Find experienced local tradies in Logan Beaudesert

Lounge room - New installation, remove old light Dining room - New / Replace Entrance way - Replace Hallway - Replace Toilet - Replace

Hand aquacheck plasterboard and plaster, sand bathroom. Plasterboard, plasterboard screws and wet area gyprock compound supplied. Need completed on mon, wed or fri when i work from home.

Approximately 4 meters long and there are 2 of them. They are bolted on.

Plastering on side of the basement, gazebo installation, tv mount on wall or might be glass door fix. Thanks

Small bathroom approx 2.5 x 2.5 ceiling to be painted with a mould resistant paint. Soffits under the front verandah need a repaint. Inclusive of the half carport. Total area approx 2.5m x 18m plus carport 3m x 3m

Solid Plastering and painting.

Here's a ready-to-post Airtasker listing: Title: Remove & dispose of ceiling insulation + gyprock debris — 6x6m room Budget: $300 Location: [Your suburb] To be done: This weekend (Sat/Sun) Description: The ceiling in a 6x6m (approx 36m²) room has been pulled down and I need all the debris removed and taken away. This includes loose ceiling insulation (currently spread across the whole floor) and gyprock/plasterboard sheeting. What's involved: Bag up and clear all loose insulation from the floor (it's piled fairly thick throughout the room) Remove and stack all gyprock/plasterboard debris Load everything and take it away for disposal Please note: Tasker to arrange own truck/trailer and cover all tip/disposal fees — please include these in your quote. Ground-floor access, room is easy to walk into. Framing, wiring and brick walls stay — it's just the debris on the floor to clear (see photo). The room will need a general sweep-out once the bulk is gone. Please bring your own tools, bags, PPE (dust masks/gloves recommended — old insulation can be dusty) and anything needed to load out safely. Let me know your availability for this weekend when you quote.

Looking for an experienced carpenter, deck builder or balustrade installer to install a 316 stainless steel wire balustrade system on my front deck in Eagleby, QLD. Materials supplied by me (Chaindirect - Balustrade Basic Kit (No.6) – Turnbuckles (33), Wire (150m), Fittings, Tools Kit): 316 stainless steel wire balustrade DIY kit 3.2 mm 1×19 marine grade 316 stainless wire Turnbuckles, end terminals, saddles and all fittings Hydraulic swaging tool and cable cutters Work required: Remove and dispose of the existing timber balustrade infill only (existing timber posts and top rails to remain). Install stainless steel wire terminals and cables. Tension all wires evenly. Ensure the installation is straight, secure and professionally finished. Clean up and remove all waste upon completion. Project details: Approximately 7 railing sections 8 horizontal wires per section (56 wire runs total) Total railing length approximately 12 metres Existing timber posts and handrails remain Stainless steel wire system only (no glass) Requirements: Experience installing stainless steel wire balustrades. Own tools (other than the supplied swaging tool and cable cutters). Please provide photos of previous similar work. Installation must comply with Australian residential balustrade requirements. Please include with your quote: Your experience with similar installations. Estimated time to complete. Total labour cost. Any questions after reviewing the attached photos. Location: Eagleby QLD 4207. Must visit in person to confirm the full job and understand work. Budget: Looking for quotes.

Current plasterer called in, needing someone to quickly to finish the job All materials are supplied and the gap needs to be covered with plyboard then painted

Need a plasterer tomorrow for one room, materials provided but you need your own tools. I need a quote for day rate, 10am to 8pm

a shed flat roof/size 4.9m/ front 4m /rear 3 roller doors/side access as well.quotes approximately $6000 .council pre-approved .concrete slab is down 120sqm .we have council approval already .shed already on site roof installation is already on site.

I need the existing power point moved slightly to the left, and a new one put in about a metre below it.

A chunk of plaster/render in wall that has a moisture crack needs to be filled. Someone that is good with Home renos and quick fixes.

I have purchased 2 awnings that require basic installation side-by-side. The dimensions are: 28.5 x 240 x 100cm. I have attached an example photo of what it will look like once installed. I would be happy to share any further details required!

Seeking a plasterer to sheet an ensuite. All sheets, screws, top & base coat, tape, corners already sourced and onsite ready to go - previous trade ghosted us. Includes 1 x 3000mmx800mm framed wall, 2 x 2400mmx950mm wall (front and back side) and a little overhead section connecting these two walls together that’s framed, and 1 x 2100mmx1000mm wall (front and back). All areas have been framed, plumbing and electrical done to be accounted for when sheeting.

I need three curtains rails installed in bedrooms, The bedrooms are gyprock on brick/masonry. They should have proper anchors and a level finish. Happy to post pictures if needed.

New passage door installed needs plastering completed so painting can be done.

Need someone to set and cornice 250sqm worth of Gyprock. Cornice supplied. Happy to negotiate price. Send me your offers.

Supply and install 3 x wire balustrades.

Need to fix the broken part of the wall it was hit by the car while parking. It should look similar to the rest of the wall after repair.