Find experienced local tradies in ACT

Small room. Install small panel of dry wall and plaster wall, including arched door way.

Install missing gyprock and plaster.

I need someone to patch and sand a few areas inside an old shop tenancy. See photos Must have own tools and supply materials. Must clean up after work. Will need a ladder to reach 3.6m high.

Need experienced plasterer to plaster the skylight shaft all the way up to the top. See photos

Need a licensed electrician to replace a double power point with switch for hot plate in the kitchen, as the existing one has failed (switch mech no longer operational). Replacement already purchased and ready to install

Cut out damaged ceiling plasterboard and replace with new plasterboard. Paint to match existing ceiling colour as close as possible.

I need someone to render the front of the house. The front bricks only.

I’m looking for someone that can start with sanding the deck and it goes well there is a range of other similar unskilled tasks. Please tell me your general availability. The work is not every day. Ideally you would start this Wednesday morning but I could wait until Thursday morning. Please tell me the hourly rate you expect. I have to give a budget on this and I’ll put one in but that could be a lot more work depending on how you work. I’m looking for someone who’s not particularly skilled or experienced but is willing to give it a go at a good price per hour. I already have several good Tradies.

This window shelf is rusting and needs replacing. Shelf is 1.82m long. I will need it rendered and whole wall painted to match house.

I have damaged hole in gyprock wall and need to fix and paint same

Our current bathroom was renovated 10 years ago. The tiles are large ones. We need to get it demolished and rendered in preparation for tiling.

7 aluminium window frames need to be sprayed and painted dark grey. Only looking for experienced painters or tradespersons to complete the job

Concreting and area at the back of the house, approx 7m x 1m and small area 2x1 and complete wire balustrades on front deck and finish balustrades on small patio

Plastering and sanding two wall holes - View all the details of this offer: https://www.airtasker.com/offers/01K6CX836BD4NYE72HCZ1SYWEM

Our experienced awning installer needs help for half a day as his colleague is on leave. May lead to other work in future. It MUST be this Tuesday 16/9 morning start 930am. You will need to. - Help unpack a van with small awnings and blinds. - Hold ladders for the fitter to be up high. - Be on a small 3-5 step ladder to help him hold up the other end of the awnings. - Help clean up afterwards. Experience with Awning/Blind installation or being a handyman would be preferred, but not essential. We can provide tools if this is needed.

I have an uneven area on my bathroom ceiling where I scraped back the paint and repainted it. I need someone to come and make it completely even. Painting is not required - just the plasterwork. It is a small area approximately 50cm by 50cm.

One sided niche install size ~900mm wide, ~300mm high Looking for someone to cut out, install extra timber, gyprock if required etc. I’m happy to do the finishing painting so you don’t need any repeat site visits Thankyou Joseph :)

Need to attach a 1.2m wide awning above our back door. Exterior wall is render. Awning needs to be attached to the internal frame of the building as per landlord’s instructions. Pics show the awning, door and render.

Hi there, Looking for an experienced handyman or carpenter to help with some front and back porch upgrades: 🔨 Tasks include: Installing timber tops on approx. 15m of steel railings (front and back porch). Adding wood cladding or rendering to a pillar approx. 4–5m tall at the front porch. Painting timber tops and ensuring a neat, finished look. 💡 Materials: The price I have included is for labour only, as I am hoping to supply materials myself, however I may need some guidance on what to get. If you are happy to supply materials instead, please include that in your quote. 🖼️ Note: I have attached images of my railings and pillar, along with a couple of inspo pics for what I’m aiming for. Thanks!

Looking for someone to patch several Gyprock/plaster holes left after old air conditioning system was removed. The holes include: ✅ Hole from old split system indoor unit ✅ Hole from old controller panel ✅ Hole from old return air vent Would like all holes patched and sanded, ready for painting (I can do the painting). Please bring your own tools and materials.