Find a local electric car service expert in Los Angeles

My car isn’t getting spark to the engine, so it won’t start

I need new 12 inch pneumatic tire for scooter and have it put on

Electrical issues with the battery/alternator

it has the engine on I have the codes for ir

Car drives okay than everyone and than it shows electrical problems than don’t turn back on after turning off and needs jump start

Changed the alternator and got a new battery and still got that

One door driver side lock doesn’t open with alarm key

I need to reconnect a broken wire for car

Chevy P30 style box truck. been parked. needs a look at lights, electric - happy to discuss budget after I get an estimate of any needs.

The display panel comes on. Brake lights and blinkers and the headlight all work. Alarm works. But the motor doesn't run. I don’t know what it is. I just think it's a connection issue to the controller.

Cross wiring -it’s all messed up. The dome switch controls HVAC and Radio

I need electronic installs for headlights and tail lights on a 350 Z it’s all plug-in play

Flat tire in my front wheel of my electric scooter i need help changing it

The screws to align / tighten the chain have been overtightened and have been stripped. Need to loosen chain but we don’t have correct tools.

Hi, I recently had my 2006 Audi A4 inspected because the OBD system won’t communicate and scanners keep showing a link error. The shop diagnosed it as a K-line communication issue, likely wiring damage or a module pulling the signal down, but they weren’t able to fix it. I’m looking for someone experienced with Audi/electrical diagnostics who can trace and repair the issue. If this is something you think you can help with, please let me know. Thanks! Official diagnosis below: Findings: • OBD scanner shows “link error” (no communication) • Verified power and ground at OBD port • Tested Pin 7 (K-line communication wire): reading ~0.1V (should be ~10–12V) → Indicates communication line is being pulled low or shorted Actions performed: • Checked and isolated common causes of K-line interference: • Radio circuit • ABS system • Related fuses • No change after isolating these components Conclusion: There is a fault in the K-line communication circuit, likely due to wiring damage or a module pulling the signal down. This prevents communication with the vehicle’s control modules and blocks proper diagnostics. Recommendation: The K-line issue must be resolved first. This requires electrical/wiring diagnosis, which is a specialized process involving tracing the communication line through the vehicle. I recommend consulting a technician or shop that specializes in automotive electrical diagnostics and wiring repair. Once communication is restored, I can proceed with full diagnostics, identify the cause of the warning lights, and complete any necessary repairs.

My Audi a4 needs electrical work done so that it can run. I had another mechanic lol at it and he did some work so I just need it diagnosed and fixed so that I can be able to crank and start.

My car ran out of gas when I put gas in it had no power. I was pressing gas peddle and it wasn’t doing anything. While trying all the steps I found on YouTube my battery kept dying and went into anti theft mode. I need help

I already have the part just need it put on I'll even help.

I have a classic truck. I need new electrical system installed in it

Check engine light is on after replacing a valve body box infinity dealer also stated its an electrical problem