Find experienced local tradies near you

Painting render of top half of front of house. Quick and easy

The wardrobe is recessed into the wall, and I’d like the entire existing wardrobe structure removed, including the doors, hinges, internal rails/fittings, surrounding frame/panelling, and the overhead panel/boxing above it if this forms part of the wardrobe structure. I’m planning to replace it with a new floor-to-ceiling wardrobe in the same location. The existing wardrobe also has an overhead panel/boxing above it. I would ideally like this removed as well if it forms part of the existing fitted wardrobe structure. Could you please confirm whether this is included in the removal quote, and whether the area would be left ready for the new wardrobe to be installed?

We have a low brick wall about 50cm high in front of our plant that needs fixing. Specifically we have bought some new coping stones that need to be attached to the top of a 2.5m section of the wall. Then the whole wall needs to be rendered in a white render. Note that the current render is falling off and some of the bricks underneath are in poor condition so the existing render needs to be removed where it is not sound and a hardening agent applied to the bricks. Total length of low walls is around 10 metres. See the attached photo - the low wall is at the front of the facility and you can see the bare bricks that need to be rendered. You will need to provide the hardening agent, the white render and the tools to do the job.

My full sized 19 steel framed awning was damaged in heavy rain storm. Two poles have been bent, one centre upright poles short joining sections have been bent and rivet lost therefore side roof poles cannot be attached to centre pole. There is a tear on one front panel and the roof has stretched extensively due to rain pooling. My insurance campany has requested a contractors report on whether it can be repaired or awning needs replacing. Please can contractor either come to assess în poole dorset or assess by viewing photos of damage and provide a report for caravan guard.

I had a built in loft wardrobe made. Unfortunately the person I called messed up the job and has left the inside a mess. I need this fixed asap.

Some outside rendering or pointing to make the wall look better ground floor flat

To remove a Fiamma 45s 3500 from a Motorhome and put on a new one I have bought

I need to wire in a sauna in my garden. Instructions from the website are: A dedicated 32AMP electrical supply. Correct cable sizing. A suitably rated isolator switch OR 32AMP commando socket. Compliance with UK electrical regulations (BS 7671) The sauna is approximately 35-40m away from the circuit board. Circuit board is mounted to an external wall (picture attached). Uncertain of cost so please quote.

Below window lime rendering required.

The adjustment weld has failed on the recliner mechanism

Right hand side of the awning looking at it from outside will not inflate

Panels welding to car X 4 in total

The awning keeps deflating so i think the tube needs either repairing if a hole can be found or replace the tube.

CenturaHeat 3 Person Outdoor Steam Sauna SKU: HEAT-HS5004 (Pro -Line Direct) Two people required No mains connections required.

Build and assemble indoor sauna. No electrical certs required. 3hours job VAT invoice required. 2 man job (recommended)

4 PERSON COMBINATION SAUNA - NEEDS TO BE BUILT - BUILDING VIDEO PROVIDED WILL NEED TWO PEOPLE NOT ONE. SOONER THE BETTER IF POSSIBLE

Build our customers flatpacked sauna

Build a flat pack sauna for my customer.

Flat pack sauna to be built for my customer. Super easy. Barely a two hour job. https://prolinedirect.co.uk/product/single-infrared-light-indoor-sauna/

Build a flat pack sauna. this is for Liviu