Find a trusted local electrician in Surrey

Cooker hood is not working

Service my Bosch electric lawn mower, potentially replace the rotating blade.

Light replacement got a new one. 2 Bedroom power switches need replacement

85 year old lady needs an electric bed dismantled today

Add in plug sockets. One in the kitchen for a fridge, and some in the bedrooms depending on price. As well as one outside of the house in the front (weatherproof)

I need someone to remove our existing gas fireplace (photo 1) and fit an electric modern fireplace into the wall instead (see mock up). Then cover the wall in reeded panelling (I will provide this) and re-attach the TV. The wall is a brick wall.

Need to install a cooker hood by replacing the existing one

Got a Bosch NBS533BBOB Electric Double Oven delievered. Needs a dedicated switch on the MCB and then connected and installed. Refer to the attached images.

I need a qualified electrician today (Tuesday 29 September) to prepare the electrical supply for a new Daikin air-conditioning unit being installed tomorrow, Wednesday 30 September. The AC installer has specified the following: • Install a dedicated electrical supply from the fuse board • 16 amp circuit/fuse as specified by the AC installer • Supply to terminate at an outdoor rotary isolator • Rotary isolator must be positioned within 1 metre of the outdoor AC unit • Outdoor unit: Daikin Sensira 2.5 kW single system • Please supply the appropriate weatherproof rotary isolator and other required electrical materials, unless agreed otherwise • Work should be tested and completed to the appropriate UK electrical standards Location: TW20 8AB, Egham area When: TODAY – Tuesday 29 September The air-conditioning installation is booked for tomorrow, so this needs to be completed today. I have attached the AC company's reference photograph showing the type and location of the rotary isolator required. Please only offer if you are a qualified electrician, can attend today, and can complete the job safely. Please state your total labour price, whether materials are included, and approximately what time you can attend.

I need to replace my hob with a new one. They are both electric and the size is the same, but I think they have different wires which will need to be considered to change (I’m sorry that’s the extent of my knowledge!)

- 6 pieces down light installation in kitchen -4-5 pieces wall plug socket to be checked

I’m looking for a qualified/experienced electrician to replace my existing vintage light switches with smart WiFi switches. There are 3 x 1-gang switches and 1 x 3-gang switch to be replaced. The existing wiring appears not to have neutral wires at the switch locations, so the appropriate capacitors/bypass modules may need to be fitted where required. I already have all the smart switches, capacitors and a spacer available. I can provide photos of the existing switches and wiring before the job if helpful. Looking for someone experienced with smart switch installations who can safely install, test and configure the switches.

Broken switches to purchase and replace

Briggs and Stratton 14kw home standby generator needs servicing

I would like someone to replace the ceiling light in my living room with a new light fitting (see photo). Thanks

Need to change 3 sockets

Airing cupboard has a burnt sulphur smell and making an unusual noise. Investigate and fix

Assemble a kids bed, picture shown. Mount 1 electric blinds with the 2 brackets provided, pretty quick job Helping hand can be provide for the assembly

Replace six existing airbricks

I’m fitting out a small garden prep kitchen in Coulsdon and need an experienced plumber to complete the water and waste connections. Everything is located very close together, so pipe runs are short. Scope: * connect incoming cold water supply * install hot/cold feeds to 2 sinks * connect a Flomasta 10L undersink stored water heater * fit suitable isolation valves * install the supplied pressure-relief valve and discharge arrangement in accordance with the manufacturer’s instructions * connect sink wastes and traps * connect both sink wastes into the existing waste outlet * surface-mount pipework neatly to the wall * pressure-test and check all joints for leaks The electrical connection to the water heater will be carried out separately by an electrician. I’m happy for the plumber either to supply the small plumbing materials or tell me exactly what to purchase beforehand. Please only respond if you have experience installing small unvented/stored water heaters and pressure-relief discharge pipework. Please quote a fixed labour price and indicate estimated material cost separately