Hire a trusted hob installation and repair service in London

My induction hob broke so I need to have a new one installed. It is an integrated induction hob

there is an old electrical hob in my flat, I already purchased a new one on Amazon, I need someone who can install it for me and dispose of the old one.

THe electric oven and ignition for gas hob is not working Sorry help no longer needed

I have a new hob and oven already delivered and need both installed. The oven just needs to be pugged in - but since the new oven is deeper than the old one, to make it fit I need the copper gas pipe behind it needs rerouting slightly and the electrical socket needs to be put in-wall / flush-mounted fitting. Must be Gas Safe registered. The new hob needs to be installed as well.

Remove all existing sealant around the kitchen sink and hob, clean and prepare the surfaces thoroughly, and reseal neatly with suitable clear kitchen-grade silicone. Also remove and replace the existing dark-grey flexible sealant/jointing material between the sections of wooden worktop. The replacement should be dark grey, ideally matching the current colour. Please identify and use a product suitable for wooden worktop joints—not ordinary silicone unless that is technically appropriate. Please confirm the worktop-joint product and colour with me before applying it. Black may be considered only if suitable dark grey cannot be sourced and must be approved beforehand. The finish needs to be clean, smooth and watertight. Please provide all tools and materials, completely remove the existing sealants, prepare the surfaces properly, and dispose of the waste. Please only offer if you have relevant kitchen/worktop sealing experience. Photos attached.

Kitchen fitting Carpentry

Hi, I need help with: 1. Self assemble the base hob cabinet with legs from a flat packed box 2. cut / adjust and Glue join a 60cm Wide worktop from a flat packed 1 Meter Worktop box. 3. Install & connect the oven below and the Ceramic hob on top please

New hob needs installing and old one taking out

recently had a gas hob fitted into my flat, but the connection was not done very well and there is a small leak. About 2-3 feet of the gas feed pipe needs to be replaced and then the gas connection to the actual hob refitted. I have a short video to show what needs to be done, and if you are interested in quoting for the job.

Ignition Switch needs to be replaced

60cm standard gas hob installation - remove old one, install new one - gas safe certified

I have an 20 year old AEG Hot Plate hob, which is pretty much awful and I am thinking of replacing it. However all the dimensions of new ones seem to be 1cm more. I just wondered if this is something that can be done? No rush just wondering before I order a new hob. Pics include existing dimensions vs new ones, and image of setup. The Hob has its own Power Switch/Circuit etc

I have a five burner gas hob fitted into the work top, 3 of the burners has stopped working, when you press the knob it sparks and lights on some of the burner but as soon as you let go the gas cuts off, is there anyone who can help with this, I need it sorted as soon as possible. Also the big burner has stopped working, not sure what the issue is.

Hob not switching on suddenly, was all fine till afternoon and fridge making a lot of ice

I’m looking for someone who can remove my old one and install my new electric built in over and hob

I need a new gas pipe connection installed in my kitchen. The boiler is already located in the kitchen, and I would like a new gas connection for a gas hob, which will be approximately 4–5 feet away from the boiler.

I need a new oven installed in a kitchen area. This is a plug-in oven so no hardwiring is needed. The old oven has been taken away so you will need to install the oven in the fitted area within a rental house. (pictures for reference on where the oven is located)

electric hob need replacing

hob stopped working. Most likely fuse needs to be replaced.

Hi, I need a kitchen a worktop replaced with new worktop, cut to size and cut to fit cooker hob. If you can install the hob also that would be great