Find a professional planter box contractor near you

Hey everyone, looking for someone who can render my planter boxes. I’d say it’s approximately 20 meters in length and about 250mm high.

I have a long, narrow raised garden bed in my courtyard (approx 2.4m long x 500mm wide, masonry walls both sides). I want it covered with timber decking boards so it works as a bench seat. What I need done: • Cut and fit 4-5 short bearers across the inside of the box, packed and levelled so the boards finish flush with the top of the masonry • Lay decking boards lengthwise and screw them down to the bearers • Leave an open gap in the rear board where the sewer pipe comes through. • Seal/stain all faces including undersides and cut ends Important: • This is a rental so nothing can be drilled or fixed into the masonry or the house wall. The whole thing must sit in as a removable tray held by its own weight and a snug fit. • Timber-to-timber screws only. I’m happy to provide materials if you let me know what you’ll need. You just need to bring tools. Should be a 2-3 hour job for someone with the right gear. Ground floor, easy access through the side gate. Happy to discuss timing — weekends or weekdays both work

I have some planter boxes that are already mostly built and finished. I’m looking for someone to install a false/raised bottom inside the planter boxes to reduce the amount of soil needed to fill them. I already have the timber required for the job, as well as a nail gun, compressor and nails. The job will mainly involve measuring, cutting and securely installing the false bottoms. The planter boxes are already assembled and accessible. You’ll just need to bring any other basic tools required, including a saw for cutting the timber. Looking for someone with basic carpentry/timber experience who can get the job finished neatly.

Demolish planter box (constructed of garden sleepers and cladding, approximately 4m by 0.75m by 0.75m). Remove plants, soil and construction material from site. Retain plants in front as much as possible, and be careful of the reticulation in the box. Also pull up pavers in garden and remove from site.

Customised planter box made for me Inspo pic uploaded.

I need two people, that can assemble VIda XL corten steel planter boxes, 14 of them, they vary in size, its not difficult, but it is fiddly with lots of small screws and my arthritic hands cant to it, not to mention my eye sight. It's not heavy work, but attention to detail (i.e. the instructions) is paramount. Work can be onsite in kyneton, but if you have a workshop or shed and prefer to assemble there (provided it's within a 20 minute drive from Kyneton), that's Okay too, I can collect finished boxes with a van.

2 Planter boxes made out of treated pine 6000 x 600 x 400 and 3000 x 600 x 800. Installation requires narrow trench <150mm and width of 100 mm in soil length of long sides ie 6000 & 3000 x 2. Easy level access.

I’m looking for a handyman/carpenter to modify and finish several existing Montague timber planter boxes to give them a more finished, traditional appearance. Scope of works * Install a vertical timber dressing piece to each external corner of each planter box to conceal/dress the existing corners. * Install a horizontal timber capping/dressing board around the entire top perimeter of each box to create a neat finished edge. * All new timber is to be untreated timber, as the boxes will be used for growing vegetables. * Timber should be appropriately sized and neatly mitred/joined to create a high-quality finished appearance. * Prepare the exterior surfaces as required. * Prime and paint the entire exterior white, including the new corner pieces and top capping, to achieve a clean, consistent finish. * The finished appearance should be similar to a traditional white timber raised garden bed rather than a rustic crate. The planter boxes are already assembled. This job is primarily carpentry/dressing and painting, not construction of new boxes. I can provide photos of the existing boxes and the style I’m trying to achieve. Please quote for labour and materials and advise availability.

I have a planter in my yard I would like all the soil dug up bagged and disposed off. Also multiple bags of rubbish taken away. See photos for description

Cut a rendered retaining wall Minimise dust Consider noise and dust due to apartment complex Job is on balcony Wall is 120 x 40 cm approx

Assemble a Vida XL Planter Box. Dimensions 80x 40x 80

Brickwork is still in place but mortar joints have failed and bricks are misaligned, some are also cracked.

I have concreted rendered planter beds that have been painted. I need them repainted, after surface preparation, with a Dulux Avista concrete sealer paint. I’ve chosen the colour. There is a crack that would need to be filled too. It’s not a big area and very accessible. Ideally the job would be done the week commencing August 24. Thanks for taking a look at the job

I’m looking for someone to supply and install a raised timber sitting platform along my backyard fence. Approximate size: 12 metres long 500 mm wide Around 500 mm high Timber posts and framing at the front and back Decking boards on top cladding along the front Two raised planter boxes, approximately 700 mm high × 500 mm wide, one at each end I have attached photos of the existing area and a rough draft sketch for reference.

We need some broken bricks replaced in planter boxes

We have 11 planter boxes finished in raw concrete although made of fibreglass that need a light sand and two coats of paint allow an hour or two between coats. Paint and roller supplied. The planter boxes are 1 m long each photos as attached.

Need plants and soil and small rocks etc removed from these 4 x planter boxes Each one is approx 150cm long x 50cm wide x 30cm deep with soil All soil needs to be removed off site.

Need someone to cut and remove the plants in the three planter boxes seen in the pics.

We are looking for an experienced painter to paint a newly concrete rendered L-shaped planter box at a residential home in Brabham WA - approximately 5mx3m in length. You will have access to the backyard where the planter box is via a side passageway which is approximately 0.6-0.8m in width and ~25m from the front. What we will supply: - Paint + Primer/Sealant - recommended product type and quantities TBC and advised by the person completing the job. What you will supply: - All other remaining tools and equipment required to paint the rendered planter box. Please reach out with any further enquiries.

I need someone to waterproof my recently rendered planter boxes outside we will supply all the materials just need someone for labour