Find an experienced handyman in Baulkham Hills & Hawkesbury

Handyman required to help reattach door hinge. The screw holes seem to have been used a few times already, so the screws just spin without gripping and likely need some reinforcement.

1. Fix water leak under the sink in granny flat 2. Fix flush for toilet in the main house 3. Fix whirlybird on garage roof .. it seems to have been stuck

I need a fly screen sliding door, roughly 2280mm height and 1220 m width. this needs to be provided and installed. I also need to change the door handle for one of my bedroooms. I have the current handle out and purchased a new one, needs a larger hole.

Details: Bedroom ceiling has sagged and is currently propped. Failure caused by original glue-only installation. Ceiling must be fixed properly. Scope of works: • Remove loose/sagging ceiling gyprock • Clean off old adhesive from joists/battens • Supply & install existing gyproc • Screw-fix plasterboard into joists (not glue-only) • Set, sand, and finish joints • Refit light fittings / vents • Repaint entire ceiling • Remove waste and clean up Requirements: • Must comply with AS/NZS plasterboard standards • Licensed & insured • Include all labour, materials, disposal, and painting in quote. Prefer to use existing gyproc where possible (not replace entire ceiling - prop up and reattach sheeting with screws).

Install a pet door for a 18 KG DOG , to the current laundry door

Install a wireless solar camera at the front Walls are of Hebel material, not bricks, soft material ,if you have drilled into hebel before would be better

I have 5 sealing fans to be installed, need someone to wire and install these. Please give me your offer.

Minor dent on the garage door. I.ag3s attached.

Need an electrician to swap out an existing ceiling fan.

Clean sand and poo out of chicken coops and new sand put down and saw dust put down in stable

Tried to screw in bathroom towel hook and the door didn't handle the screw that came with the pack. The hole needs to take a screw and bolt so that i can tighten the hook to the screw. But the door thread is gone and it can't screw in tightly. Need help to fix. Will add photos when someone is ready

I need help with the following: - assembling an IKEA Queen Size Bed - mounting 1 artwork/picture on the wall using industrial tape (not nails). It's easy and modern - mounting two mirrors using the industrial tape (not nails) - putting the stand on the TV (not mounting the TV but simply putting the legs on a 75 inch tv)

I have 2 plantation shutter louvres where the pins have broken off and half is in the louvre and the other half is in the shaft. These broken pins need removing and replaced with retractable pins so the louvres can be fitted back in. Need Someone who’s fixed these before and has the tools to do so. Wa thinking of using retractable pins to make it easier to put louvres back.

I have a couple of small holes in an external Hebel wall that needs to be repaired.

My wife hit the gate, it’s happened before and it’s been fine. This time it seems like it’s reset itself and it doesn’t seem like it’s working out the limits. Need someone to come and have a look at it, see if it can be reconfigured or if there’s damage and needs fixing or replacement

Need to fix a door latch for the entrance door. I have the latch please see video

Hi, we have a broken fence that need amending. See pictures attached.

Installation of the following ceiling fans 1 x Mercator Smart Grange 2 x Mercator Grange This will be a new install - i.e. replacing existing light fittings with the fan.

Small gyprock patching. Ready for painting

Supply and install privacy screen on elevated deck Horizontal wooden slats preferred Total length is approx 20mtr and height of 1.8mtr