Find a professional local car service in Central London

Bought front brake pads for my honda jazz 2013 plate. Need mechanic to replace just labour cost please good price. Happy to negotiate a little more on price if you accept my offer then at least we can discuss but let me know your price and if your mobile mechanic

I have the speakers already - and the adaptor ring - this is a simple labour only job. Remove old speakers and replace with new ones. should be about an hour or 1.5 hours tops.

My 2012 Fiat 500 (TwinAir 875cc) is blowing hot air from the vents when the AC is turned on. It was recently regassed. I have checked the 7.5A compressor fuse under the bonnet and it is fully intact. When turning the AC on/off inside the cabin, I can hear a clear mechanical click/engagement from the compressor clutch. I am not a mechanic, so I need a professional to verify this, but based on the compressor engaging and the fuse being good, I suspect the heater blend door actuator/flap might be the issue. However, I would appreciate a proper diagnostic check to confirm if this is the actual issue or if it's something else. ​Looking for a qualified mobile mechanic to inspect, diagnose, and hopefully free up the mechanism or advise on next steps. Car is parked on my street and ready to be looked at today/tomorrow.

Hi, I already have a reversing camera and monitor for my 2017 Ford Transit L3H3. I only need fitting and wiring. Can you give me your best price please?

Clutch needs replacing I can order part just labour needs to done

I have a new battery I just need it changed

Mazda system needs to be updated and install new usb hub

Looking special rocker arm oil feed bolt 2006 Honda jazz

Need rear centre-right parking sensor replaced on BMW 2 series gran coupe 2021 I have the sensor just need it swapping over it’s just one sensor to be changed

the seat of the bike won’t pop open so i can fill up the tank

Car was in limp mode Rac said pinnacle neads Repair .

Description: Hi! I have a 2018 BMW 530e (G30) and the driver seat cushion has worn down, causing back pain. I’m looking for someone experienced to: • Replace or rebuild the foam in the seat base • Possibly fix side bolsters if needed • Keep the existing cover (no full retrim unless necessary) I’d like this done locally in East Finchley, London. Please include: • Estimated cost • Whether you can do it at your workshop or come to my location Budget: £80

Install Apple car play head unit into Peugeot 108 with original reverse camera

Old unit blew the fuse and gone unresponsive. Ordered used replacement media nav head unit that needs swapping and fuse checked.

Install car screen, reverse camera and parking sensors – Honda CR-V 2004 I’m looking for an experienced installer to supply and/or install: - 7” CarPlay / Android Auto screen (portable or head unit – open to advice) - Reverse camera - Rear parking sensors Car: Honda CR-V 2004 Location: NW10 (London) I have not purchased the parts yet, so happy for you to: - supply everything, or - advise what to buy and install Please include: - whether you can supply parts - total price (parts + labour or labour only) - experience with similar installs Looking for a clean, reliable installation. Thanks

Put new battery on and put 4 Splash Guards

Hi I need a straight replacement of my intake hose pipe for my 2017 Nissan Qashqai 1.5dci Acenta. This shouldnt take too long I attach the part in pics.

I have a fiat 500 and one of the door handles needs fixing. I already have the spare handle for it, it just needs attaching onto the car door. Panel inside already removed!

Hi, I need petrol safely removed from my Vauxhall Corsa. It’s not possible from the outside due to anti-siphon/security, so it would need to be done via the bonnet/fuel system. Please let me know if you can help, your availability, and the cost. Thank you.

I have a 2016 BMW 2 Series (F23) convertible. The windscreen washer sprays only a very weak dribble while the headlight washers work fine. I disconnected the hose to the windscreen washers near the bonnet and blew some air into it using a compressor - this temporarily cleared the line and gives strong flow for a few seconds before it then blocks up again. I believe the strainer/intake on the washer pump or debris in the tank is causing the issue. I’d like someone to come to my home and: ✅ Access the washer tank via the front left wheel arch ✅ Inspect and clean the pump strainer/intake ✅ Flush any debris from the washer reservoir ✅ Re-test to make sure windscreen sprays strongly consistently ✅ Advise if any parts are needed (pump or strainer) Please bring suitable tools (jack, stands, trim tools, etc).