Find a local electric car service expert in Georgia

I have an hhr lt 2007 and i can buy the part that may need to be replaced. But it can not be driven because the wheel ks too stiff

no communication with ECM and TCM. ENGINE: P0010 it triggers check engine light Transmission codes: P0513,P15A1,B101E,U0073,U0100,U0101 AND U3000

I’m having an issue where I’m trying to get an emissions test, but the machines are not able to detect my ODB. I’ve already tried changing the fuse. My vehicle is a 2017 Mitsubishi Outlander

The backup camera, the driver side taillight, the passenger side headlight, the abs light and traction light goes off and on

Jaguar xe 2017. Gear selector will not eject. Unable to change gears.

Car loose power in certain areas

Pu0100 no read from ECM. After changing the ecm, pdc and bcm. Cannot do a force regen due to no communication with ecm. Willing to pay $200 for diagnostics with it going toward repair.

Kill switch and tracker were installed under the hood and is now drawing codes causing car not to pass inspection for emissions

I have a 2014 Lexus is350 I was previously in an accident and 1 headlight doesn’t work and 1 day time running light doesn’t work because of my wires being cut

It’s 2011 Hyundai sonata has an electrical problem

The wiring from the fuse to the hitch harness is broken in 2 places The harness is good but car wiring needs go be repaired fir nissan 2005 titan crew cab

The alternator brand new the battery brand new the starter brand new, but I’m still getting a clicking noise for the car not the turnover

My car dont always start on the 1st try at times, and other times it starts right up, i had the starter, alternator and battery tested shop say they are all good, they think its something electrical causing it to happen. I need to know what that is!

My AC, power windows, and power running boards keep going in and out. They will work for a couple minutes and then just stop working and then randomly turned back on

Replace the oil pressure sensor

Main engine wire harness is corroded

Here are Steps - Total Time about 2.5 -3 hours 1 Remove Packaging & Check Contents:Carefully unbox the bike, remove all protective coverings, and confirm all parts, tools, charger, and manuals are included. 2 Battery Removal & Safety Prep: Unlock and open the battery compartment lid. Turn the main breaker to the OFF position and disconnect the main waterproof battery cable before removing the battery pack from the frame. This is for safety during assembly and is a good time to charge the battery. 3 Handlebar & Brake Setup: Loosely attach the brake levers and throttle assembly to the handlebars. Secure the handlebars to the direct-mount bar clamp, adjust the angle for comfort, and then tighten the bolts using a cross pattern. 4 Release Suspension: Straddle the bike and compress the front forks using your body weight to release any tension from shipping. 5 Install the Front Wheel: Loosen the fork pinch bolts and remove the axle. Apply a light layer of grease to the axle, install the wheel with the correct spacers, and align the brake rotor with the caliper pads. Slide the axle through and tighten everything securely, ensuring the axle pinch bolts are snug. 6 Mount the Front Fender & Brake Line Bracket: Attach the front fender using the provided bolts (Loctite is often recommended for these bolts). Secure the front brake hose properly using the brake line tab to prevent excess tension or snagging. 7 Foot Peg Installation: Align and install the foot pegs using a 17mm wrench. Ensure they are correctly oriented to fold backward in the event of a crash. 8 Install Display & Connect Wires: Mount the display by aligning the notches. Route the wiring cleanly along the handlebars and frame, using zip ties to manage cables safely. 9 Reinstall the Battery: Carefully slide the battery back into the frame, ensuring no cables are pinched. Reconnect both the main power and communication cables and close the lid.

I want to uninstall the tires of my Lamborghini Aventador 24v electric car and install the new tires

Its Vitacci GTX 250 and starter button is cranking the bike but not starting

dash lights indicate air bag. antilock brakes snd turn signal light