Find a trusted local electrician in Surrey

Repair 3 LED down lighters in the kitchen (old GU5 dimmable bulbs). Also repair single light fitting in bathroom cabinet (same type of bulb).

Need a light fitted, already wired up. Need a light changed. Need a switch changed. Need 3 sockets changed. Need a further socket changed and a base plate added. Need to diagnose why the hot water system may not be working

Cables and wiring, plugs etc around house need sorting

Rebooking task between Dave and Hamid

Looking for a professional and experienced electrician/handy man to install a 90cm wide cooker hood and chimney to wall above a stove. Cooker hood does not come with a plug, just wires it will need to be hard wired into plug socket by qualified electrician. Please see the picture for more info. All wall fixtures and fittings are included. Cooker hood will be used in recirculating mode as opposed to a vent. Carbon filters and have already been installed and cooker hood is ready to go. Someone with previous experience in mounting cooker hoods would be ideal!

I popped my rear tire on my off road electric scooter and need a hand changing the tire. I have spare inner tube and patch kit, but in need of someone with the correct tools and general knowledge to change it.

I need electric cooker disconnected as soon as possible

We need a failed ceiling downlight removed and replaced with a new downlight unit. The existing light is hardwired directly into the mains, and the replacement unit is a plug-in type, so the job involves: • Removing the existing hardwired downlight • Converting the current wiring to a suitable plug connection • Installing and connecting the new plug-in downlight • Ensuring everything is safe, secure, and working correctly

A. Survey the site with a Cap and Genny and/or other tools to identify existing cables and pipes. Refine quotation. B. Dig initial inspection holes to confirm survey data on existing cables and pipes. C. Dig a 17m trench 60 cms deep 20-30cms wide from where the pavement joins the driveway, across the left side of the drive (skirting a sewer inspection chamber) and then down the side of the house to the back gate. 1. Clear 2-3 inches of 10mm top gravel for the digging route and place to one side covered by plastic sheet. 2. Put down sheets or boards on which to store the diggings until backfilling. 3. Dig the trench: through a few inches of scalpings and then earth. Follow safe digging guidelines to safely avoid existing electrical cable, gas pipe and water pipe. 4. Instal a cable duct (provided by UK Power Networks) with a pull chord; cover the duct with pea gravel; instal a plastic warning strip provided by UKPN. 5. Refill the trench leaving access holes at both ends for cable installation by UKPN. 6. Replace the top gravel. 7. Remove excess diggings from site and leave it neat and tidy.

I need rails hung in a wardrobe there’s 6 rails in total. And I need a light hung in there too. I have the fitting it’s a glass pendant and needs to be fixed in

move one of the ceiling light to center and install the pendant light. The pendant light only have one connection. Please see below link for the light I’ve bought. I need to move the existing hanging ceiling light connection from end to center and replace it with below pendant light. Additionally, I want to install 2 more celing lights on existing port. Pendent light : https://www.wayfair.co.uk/lighting/pdp/longshore-tides-3-light-kitchen-island-dome-pendant-u100242426.html Other ceiling lights : https://www.diy.com/departments/pheashine-ceiling-lights-modern-round-ceiling-light-40w-warm-white-3000k-for-bedroom-dining-room-living-room-30cm-/5061104430099_BQ.prd https://www.diy.com/departments/norman-black-and-gold-monkey-pendant/5056367145125_BQ.prd

I need a qualified electrician to complete the electrical supply to my garden room at the back of my garden. A steel wire armoured (SWA) cable has already been installed, but it needs to be routed/extended to reach the garden room and then connected. The work required includes: - Running the existing SWA cable to the garden room at the back of the garden - Ensuring the cable is installed correctly for outdoor use (buried or clipped as appropriate) and compliant with electrical regulations - Connecting the supply to the garden room - Installing a small consumer unit or appropriate protection if required - Wiring the garden room for power and lighting - Installing sockets, switches, and lighting points as needed - Testing the installation and providing electrical certification to confirm compliance with current regulations. The work should be completed safely, neatly, and to a professional standard.

I need a qualified electrician to complete the electrical supply to my garden room at the back of my garden. A steel wire armoured (SWA) cable has already been installed, but it needs to be routed/extended to reach the garden room and then connected. The work required includes: - Running the existing SWA cable to the garden room at the back of the garden - Ensuring the cable is installed correctly for outdoor use (buried or clipped as appropriate) and compliant with electrical regulations - Connecting the supply to the garden room - Installing a small consumer unit or appropriate protection if required - Wiring the garden room for power and lighting - Installing sockets, switches, and lighting points as needed - Testing the installation and providing electrical certification to confirm compliance with current regulations. The work should be completed safely, neatly, and to a professional standard.

Need a like for like electric shower fitted

Towel Radiator wall socket needs replacement.

Need to why mains tripping

In my electric boiler, there is a leakage whixh seems coming from the immersion heater that needs to be fixed

Please supply and install 7 double sockets into the main bedroom and the nursery. Replace one single socket for double. The walls are concrete and the carpets have just been lifted. I would like this completed before 6pm today

Teddington not Hounslow - I have two windows- Velux GGL MK04 - that I would like to set up so that they open and close automatically/electronically not manually as very hard to reach. This has to be professionally managed with someone who has installed such Velux windows before and made them electronic. Furthermore, I would like see what the options are of making the blinds electronic too. Someone who works with Velux windows

Fit plug sockets & for a door bell. We already have the plug sockets and bell.