Find a local electric car service expert near you

when parked or driving it’ll run with no problem then it’ll just shut off.. i’ve ran the live data and everything is running fine and when it died i have to mess with the little piece sticking out the fuse back to start it again

Put together an electronic (battery operated) car for kids

2014 Mercedes Glk350 no crank no start battery is good starter is ok some electrical issues or ignition issues.

Electric recliner needs to be repaired. Apparently cables from the motor went lose.

I got My fuse box in my trunk replaced also the the wiring harness connectors and now my lights are dim windows won’t work and steering wheel buttons won’t work

i need the tire back where it supposed to be and it fixed

Took my car to a shop to install a Tesla screen which they messed up on install cut some wires now car not starting

2010 mustang GT has an intermittent shutoff issue. Suspected electrical failure but not exactly sure where

I installed a new alternator and I’m getting no power to the vehicle. When I tried to use a jumper pack it’s giving me sparks and drains the jumper pack. IM told I blew a fuse. I need to figure out which one so I can get my vehicle running asap.

Apparently this camera will need electrical installation. the camera I have for my qx56 is think ware dash cam

The power steering went out in my 2008 ford escape

After putting a cover on a car the keyfob doesnt work, interior lights dont work and trunk says open when closed.

Here are Steps - Total Time about 2.5 -3 hours 1 Remove Packaging & Check Contents:Carefully unbox the bike, remove all protective coverings, and confirm all parts, tools, charger, and manuals are included. 2 Battery Removal & Safety Prep: Unlock and open the battery compartment lid. Turn the main breaker to the OFF position and disconnect the main waterproof battery cable before removing the battery pack from the frame. This is for safety during assembly and is a good time to charge the battery. 3 Handlebar & Brake Setup: Loosely attach the brake levers and throttle assembly to the handlebars. Secure the handlebars to the direct-mount bar clamp, adjust the angle for comfort, and then tighten the bolts using a cross pattern. 4 Release Suspension: Straddle the bike and compress the front forks using your body weight to release any tension from shipping. 5 Install the Front Wheel: Loosen the fork pinch bolts and remove the axle. Apply a light layer of grease to the axle, install the wheel with the correct spacers, and align the brake rotor with the caliper pads. Slide the axle through and tighten everything securely, ensuring the axle pinch bolts are snug. 6 Mount the Front Fender & Brake Line Bracket: Attach the front fender using the provided bolts (Loctite is often recommended for these bolts). Secure the front brake hose properly using the brake line tab to prevent excess tension or snagging. 7 Foot Peg Installation: Align and install the foot pegs using a 17mm wrench. Ensure they are correctly oriented to fold backward in the event of a crash. 8 Install Display & Connect Wires: Mount the display by aligning the notches. Route the wiring cleanly along the handlebars and frame, using zip ties to manage cables safely. 9 Reinstall the Battery: Carefully slide the battery back into the frame, ensuring no cables are pinched. Reconnect both the main power and communication cables and close the lid.

Electric scooter put together from Santa

Driver door module not working due to wiring/fuse issue. Module works in other car. Car radio continuously plays no matter what until I open driver side rear passenger door. ABS is showing on display screen.

Occasionally and rarely, multiple lights will appear on the dash. That includes the check engine, VSA, and engine warning light ⚠️. The car continues to function normally, until you come to a stop, them the engine stalls and you have to restart. Lights turn off except for check engine, which usually clears after a day or two. The code always scans as P1009. VTECH solenoid stuck in "advanced" position. This part has been replaced, and has not fixed the issue. The most recent mechanic I've been to told me it's an electrical issue that can be fixed by someone with that area of expertise.

I own an electric moped (like a 50cc moped) and it needs a general service (tyres, brake fluid) plus it has a loose connection as sometimes the throttle does not connect. I would love someone to take a look at this for me.

I need to have my front tire replaced. It is a gotrax electric scooter. I already have a tire, I just need it replaced and filled with air, as I do not have the tools or knowledge on how to do it.

Electric scooter has flat tire in need of assistance?

My 2018 Camry wont start. There's electricity, but won't start. Maybe it's the starter. Need a mobile mechanic to repair it.