Find a professional render contractor in Sydney

Remove a small concrete divider ( half the height of the room ) and then render the remaining wall wbere that divider was.

Looking for a quote for a rendering Patch Work – 2 Bedroom Apartment Renovation We are looking for an experienced renderer to complete patch work throughout our 2-bedroom apartment currently under renovation. Materials: We will supply pre-made render mix bags. Duration: Approximately 2 to 3 days of work. Scope: Patching and smoothing walls to a high-quality finish in preparation for painting. Requirements: Proven experience in rendering and patch repair Attention to detail and ability to deliver an even, consistent finish Own tools High-quality workmanship is essential. Please provide examples of previous work and your availability.

Cement Render 2 external garden walls. One wall 2.4 H x 4.7 L other wall is 3.1 H x 5.5 L

Fit cap rendering on garden wall and render side of walls. We will remove the timber (seen in photos) prior to job starting. Section 1) 5.5m ,Section 2) 2.5m Section 3) 1.8m Render area 30 cm for Sections 1 & 2. Section 3) 1.15m

Job: Cut approx 1m (or less) Channel in Brick Wall + Install Conduit + Render Back to Smooth Finish Hey everyone Always had a good Airtasker experience Just had my TV hung on the wall I’d love an approx 1 metre vertical chase (channel) cut into an internal wall (brick) to run TV cables (sealed power/AV leads) from the floor up to a wall-mounted TV. Scope of Work: • Cut a neat 1m channel into brick wall (approx. 20–25mm wide, 20–25mm deep). • Supply and install PVC conduit for the wires • Secure conduit with saddles/clips inside channel. • Patch and render back over channel so the wall is flush and ready for paint. Happy to do the painting myself :-) • Finish should match existing wall as close as possible please (smooth render, not a lumpy patch job). I’m happy to handle final painting, I just need it rendered smooth and ready. Job Location : Surry Hills

Two storey house in need of rendering or re-pointing of brickwork and brick patch up. Located in marrickville. Bonus if external painting can be done also.

smasub=ng mounting kit needs to be installed

Bagging a rear wall around back sliding door, a little bit of filling in corner also. Price to include labour and materials. 7 square metres in total

Rendering of the front brick fences. Reinstall letterbox supplied by owner prior to work commencing. Repair render gap in garage back window sill. Rendering of left side exposed concrete slab edge (at ground) from the rear of garage to rear of house and render repair the large holes in the wall at upstairs spa pump pipe penetrations on LHS wall. Rendering of back concrete slab edge and render repair above the rear sliding door. Repair rusted corners on the right front balcony. Repair rusted corners above the garage. Repair outside and inside rusted sections in the garage door opening and the bottom of column at garage door. Repair two rusted corners in front of front door from top to bottom. Repair of rusted corners consists of grinding out affected render and set beads. Including all equipment and all materials. Trades only offers please, no contractors or handy person.

Wall has cracked by tree roots underneath. Approx 3m Squared needs rendering repair.

render a wall inside garage

Patch repair wall in city

I need these 2 x small sections rendered and all the doorways in the picture. I have render here also rockcrete

Wall and window frame needs to be re rendered to be square set. Cornice section also needs to be repaired. Please see photos

We’ve had electrical rough-ins completed in our kitchen, and are now looking for someone to patch and render the walls where channels have been cut for new power points, switches, and cabling. Scope of work: Patch and render wall chases and holes left from electrical rough-ins Smooth finish ready for painting Areas contained to kitchen walls Must provide all tools and materials Paint patched render white Looking for someone experienced with rendering/plaster patching. Thanks!

Removed my security cage today and now a need to render the side of the entry. Its 2.4 high and 20 cm wide.

Remove the cracking render from a 2.5m long windowsill up on the 1st floor. Redo a render coat on the window sill. Paint the surrounding wall to match - width of a single room, ground and first floor (will require some scaffolding) A long second crack in render above entrance doorway to paint over also.

Looking for someone to remove old cement rendering around the window, and apply new cement rendering around the window.

Need to fill in render as it’s worn away. I would like a smooth level finish. Needs to be done over a weekend. There are 3 areas 25 x 35cm as shown in pictures .

Wall Rendering requires where Wall removed