Find professional underfloor heating installation in East London

Hi. My baxi boiler needs fixing. The boiler doesn’t come on. No display and makes fan noise.

To check all connections to the boiler/wiring centre and thermostats and commission our underfloor heating.

I have a 2014 Mitsubishi Outlander PHEV that is losing coolant. The radiator was replaced after a leak was found, but the coolant is still disappearing after each trip with no visible leak. The garage has pressure-tested it but cannot find the cause and doesn't have much experience with this PHEV. I’m looking for a specialist who can properly diagnose and fix the underlying issue rather than use trial and error, as I’ve already spent quite a lot without resolving it.

I have trouble installing my heating element in my electric stove.

THE MACHINE COMES BUT DOES GET HOT

Install 20 square metres of WUNDA 20mm Rapid Response underfloor heating system. Ground floor kitchen, small toilet and landing. Concrete floor, that has been levelled.

I need a plumber with experience working on gravity-fed tank systems and booster pumps. I have a loft-mounted shower pump that was installed last June. It worked perfectly until October, but now it drops to a trickle immediately after the first person has showered. The temperature remains stable, meaning the cold water storage tank in the loft is running dry due to a slow refill rate. I need a qualified plumber to carry out the following maintenance: Isolate the pump, disconnect the flexible hoses, and clean out the accumulated installation debris from the internal mesh filters. Inspect the ball valve inside the loft's cold water storage tank and clean or replace it with a high-flow equilibrium valve to handle the high water demand. Fully bleed the system to purge any winter airlocks from the pipe loop.

the displayed temperature jumps rapidly from 30°C to 44°C within seconds, followed by the HL error and the control panel locking up, it doesnt heat the water and the water is cold but still shows the temperature is 30

Repair dishwasher to heat adequately Must be reliable, experienced, and able to work safely in a nursery environment. Please confirm your availability, experience, and pricing. Please provide examples of similar work, where possible. The job may need to be completed outside nursery operating hours or at another mutually agreed time.

Our dishwasher is not heating up, it still runs but we know the water isn’t getting hot as we have opened it mid run. This also means that the dishes are not dry when the cycle is finished and the dishwasher is not washing anything oily well. We suspect a faulty heating unit. Price indicated is labour only (we will pay for any parts required)

Boiler is working but radiators are not working. Heating is not working

Central heating system not performing properly due to undersized pipework – uneven heating across the house. Looking for someone to: * Upgrade heating pipework to correct size * Supply & fit 8 new radiators * Balance and test full system Boiler is working – issue is with pipework and heat distribution. Please quote for labour + materials (or break down separately). Access to floor boards for upstairs and cellar to obtain access to ground floor pipes.

I need a cable installed for my underfloor heating mat in my shower room. Picture 1: shows the plug socket in the adjacent room, which I’m hoping you can run the cable from. Picture 2: shows the direction of the joists under the floor to help plan the route. Picture 3: shows the height where I need the cable brought up to feed through the wall so the thermostat can be installed on the other side. There is lots of room under the floor to pull the cable through

Connect electrics. Theomostat and a Install a stat Must be qualified electrician

Electric oven (Bosch) turns on but does not warm up.

So these came with a plug but it’s too short so I’m looking for a handy electrician to either hardwire this or replace the lead with longer lead to reach a plug. I have two of these btw.

Heating engineer / plumber needed – radiators not heating (HIU system) Description: Looking for a qualified heating engineer or plumber experienced with HIU / communal heating systems. Issue: - I replaced one radiator in the flat. - After bleeding the radiator and adjusting valves, the new radiator does not heat properly. - It briefly heated from the bottom when other radiators were closed, but then stopped again. - Now most radiators in the flat are not heating, even with TRVs open. - Hot water still works normally. System details: - Flat has a HIU (heat interface unit) / communal heating system, not a standard boiler. - Radiators were working before the radiator replacement. What I think may be needed: - Check heating circuit on HIU - Check radiator valves (TRV / lockshield) - Bleed radiators and remove possible airlock - Rebalance heating system Location: E14 London Ideally looking for someone who has experience with HIU or communal heating systems. Please quote total price

Radiator thermostats and fix internal thermostat to water pump

Urgent must be today. We have a detached guest studio with separate heating/water We had a radiator removed and now water isn’t heating it’s probably as simple as a switch in our cellar or something but we aren’t familiar with the way it works

One radiator is warm at the top and not bottom and the others aren't heating fully, I've tried bleeding but it isn't changing anything Dishwasher runs but doesn't heat