Find professional electric boiler installation & repairs near you

Primary task: I need to carry out annual boiler service on my Potterton system boiler. You must be Gas Safe Registered engineer and provide invoice. Additionally, three other things. (1) fix the leak from the bathroom towel rail radiator valve. (2) investigate and advice whether I should put a new central heating timer/programmer. It’s quite old (perhaps over 20 years). (3) investigate and fix motorised zone valve - probably motor needs replacement rather than the whole actuator. I can either buy needed parts or you can

Gas boiler service and help with the neo heatmiser app to sync to phone/ WiFi

Boiler needs a service by corgi registered engineer. EPH needs resetting - I’ve tried but it’s not kicking in CH and am not familiar with system. Also pressure gauge is at zero but hot water on boiler is working. I already had a gas safety done in early summer so not clear why CH not working. We aren’t familiar with this system. Please quote for service trouble shooting. Thanks.

No hot water and pressure is down.

As above - nest thermostat connected to combi boiler. I have the thermostat

I need a boiler flue boxed in, with three inspection hatches on the bottom. It’s across the top of the bedroom.

Gas went off as there was no credit when it was credited no gas is coming to appliances

Intermittent Hot Water: The boiler randomly stops delivering hot water. This has been happening off and on for the last few weeks.alsoThe boiler pressure occasionally drops and needs topping up. Its a ideal boiler, logic

We have no hot water. It appears the thermostat needs replacing

The sensor light in my boiler cupboard isnt working properly and keeps going on and off at random times. I need that repaired please.

THE WATER FEED TO THE BOILER LEAKS ONCE YOU PUT THE HEATING ON. THE WATER PIPE HAS BEEN DISSOLVED BY THE CONCRETE OF THE KITCHEN FLOOR.

We use a BeSMART controller that is connected with the boiler, but when clicking the heating mode the flame doesn't turn on. Hot water is working fine in all taps.

I wish to start using my heating and need to be able to increase or decrease temp from thermostat dial on the wall. It worked perfectly over winter but I think I have pressed the wrong button recently when I tried to switch it back on

Hello, I need a boiler service certificate for a boiler in my restaurant. I believe the boiler itself is a domestic-type boiler, although it is installed in a commercial property. I have attached a photo of the boiler so you can check. The boiler is working perfectly fine. My main reason for arranging this is that my landlord has asked me to provide a valid boiler service certificate. I would therefore need the inspection/service to be carried out by someone who is properly qualified and authorised to issue a valid certificate. I would prefer not to have unnecessary work carried out on the boiler since it is working fine, but if servicing is required in order to issue the certificate, that is absolutely fine. Could you please let me know if you can do this and how much you would charge? Thank you.

I have checked and is in working order, all the status lights are green which indicate the hive is connected and working and the same for the boiler as we have hot water. However the thermostat still does not send signal to heat up

Gas Safe Engineer needed for: Vaillant boiler, F.75 fault. Pressure is 1.7 bar, gas supply is working, reset has been attempted, and there's no hot water Free parking. Please say when you are available with your quote

Have recently had boiler installed and contractor had to cut out a small hole in ceiling for new flue. Need someone to re plaster the ceiling - also open to offers for those who can re plaster and paint in the same day

Boiler Service and Smart Thermostat Replacement I’m looking for a qualified heating engineer to: * Carry out a full boiler service. * Remove the existing old heating controller. * Diagnose why the heating/boiler seems to switch on unpredictably. * Install and configure a new smart thermostat Drayton Wiser Wireless Heating The new thermostat has already been purchased. Please include any required testing and confirm the system is working correctly after installation.

I need a plumber to re-pressurize my boiler and to tighten the bathroom heater as it’s leaking at 8 AM on the 9th July 2026 please. I have guest staying in my flat and the only time they can do is 8 AM tomorrow morning.

You must be a plumber or a heating engineer. Boiler diagnosis completed as follows below and need someone to replace both parts. Parts to be ordered separately and not included in price here. - system pressure was low. I topped up the pressure and reset the boiler; however, the boiler still failed to fire. The appliance was displaying the fault code shown in the photographs provided. I referred to the manufacturer's instructions, which identify this fault as relating to the gas valve. I then contacted the manufacturer directly to confirm, and they advised that the fault is associated with the gas valve and ignition electrodes, with replacement of these components being the recommended course of action. The active fault codes displayed on the front of the boiler provide a clear indication of the fault condition being detected by the appliance, and the manufacturer has confirmed that these codes relate to the gas valve and ignition electrodes.