroughly cleaned, but the fault remains. Looking for someone experienced with Bosch dryers to diagnose and repair the issue.

Need someone to fault find Filter issue with Bosch dryer. It runs for 5 mins then filter light comes on. I have cleaned out the lint filters. See pictures

Bosch Maxx Classic 6.5kg front loader washing machine not spinning properly. Machine powers on, fills and drains normally. Drum/belt inspected and belt is still attached. Drum will spin briefly at the beginning of the cycle, then stops spinning (and trips the electricity). Drum feels somewhat stiff by hand. Possible issue may be worn motor brushes, motor/tacho fault, or drum bearings beginning to fail. Looking for someone experienced with Bosch front loader repairs to diagnose and advise whether repair is worthwhile or we need to replace.

Bosch error e:61 - 03 I've reset the dishwasher settings and this error keeps coming back.