Find a professional render contractor in Inner West Sydney

1. Fix render as per pictures 2. Fill under door track with cement to give the frame some support and stop water getting in

Need to patch the brickwork, render over it, sand it then paint the wall.

Bathroom renovation, need walls rendered to prepare for tiling.

Need rendering to be done in bedroom window and laundry and hallway

Repair render and patch wall after electrical work around 3 x light switches as picture and another area above a door, also pictured.

Garden bed walls and garage walls to be rendered with a “speckle” render. This is a coarse type of render that is normally splattered on with a machine. Also called roughcast or pebbledash render.

Renderer to patch up around existing render

Recently demo’d kitchen, including wall tile removal. Require rendering and white-set.

Window edges - need cement rendering. Only top edge on 2 windows. You to supply all material and labour. During the course of cleaning, we were removing old double glaze windows and hangers for blinds. As a result these were all stuck on using silicon and industrial strength tape and when we removed these, the cement came off. Please note the following brief: - some of the cement render which has come off from the top part of the window is an 20mm thick. 2 windows affected. Others not so much. - I need the windows taped to protect the aluminium and I need all this damage fixed. - the edges 45 degree angles need to be finished off smoothly. - I require this done Tues 19 August (tomorrow). - I need a professional. - I have painters who need to paint this on Tuesday so your guidance for drying time needs to be given please. Needs to be ready for painting Tuesday 19 August. - quality licensed person to do this . - work needs to be guaranteed and weather proof, waterproof. - I need sealed and primed ready for painting as well. - 2 windows: 1150mm high x 1800mm wide. - location: Homebush West. - photos attached. - every precaution needs to be taken to ensure this is secure and also ensure that the underside of the rendering does not drop off whilst drying or supported if need be. - if you would like to inspect before doing the job, I am available.

We bricked up a door and installed 2 new windows so will need the section of the wall rendered

Need two bathroom walls (approx 4.3m² total) re-rendered. Walls are damaged with soft, crumbly areas that need stripping back and fresh render applied. Final surface needs to be smooth and ready for priming and painting. If you are able to fix the hole where the previous vent was also, that would be great, otherwise I can do it. Ignore the tile missing with the powerpoint, this will be replaced.

Demolition has occurred and bricks, concrete and render need to be removed.

Rendering smooth finish. Length 5.6 metre width 600 mm at widest but narrows. Complete section below fence in photo. Existing and exposed brick section.

Hole in kitchen, approximately 30cm long and 20cm wide (the actual hole is smaller but the part requiring rendering to be flush with the call is approx that size). I believe it needs to be rendered. Location Dulwich Hill. Ideally completed by the end of October, flexible with work time.

Job includes: - Rendering Blueboard / Villaboard under the roof line (requires acrylic render). - Brick patching and rendering below the sliding doors.

- Please state your quote and timing for the job - Need two rectangle holes to be rendered around to make it square and right angle - You’ll supply the cement render and plastic angle beads

After some prices for bagging or rendering a brick wall please. Approx 5x3m.

A small wall needs to be bagged using terracotta colour (supplied)

Render has been removed from 15sqm of kitchen wall back to clean brick Low spots and electrical chases have already been filled with Dulux acratex acrylic render. Looking for renderer to render the wall in acrylic render ready to paint finish. Thanks

Render 2 walls in 2 bathrooms