Find experienced local tradies in Logan Beaudesert

Wall section to reinstate is 3.5m long x 1.3m high. The plasterboard was removed from a brick/masonry wall. The wall-to-slab joint at the base has been pressure-injected with waterproofing membrane. The brick face has been coated with membrane paint. The area is now dry and stable. Scope required: Reinstate the wall to the original finished line. Do not bring the wall forward or box it out. The original plasterboard sat about 25mm off the brick. Install a low-profile fixing support (thin battens or furring channels) fixed to the masonry where appropriate. No drilling or fixings through the injected waterproofed base joint at the slab. Keep the bottom edge of the new sheet 10 to 15mm above the slab so it does not touch the floor. If any mechanical fixings must go through the membrane-painted brick, each fixing point must be sealed so the waterproofing remains continuous. This means sealant in the drilled hole before the fixing goes in, seal around the head, then touch up with membrane paint. Supply and install moisture resistant plasterboard. If you recommend fibre cement instead, please explain why. Tape and set joints, then sand to a paint-ready finish. Clean up and remove all rubbish. Quoting: Please include materials and labour. Please confirm your proposed fixing method. I do not want an adhesive-only dot-and-dab plasterboard install directly onto the membrane-painted brick.

Install rooftop tent tub rack and awning

Minor Wooden Awning Repair – Cracked Timber I accidentally reversed into my carport and caused minor damage to the wooden awning. There is cracked timber, but no major structural damage. Details: Wooden awning/carport Timber is cracked from impact (see attached photo) No collapse or major structural issues Looking to have the timber repaired or replaced as needed and made secure Requirements: Handyman or carpenter with experience in timber repairs Own tools Able to assess whether timber can be repaired or needs replacing Finish should be safe and structurally sound Please quote based on the photos attached, or advise if a quick inspection is required.

I have two sharp air conditioner. Both are working but not cooling the space. The wind is not cold enough. I believe their gas should be refilled/changed. I need someone to fix them

Electrician needed for a few tasks: - re-attach a power point that has come loose from the wall - fix a light switch (one of the 4 switches is stuck) - replace a batten ceiling lamp (easy access) - install a new ceiling lamp (old broken socket, easy access) OPTIONAL additional tasks (additional budget negotiable): - install a new outdoor lamp (long ladder needed) - install a new power point + chandelier lamp on a high indoor ceiling (at 3.50m height, tall platform ladder required)

There is a hole on the wall

Finishing plastering and install small bits of cornice

Two spots on garage wall where paint and outer layer of drywall were peeled off when removing something stuck by double sided tape. A patch up with a flat matte white paint required before Friday 19/12/25

Need to rebuild balustrade at my parents place, 4127

Hole in wall needing plastering and painting. Paint already provided.

Looking for electrician to install new power points in the living room. Wall already has power point inside master room. Hopefully easy access. Might be just 1 new powerpoint or another too. Can be discussed on the day depending on price.

NEED KINGS AWNING PUT ON PRADO TOFAY PLEASE!! Willing to pay decent $$ as desperate. It’s way too heavy for me to help my partner put on.

NEED SOMEONE OR 2 PEOPLE TO ATTACH KINGS 270 AWNING TO PRADO

Need rendering all round house 5 to 6inch

I need 3 Instahut awnings assembled and installed

I need a broken stove switch replaced and a new power point to be added in a bedroom. Must be a qualified sparky

I have around 20m2 of ceiling that needs to be replaced, around 10 (10m2) if water stains that need to be pre painted and around 200m2 of ceiling to be painted. Im looking for someone to supply all materials, install and paint.

$50 per hour, needed for 2 hours min. Help to carry and support sauna panels as we take apart existing sauna and assemble new one. Not super heavy but awkward to do solo.

Needing the ceiling hole to be covered + Plaster and old downlight holes to be covered along with a few smaller holes and electrical work to be covered.

We need some ongoing plastering work done at our home.