Find a professional render repair in QLD

Render concrete pump house and retaining wall including edge work. All materials must be supplied, happy to discuss on the phone. Need done ASAP

Silicone removed, 10 screw holes repaired rendered over. We removed an old BBQ so wanting to repair the wall. Gas and Power all remaining in place. just want to neaten up. I need a well finished job that does not look like it is repaired. Ready to paint clean job site state when done.

Examples as per.photo a renderered letterbox with parcel box insert as per photo. Garden to side to be on left side and square approx 1x1m. Location to be behind water meter as a sort of.retaining wall..

I need a qualified contractor to repair damage to an external rendered wall corner next to the garage door. An invoice needed for the real estate. The damaged area is approximately 800–900 mm high. I need someone experienced with external rendering/plastering to assess the issue, confirm the correct repair method, and provide a clear quote before starting. The repair needs to be suitable for outdoor conditions and blended to match the existing wall texture as closely as possible.

We are looking for a post rendering on our garage.

Scope of work: • Filling gaps and penetrations • Applying expanding foam • General labouring support for renderer/wall works • Site clean-up as required

Just looking to get a quote on some rendering on a block wall please. I’m in Cowell drive Burleigh heads. Here is some pics of the wall. Cheers

Small repairs on render needed

Rendering needed above the garage door. Polystyrene system. Will need new bead installed on the bottom and sides. Will need the entire thing rendered. I have new bottom bead and the fibreglass mesh. Not sure what the ends need bead wise but will purchase materials once I lock in the trade and date and let me know what render to purchase and or other things to make it happen. Measurements - 4960x220x40

I need someone professional and with proper insurance to come seal and render our cracked wall next to the balcony

I am looking for a grouter / cement applying person to repair a leaking wall from water. You would supply the materials for applying grout. Need a fixed price quote only. Thank you

Need renderer for a day tomorrow

Fit two exterior hose reels to brick and rendered house

Fill in gap of rendered wall, front on both sides is ground level under the eaves, one at the rear is second storey will need approx 20m ladder, paint colour is dune, can be supplied equipment 1. Clean the exposed EPS edges Remove loose paint/foam. 2. Apply a flexible waterproof sealant inside the gap (Just to block airflow/water — doesn’t replace flashing.) 3. Install a vertical metal flashing / cover strip Usually: Colorbond folded flashing 0.55 mm or 0.75 mm gauge Colour matched (Surfmist or similar) It sits over the joint like a cap. 4. Screw into the solid substrate on both sides Use: Bonded washers Sealed screw penetrations Silicone edge beads if required 5. Paint touch-ups if needed

Render letter box repair

There is a small damaged section (around 15cm tall) on an exterior wall corner at ground level. The render has cracked and chipped off, exposing the plastic corner bead underneath. I’m looking for a simple, budget-friendly patch repair — not necesserily a full professional texture match (though open for qoute). Just need it filled, patched, and roughly blended so it looks tidy from a distance. Details: Damage size: approx. 15cm Location: exterior wall corner near ground Corner bead seems mostly intact No need for perfect texture match No need to repaint whole wall — spot paint or primer is fine I don't have any paint/repair material. Please send your quote and availability. Thanks!

Couple of small chunks taken out of the render next to a sliding door (door has been hitting the wall). Just need it patched and textured to look tidy again. I’ll handle the paint later.

architectural renders prepared by 3dstudio max

We urgently need our rendered wall repaired to match the finish (we can do the painting). We drilled and patched a couple holes ourselves but it’s not exact as you can see The texture cement render needs to be more consistent we are told - so we can get our bond returned. Might just need to drill the holes out again and plug it to match unsure

need a plasterer to fix front wall and render