Hire a trusted hob installation and repair service in West London

We’ve already fit the hob in, just need an electrician to plug it/ the oven in. Induction hob needs some sort of seal as well it moves a bit

We need someone to replace old burner and install new five burner gas hob which is exactly 75 cm

Built-in hob, touch controls not responding. Shows error code 053. Need a quote to repair the touch panel/control board, or supply and fit a replacement hob if cheaper. Please include the diagnosis cost, repair cost with parts if possible, and earliest availability.

I need my 4 radiators flushed cleaned and new gas hob to be installed

Need a new gas hob installed after the old one has been disconnected by you. Gas Safety Certificate required at the end of it.

Old broken induction hob that is currently hardwired but partially removed needs to be replaced. Replacement model needs to be a Smeg S12641D. Price to include parts and labour.

I need a new gas hob fitted and removal of old one. I need it connected up and ready to use, sealed onto marble top.

Worktop fitted around built in hob and around 40 tiles fitted

We need the existing hob replaced following an EICR issue, as the circuit is currently tripping the fuse. We don’t know for certain whether the hob itself is causing the problem, but as it is quite old, we have decided to replace it. We need an electrician to install, connect and fully test the new hob, and also check the circuit to identify whether there are any other issues. The cooker may need to be partially pulled out to allow access to the cabling behind it. Photos of cooker and old hob with new hob: www.amazon.co.uk/dp/B0DVC7NPSD

Remove hob and replace with new Bosch electric induction hob

Cap off, disconnect and uninstall gas hob and install induction hob. Circuit for induction hob is already installed, so it just needs to be connected to it. There should be no need to alter worktop as hobs are same size Hob to install is Samsung NZ64H37070K

Remove all existing sealant around the kitchen sink and hob, clean and prepare the surfaces thoroughly, and reseal neatly with suitable clear kitchen-grade silicone. Also remove and replace the existing dark-grey flexible sealant/jointing material between the sections of wooden worktop. The replacement should be dark grey, ideally matching the current colour. Please identify and use a product suitable for wooden worktop joints—not ordinary silicone unless that is technically appropriate. Please confirm the worktop-joint product and colour with me before applying it. Black may be considered only if suitable dark grey cannot be sourced and must be approved beforehand. The finish needs to be clean, smooth and watertight. Please provide all tools and materials, completely remove the existing sealants, prepare the surfaces properly, and dispose of the waste. Please only offer if you have relevant kitchen/worktop sealing experience. Photos attached.

Hob not switching on suddenly, was all fine till afternoon and fridge making a lot of ice

I need new gas pipe pulled from adjacent boiler room and install new gas hob (replace old electric hob)

We are switching from a gas to induction hob and I need the existing gas capped off at the branch from the main inlet feed to the boiler. It is accessible. I need a gas certified engineer/plumber

Neff gas stove top. Four hobs have gas but no spark so need to use a lighter to get the flame.

Replace kitchen Gas Hob with New, do all checks, adjustments, fittings. 1. Need gas safe registered engineer with ID. 2. For warranty purposes need an invoice for fitting 3. and any gas safety checklist completed. Please share what checks you will do as part of the job. I will have new one ordered.

My buffalo induction hob is making a loud noise and this is coming from one of the fans. Can come to Amersham also

hob stopped working. Most likely fuse needs to be replaced.

Gas hob igniters are continuously trying to ignite. May be there is some moisture/grease or some fault.