Find a professional verandah installer in SA

Bottom section of the veranda post has rotted due to a leaking gutter. I think that the bottom section needs to be cut off and replaced.

Simple job: drill through my timber verandah beam (30 mm thick) and fit approximately 10 x M10 x 75 mm stainless eye bolts with washers and Nyloc nuts. I supply all the hardware and a one-page sheet with marked photos showing exactly where each bolt goes - one near each post, one mid-bay, all on a level line. You bring a drill, a sharp 10.5 mm bit, a spanner and a step ladder. Single-storey, flat paving, max height approx. 2.4 m.

Verandah painted. The posts and roof posts painted. Currently has no roof. All paint and paint brushes will be supplied.

Hi, I need a licensed/experienced pergola/verandah installer to quote and complete a pergola at my new build home in Salisbury North SA 5108. Scope: build pergola generally as per my approved plan, approx 3000mm x 4500mm / 13.5m², at the rear/side outdoor area near living/meals. Handover is expected around 16 July, so work will be after keys are received. Preferred roof: opal/translucent polycarbonate sheeting, semi-transparent, to allow natural light but provide rain/weather protection. I do not want solid Colorbond unless required for approval/engineering/compliance. Approved plans can be shared. Please check if the existing approval covers this pergola and whether changing roof material to opal polycarbonate needs any approval amendment, engineering or certification. Please provide an itemised quote including labour, materials, roof sheets, posts/beams, footings, flashing, gutters/downpipes/stormwater if required, any approval/engineering/certification costs, GST if applicable, warranty, public liability insurance, and invoice/receipt with ABN. Budget is a starting estimate only. Final price can be confirmed after plan/site check.

I have a verandah that is exposed to the weather, and the main long beam is rotting and needs replacement. Looking for a rough idea of replacement. Please send through rough quotes. The beam is 330x80 timber.

Replacment of some sheeting and c channel

4 verandah panels have cracked and are leaking when raining. Need replacing. Person needs to buy panels and replace.

I’m seeking an experienced tiler to tile my front verandah at my home in Edwardstown. Approx 15 sqm. Job to include: - Supply and instal a single piece of 1500mm long x 300mm wide x 30mm thick bulnosed slate edging - Mechanicaly etch the existing concrete to remove al the paint from the existing substrate - Screed the floor area to create fals and required finished floor levels - Instal expandable mesh throughout the screed to absorb any possible movement from the existing concrete - Tile the verandah with an 'Octagons and dots' pattern and a 'pencil' border - Grout and silicone as necessary - Supply of al consumables

Verandah installer with builders licence to supply and install a verandah. Including polycarbonate skylight sheets to enclose to fence line. Bolted to concrete. Have council approval and engineering. A site measure will be required prior. As measurements are an approximate only. Will be slightly smaller than measurements on plan.

1. SHED 9X6X3 1 Slide 1XPA 2. Heritage Gable Verandah 3. Front Porch Attached . C section

One of the verandah support posts at the rear of the house requires repair or possibly replacement. The base section of the post has deteriorated and needs replacement or reinforcement.

Hello I Am After Roughly How Much It Going To Cost For 5M L By 6.5 M W Verandahs. I Need Materials , Labor & Council Approval In This Cost . I Would Like The Verandahs Connect Between 2 Sheds & Will Require Gutters And A Downpipe Connected To Stormwater Which Is Right Next To The Verandahs.

I have just pulled down a timber pergola however, need 6 timber posts that are cemented into the ground removed.

Please quote for wood rot in post and beam of verandah, also bottom of a garage door. I will have a painter finish the job. Budget flexible as I’m insure of the scope of work. Thank you!

4 of the plastic, corrugated roof sheets of my back verandah have holes and I'd like them replaced.

I require supports for a wisteria vine to grow on around my verandah area.

Want to extend an existing verandah

Looking for experienced tiler to tile 7sqm verandah. Area has been prepped and is ready to go. Tiles purchased from reputable supplier and are 200x200. Everything will be supplied - tiles, grout, adhesive and spaces.

One of my back verandah posts has rusted through at the base and needs replacing. The other posts are fine — this is just for one post. Looking for someone experienced with verandahs or structural work to: • Brace the verandah safely • Remove the damaged steel post • Supply and install a new galvanised steel post (plain finish is fine — vines will grow over it) • Mount it on a base plate, not directly into the concrete • Make sure it’s level and secure Easy ground-level access. Please include both labour and materials in your quote.

I have four blinds I’d like attached to my back verandah. May or may not be straight forward as metal edge of pergola is thin metal and hollow behind it not solid metal. Not sure if strong enough to hold blinds. Maybe some timber behind it might give it extra support to drill into(?) Please come and have a look first if you like before submitting offer.