Hire a professional washing machine repair service in NSW

Uninstalling old washing machine, taking down one flight of stairs, installing new washing machine.

The machine has developed a water leak from underneath, apparently toward the rear/right-hand side. What I have observed: No obvious leak while the machine is filling. Leak starts when the washing machine is emptying/draining the water. Water continues leaking/dripping for a short period after the machine appears to have finished draining. The pump filter has been checked and cleaned. Door seal/gasket has been checked and appears undamaged, with no debris. No water appears to be overflowing from the detergent drawer. The leak therefore appears likely to be associated with the drainage system, potentially the drain hose/internal hose connection, sump hose, drain pump or pump housing/seal. IMPORTANT: The washing machine currently has a Bosch dryer stacked on top, so please advise whether you are able to safely unstack/restack the dryer if this is required for access. Looking for someone experienced with Bosch front-load washing machines to diagnose the exact source of the leak and repair it.

Heisen Washing machine F03 issue. Cleaned the washing machine, it’s something with the drain pipe.

Need washer dryer door gasket changed have already brought new gasket

I’ve a hauler washing machine, it is showing E4 error constantly

Fix TE Error Code on my LG WASHING MACHINE Front Loader WXL-1014W

Install new LG smart washing machine - I tried to install following the manual (see pics) but on first run it won’t drain (giving the OE error message). Probably a simple fix, I just don’t know where to start!

Need two people to lift a Fisher & Paykel 8kg heat pump dryer up onto a Fisher & Paykel 8kg front loader washer in my laundry at Dee Why. Lift and place only — no installation, no bracket fitting, no hose connections. I’ll handle all of that myself. The dryer weighs around 55kg and is currently on the floor about 2m from the washer, same room, ground floor, no stairs. Should take 10–15 minutes. Two people must attend — this isn’t a solo job.

I need a licensed plumber to connect a washing machine to the existing kitchen plumbing. The washing machine is already in position next to/near the kitchen cabinets. It needs: * Connection to the existing cold water supply * Connection of the washing machine waste/drain to the existing kitchen waste pipe The kitchen sink and plumbing are already in place. Please supply any necessary fittings/adaptors required for the connection. Please include labour and materials in your offer.

Moving washing machine from Erskineville to Summer Hill and install. No stairs!

Looking for a handy Tasker to visit my apartment in Eastgardens to help stabilize my laundry setup. Job Details: Dryer Stand Repair: The plastic standoff spacers/legs that keep the dryer vertical against the wall frame have snapped off on both sides. Need these replaced, fixed, or an alternative spacer solution installed to hold the dryer upright safely. Washing Machine Leveling: The tiled floor underneath the washing machine is uneven, causing heavy rocking during spin cycles. I need you to assess the best fix whether that involves adjusting the machine's leveling feet, installing anti-vibration pads, or placing a solid rubber mat/board underneath to create a level, stable surface. Location: Eastgardens (Visitor parking can be pre-booked for your visit). Parts: Bunnings is under 10 minutes away if you need to grab specific spacers, hardware, or leveling materials Thanks!

Just need someone to connect my washing machine to the drainage, water is already connected. Thanks

Need the rubber door replaced. I have the replacement part. Just need someone to come and do it.

Quick washing machine connection – need someone now I’ve just moved into a new apartment and need help connecting my washing machine to a cold-water-only supply. The machine currently has hot and cold inlet hoses. I just need someone strong enough/with the right tool to undo the hot inlet hose from the back of the machine, remove it and fit the blank cap/sealing washer as shown in the attached instructions. It’s a super basic job — I’m just not strong enough to loosen the fitting myself! Should take around 10 minutes. Please only respond if you’re local and available to come now.

Need someone to connect my washing machine water inlet hose to the existing laundry tap. The existing tap/connector is heavily corroded and may need to be replaced. Please supply/install the appropriate washing machine tap or adaptor if required and ensure the connection is watertight. See attached photos. Licensed plumber preferred I’m not sure what the appropriate price is for this job, so please feel free to offer what you consider reasonable for the work required

Installation of brand new washing machine. Already in place in ground floor laundry but needs connecting and setting up

Help me: - disconnect one washing machine and move to the front porch - move new washing machine from store room and connect in laundry - move one sofa to front porch The old washing machine and sofa is free if you want to have it. Pickup location: Tempe NSW 2044, Australia Removals size: A few items Stairs: No

Washing machine leaking – check connection & relocate if needed My washing machine is currently connected in the kitchen, however it is leaking from the hose/pipe and I’m concerned it may not have been hooked up correctly. Looking for someone experienced with washing machine installation/plumbing to: * Check the current hose and water/drain connections * Fix the leak and ensure the machine is connected safely and correctly * Assess whether the current kitchen connection is suitable * If the kitchen setup isn’t appropriate, potentially move and reconnect the washing machine in the bathroom, where there is also a washing machine connection Please bring any basic fittings/clamps that may be required. Happy to cover the cost of additional parts if needed. Timing: Tonight / Tomorrow

Need a new seal installed on my LG washing machine

Kogan 10kg washer/dryer combo #KAGWAS10D6A Throwing error code E04. Something to do with water inlet or water sensor. Have checked filters and done a power cycle. Need fixed ASAP.