Find a professional sauna installation service in East London

Our cube saunas are designed for straightforward DIY assembly. Most customers complete installation in a weekend with basic tools and a helping hand. The kit includes comprehensive step-by-step instructions, and all hardware is provided. You'll need a qualified electrician to install the dedicated 32A circuit for the heater, but the sauna structure itself requires no specialist skills—just patience and attention to the instructions.

I need a 1.5 x 3m wooden base build for an outdoor sauna please.

Need a outdoor sauna built Kit will be provided Concrete base already in place but sauna would have to be levelled on it. Electrics already installed Need an experienced contractor - please only Reply if you have installed a sauna previously

I am looking to put outdoor sauna in my garden. It needs a solid base so that it can last many years from now. The sauna is 1.5 m x 2m so the base will need to be a bit bigger (min 1.7 x2.2m).

Need a qualified electrician to connect a 4.5kW sauna heater (BC45, 230V single phase) to an existing dedicated sauna circuit. Most of the heavy lifting has already been done by a previous electrician - the circuit is already installed and live in the consumer unit (B32 MCB on its own breaker labelled “SAUNA”), cable has been run from the board to the sauna room, and a Contactum rotary isolator switch is already mounted on the wall. The issue is the previous electrician hardwired the infrared sauna panels but didn’t connect the main stone heater, which has its own separate cable with crimped terminals that needs wiring in. The heater is already in position and ready to go - it just needs connecting to the existing circuit, either into the isolator or junction box that’s already there. Photos attached show the existing isolator and cable run, the consumer unit with the dedicated sauna breaker, the heater’s cable/terminals, and the heater unit itself. Happy to discuss on-site but it should be a relatively quick job given everything is already in place.

Need a qualified electrician to hardwire a new Insignia MXOS1700 hybrid sauna inside my home. This is a hardwire-only unit - it has no plug and must be permanently wired to a dedicated circuit from the consumer unit. It's an outdoor-rated model being installed indoors so no external cable runs needed. Electrical Specs (from manufacturer manual): Harvia 4kW stove - 240V single phase 4 x far infrared heaters - 1,320W total (240V single phase) LED lighting, Bluetooth, control panel - 120W (240V single phase) Total load: 5,792W / 24.2 amps 240V single phase only - no three-phase or supply upgrade needed Requires dedicated 32A MCB and 6mm² T&E cable minimum (depending on run length) Scope of Work: Survey cable route from consumer unit to sauna location inside the property Install dedicated 32A MCB in consumer unit (spare way needed - can send photos of fuse board in advance) Run Twin & Earth cable from consumer unit to sauna Install local isolation switch near sauna Make final hardwire connection at sauna's electrical junction box Test, certify, and issue Electrical Installation Certificate (Part P compliant, BS 7671 18th Edition) I have the full Insignia installation manual and Harvia wiring diagram available on the day. Timing: Must arrive by 12pm Friday. Estimated job duration 1.5-3 hours. Note on cable run: The sauna is on the first floor, directly above the consumer unit on the ground floor. They share the same wall, so the cable run should be very short and straightforward - essentially straight up one level.

I have a wooden sauna to assemble it’s not a big 1 it’s a 1 person cabin sauna there are 2 people here to help assemble so you’ll have help

Our sauna won’t turn on. Electrical issue! Probably cable to the heater or fuse became wet. Needing electrician to fix this

Sauna door has some water damage (its also a shower) at the bottom of it, so it doesn't close/seal properly. - Due date: Flexible