Find an experienced gas fitter in East Melbourne

Need a certified gas fitter to install propane regulators on Electrolux gas grill AGG24CE and flat top ARG24FLCE, both of which are commercial grade.

We require a licensed plumber/gas fitter to complete the following works: - Splice into the main gas line located beneath the courtyard deck and install a T-piece. - Run a new gas line from the T-piece to the existing copper pipe designated for our barbecue connection. - Assess the existing copper line and extend it if required. The main gas line is yellow PEX (brand unknown). All work must comply with applicable gas safety standards and regulations with certificate supplied upon completion.

Stove tops work fine but the oven flame doesn’t stay one after you release the ignition.

Aqua Max pilot gone in hot water unit tried to ignite it multiple times with no success

I have a gas heater that is missing a cover plate just wanted to see if anyone would know how to source and install Measurements are 91cmx67cm

Hi there, I’m looking for a licensed Type A Gas Fitter / Plumber (VBA registered) who can complete both jobs in one visit and issue a Gas Compliance Certificate upon completion. 1. Gas Cooking Appliance (Chef) - Install/replace either a 15 mm copper pigtail or an accessible isolation valve to meet compliance requirements (see photo). - Install an anti-tilt / anti-tipping bracket or chain to secure the cooker to the cabinet or wall. - Perform a pressure and leak test once work is completed. 2️. Hot Water System (Aquamax Storage Unit) - Replace the leaking PTR (Pressure & Temperature Relief) valve (see photo). - Extend the PTR drain line to a compliant termination point (drain or relief gully). - Test the operation of the valve and ensure compliant discharge. Please confirm you are licensed and able to issue a Gas Compliance Certificate before accepting this task. Photos can be provided upon request. Thank you!

Gas safety check for a house

90cm gas cooktop No active gas connection to the house Carefully remove old gas cook top We have a skip on site Images to follow

gas glove repair. Fire always disappears after couple minutes.

Astral Pool Viron250 gas pool heater not igniting. The heater turns on, but does not ignite. No ignition symbol.

One of the ignition points on the gas stove is not igniting; this was caused by forcefully turning it before. The others are fine. This is a Miele gas stove.

3 port fryer gas pipes needs to be undone

gas for cook need check and adjust. It’s hard to open

I have a large plumbed in Beef Eater gas BBQ but the flow and heat is absolutely piss weak. Need a gas plumber to fix ramp it right up

Installation of 900mm Gas cooktop and Canopy. Removal of old appliances and clean up

I need a licensed plumber to carry out the following tasks. - Cut back and seal off gas pipe (no longer needed) - Water points to be cut back and replace with mini-stops to reduce in length (currently sticking out too much) - Re-position waste point to upright position (trap to be also upright)

Looking for someone to assemble this Bunnings Mimosa Outdoor Gas Heater. Comes in several parts.

My Lennox g61mpvt gas heater can not restart after stop. i tried to turn off and turn on the power, the heater can work for a while, then after temperature reached to the setting, heater will stop and not able to restart again, and fan blows cold air. please quote . thanks

The pilot light on our gas heater isn't lighting. Looks like a thermocouple issue (maybe)

Small , silly to ask job but very important ! Our gas unit that works our heating pilot light is out . We need someone to pop in and relight it ( maybe show us while you’re at it so we can do it next time!) no idea how to do it but have had someone do this not long ago It’s literally a two minute job Thanks 🙏🏽