Find a professional render contractor in Melbourne

Render wall on stair case ready for painting as photographed and small section near wall as photographed

The render and metal frame is coming away from the bottom of the pizza oven. I need someone to reinforce the structure.

Require the red brick walls rendered to match the outside of the house. See photos. Also require a small area in the foyer approx 1x1m in size.

The render on one of my internal walls has delaminated and started cracking. Looking for someone to remove the delaminated sections, and repair the render. It looks like it is a layer of render then a layer of plaster. There is also the smaller rectangle that needs to be repaired in the bottom corner (where we had removed the plaster), and roughly 130cm crack where the render still seems solid it just needs to be filled. Not looking for an entire wall repair and not looking for painting, just at leaving the wall ready for me to paint it.

To cement render the area on a wall that has been patched up after removal of gas heater. The surrounding wall is brick. Dimensions are 173x49.

Needs to do the rendering on the external wall

Bag/Render an exterior brick wall Already primed 6800mm x 3200mm h Approx 22 sqm In Davco off white or similar

Job includes: -Remove loose/damaged render -Patch/re-render the damaged section -Match the existing textured finish as closely as possible -Colour-match the existing exterior paint -Paint the repaired area so it blends in with the surrounding wall -Leave the area neat and weatherproof -Clean up afterwards I’m looking for a simple, neat and cost-effective repair, rather than re-rendering the whole wall. Please include materials and paint in your quote. Photos attached. Please only offer if you have experience with exterior render repairs and paint matching.

The original render ballooned out due to water. I have removed render in the damaged section.

Abit of damaged render very small, need to have it render touch up and colour matched to existing

Render the following: Photo 1 - Bottom of shared wall Photo 2 - Around air vent case Photo 3 - The face of the porch Render texture must match and blend in with existing house. We have a painter who will colour match the paint so render product does not need to include paint colour.

Small cracks in the render of external wall on balcony and window areas. water leaking into garage below.

100 x 200mm render and paint. Client has correct paint on site.

I want to render on the green beam around the balcony, we will install the blue sheets before rendering, it will be ready from Saturday Balcony size 1.2*2.4m

Had a new vanity installed and require either a render or tiling completed. Jist getting ideas on both options.

Just demolished an outhouse and need rendering for a feature wall. The size is 2000mm wide x 3000mm high. The corner on the right will need a deeper fill and will most likely return around 100mm on the right hand side wall. Render just the minimum thickness required and a cement colour finish is adequate. Not too sure of tge cost, hence I've put a minimum of $10.00

Paint rendered fence and back garage door

Front wall to be rendered. Looking for good attention to detail.

A handful of hairline cracks around the house that require re-rendering

Looking to render single skin brick all to add structural support.