Find a professional gyprocker contractor in SA

I got two joins that need to be flushed and sanded, and cornice done too if you can. Need it done today if possible

Need my house either completely or partially re-plastered for a renovation.

New house, I have wall brackets but need 2 TVs and a small Samsung Music frame to be fixed to walls and stud work located

I would like to run wiring before gyprock 3 switches, 4 power sockets and and 3 lights

Planning stage - Quote - gyprock sons ceiling -patch/repair, new cornices and cornices in master bedroom repair/new

75 SQ Meter Granny Flat. 13mm Gyprock happy to supply from Bianco or Bunnings. 3 step Cornice install. Wet area WF Gyprock. Flushing

I have a 36-square-metre steel shed (approximately 6m x 6m, with a height ranging from 2.8m to 3.8m). Please see the attached photos for reference. I'm looking for someone to help with the following: 1. Build self-supporting timber stud walls (not fixed directly to the steel shed) – similar to what’s shown in the first attached photo. 2. Install insulation. 3. Install gyprock, ready for painting.

I'm looking to gyprock my two-bedroom unit, which is of block construction - walls only existing ceiling to remain. The unit will be a shell with no existing linings, and the bathroom is excluded from the scope of works. The property is currently tenanted but will hopefully be vacated within the coming months, so the work would be scheduled accordingly. Could you please review the images and provide a rough estimate for the job? It would be great if you could also outline what’s included in the quote—for example, materials, labour, surface preparation, and any other relevant details. Also, I’m open to settling the job with a cash payment if that helps with pricing flexibility. Looking forward to hearing from you. Best regards, Blake

Relatively new build, just have three cracks in the gyprock that need tending too. 2x small cracks (150mm in the ceiling) 1x large crack (750mm above the fireplace)

Needing Gyprocking for a 60 square metre granny flat due for completion end of September. Ceiling height is 2400.

Gyprock ceiling 4 rooms totalling 56 m2. Currently exposed timber 1200 centres with Stramit ceiling. Stramit does not have to be removed. Top Hat batons @600 centres are the most likely procedure.

Gyprock was cut out of wall where the fireplace was installed (this photo was prior to unit being installed). Original piece of gyrock has been cut and put back into wall, just need plasterer and painter to repair the cut,

Gyprock wall partition of 3.5m x 3.7m with a door and numeric lock pad needs to be installed. Please send a quote.

I have two ceilings to gyprock. Size of rooms are 4.1x4.5 & 3.6x5.3. They are both raked ceilings. I have ladders and gyprock crane on site. I have prepared frames around air cond and added timber where necessary for support. I also have the gypock (8xsheets at 3x1.2 & 7xsheets 2.4x1.2), plaster and insulation on site to get the job done. I might be a bit short of top coat. I am available to help until mid next week otherwise Ill stay out of your hair.

I have a bathroom that needs wr board or villa board, a wall clad with gyprock and some repairs to celings were AC vents have been removed

Gyprock two small ceilings and tape them plus taping two walls that are approximately 3m x1 m high each

The room is 14 ft x 12 ft (3.66 x 4.27 metres) The existing ceiling already has one new batten to secure the section that was drooping. The new work is: remove old cornices; install new battens, gyprock and cornices; and flush to a high standard. Please provide a separate quote for painting the ceiling.

I need a small piece f gyprocker fixed in my roof tbat a plumber cut out. I still have the piece.

Large hole in gyprock. Just need repaired up to painting. Not inuding painting.

Patch area that plumber created to access leaking rap