Find professional underfloor heating installation in East London

Looking for an electrician to swap out two old Ambiente thermostats on a wet underfloor heating system. I’m supplying the replacements (Heatmiser NeoStat V3). Straightforward like-for-like swap with no rewiring needed.

Suddenly my hive app keep going offeline, unable to use this app to control my boiler via smart phones. I need to fix hive thermostat and connection issues.

I have two Danfoss TP7001M mains-powered programmable thermostats controlling heating on separate floors of my duplex flat. Both thermostats suddenly stopped working. When I switch the central heating circuit off and back on at the consumer unit, both displays operate normally for approximately two minutes before going completely blank again. The circuit breaker remains ON. The flat uses a Danfoss district heating HIU. Domestic hot water is currently working. I need an experienced electrician or heating-controls specialist to investigate the common electrical supply, wiring, fused connections and thermostat control circuits, identify the cause and repair it.

The radiator is not heating up in the bathroom

Replace central heating pipework Looking for a qualified plumber/heating engineer to replace all central-heating pipework in my 3-bed house using 15mm/22mm HEP₂O barrier pipe. Boiler downstairs by the front door. Approximately 7–8 radiators. I will supply and fit the radiators myself along with hep20 22mm and 15mm barrier pipe and fittings so the job is to Install the new 22mm flow/return mains and 15mm branches to each radiator, leaving connections ready for me. Upstairs, pipework only needs to go under the middle/dressing-room floor; elsewhere I want it run above floor level and accessible as itll be boxed in Any joins/tees should be positioned where a discreet access panel can be fitted, rather than buried permanently under floors/walls. Please quote for: Pipework installation only Optional price to connect the radiators, fill, bleed, balance and test the system. I have attached the floor plan

Element needs replacing in Bosch fan oven. It have the part just needs putting in.

I need a hetas registered engineer or such to connect a chimney and our pellet burner. Pellet burner in situ but needs connecting to chimney and fresh air feed.

To check all connections to the boiler/wiring centre and thermostats and commission our underfloor heating.

Hi. My baxi boiler needs fixing. The boiler doesn’t come on. No display and makes fan noise.

I have a 2014 Mitsubishi Outlander PHEV that is losing coolant. The radiator was replaced after a leak was found, but the coolant is still disappearing after each trip with no visible leak. The garage has pressure-tested it but cannot find the cause and doesn't have much experience with this PHEV. I’m looking for a specialist who can properly diagnose and fix the underlying issue rather than use trial and error, as I’ve already spent quite a lot without resolving it.

I have trouble installing my heating element in my electric stove.

THE MACHINE COMES BUT DOES GET HOT

Install 20 square metres of WUNDA 20mm Rapid Response underfloor heating system. Ground floor kitchen, small toilet and landing. Concrete floor, that has been levelled.

I need a plumber with experience working on gravity-fed tank systems and booster pumps. I have a loft-mounted shower pump that was installed last June. It worked perfectly until October, but now it drops to a trickle immediately after the first person has showered. The temperature remains stable, meaning the cold water storage tank in the loft is running dry due to a slow refill rate. I need a qualified plumber to carry out the following maintenance: Isolate the pump, disconnect the flexible hoses, and clean out the accumulated installation debris from the internal mesh filters. Inspect the ball valve inside the loft's cold water storage tank and clean or replace it with a high-flow equilibrium valve to handle the high water demand. Fully bleed the system to purge any winter airlocks from the pipe loop.

the displayed temperature jumps rapidly from 30°C to 44°C within seconds, followed by the HL error and the control panel locking up, it doesnt heat the water and the water is cold but still shows the temperature is 30

Repair dishwasher to heat adequately Must be reliable, experienced, and able to work safely in a nursery environment. Please confirm your availability, experience, and pricing. Please provide examples of similar work, where possible. The job may need to be completed outside nursery operating hours or at another mutually agreed time.

Our dishwasher is not heating up, it still runs but we know the water isn’t getting hot as we have opened it mid run. This also means that the dishes are not dry when the cycle is finished and the dishwasher is not washing anything oily well. We suspect a faulty heating unit. Price indicated is labour only (we will pay for any parts required)

Boiler is working but radiators are not working. Heating is not working

Central heating system not performing properly due to undersized pipework – uneven heating across the house. Looking for someone to: * Upgrade heating pipework to correct size * Supply & fit 8 new radiators * Balance and test full system Boiler is working – issue is with pipework and heat distribution. Please quote for labour + materials (or break down separately). Access to floor boards for upstairs and cellar to obtain access to ground floor pipes.