Find a professional planter box contractor in VIC

Outdoor Planter Box Rebuild – Demo, Waterproof & Retile I have a covered outdoor alfresco area with a long rendered/stacked stone garden wall with built-in planter box cutouts along the top. The sides of the wall are solid and in great condition. The issue is the internal structure of the planter boxes — the timber framing underneath is rotting out and the bluestone tiles on top are lifting/shifting as a result. Work required: Demo and remove all rotted timber framing from inside the planter box openings Rebuild the internal planter box frames using steel or masonry (no timber) Apply waterproofing membrane to all internal planter surfaces Re-lay bluestone tiles to match existing (grey/blue tone, approx 600x600) Grout and seal all tiling Clean up and remove all waste What's staying: The stacked stone wall sides are NOT to be touched. Location: Epping, Melbourne VIC Looking for: A tiler, concreter, or general construction tradie with experience in outdoor garden structures and waterproofing. Please include your experience with similar jobs and a rough quote in your response. Photos attached. Happy to answer questions before accepting. I will purchase new outdoor tiles, please quote for the rest. Timeline not worried ill work around taskers schedule..

Demolish and remove old brick planter box. Planter box contains soil so that needs removal too

Need two down pipes plumbed into existing drainage points. All material onsite. Both have 4 x 15 degree bends and joining couplers ready to go.

I have 4 metal planter boxes on my balcony balustrade that need to be removed. Noting some screws (hex head) have rusted through and may be difficult to remove. Once off, the mounting holes need to be properly rust treated and filled with metal epoxy. The full balustrade then needs to be degreased, rust treated, sanded, primed and finished with white epoxy paint. SCOPE OF WORK - Remove 4 metal planter boxes from balustrade - Treat and fill all mounting holes with metal epoxy - Degrease, rust treat and sand entire balustrade — handrail runs 6m (including wraparound), panels and top and bottom rails run 4m - Prime and finish entire balustrade with white epoxy paint. Tasker to supply all materials (degreaser, epoxy, rust converter, primer, paint, tools) Experience with metal surface prep and painting essential

Put back together a planter box ( all material is there just needs to be put back together

Moving soil into planter boxes, most of this will need to be by bucket. Moving debris from front of house to back and putting into planter boxes.

Painting wooden planter boxes, touch up fencing and base of deck area, roller an already painted brick wall. Please see photos. Will need 2 coats. Paint and paint brushes supplied. Do not need to be a professional but do need to know what you are doing.

Assembly of 9 Greenlife planter boxes 1200mm x 300mm x 300mm

Outdoor 13 long planter box with soil and plants in it in my back yard to be moved to another location in my back yard. 5 feet away from where it is now. It’s not screwed to the concrete but it’s very heavy. I can’t move it at all.

I want these bamboo plants removed from the planter box (roots included- not just cut down to ground level) These are the clumping type (not the invasive spreading type with runners) I’d like all waste removed too I’ve partly done one of them which you can see in the photos

Timber frame needed to encapsulate existing corrugated metal planter box that is bowing. Have timber and screws already. Looking at 3mL x 800mmW x 1.8mH roughly.

Looking for an experienced carpenter to quote and build a custom elevated timber structure. Dimensions: Approx 4m wide Approx 600mm deep Scope of work: Remove existing steel mesh and planter Build a single continuous timber unit across full span Left side (majority): large storage box Top-opening lid Accessed from the rear (house side) Right side: integrated planter box Structure mounted to existing brackets (or upgrade if needed) Build requirements: Weatherproof - ish Outdoor-rated timber (or composite if recommended) Clean, modern finish (ideally natural timber look) Structurally sound for long-term outdoor exposure Images. what's there now: Steel Mesh storage box and pot plant 2nd image is similar to what I'd like.

I have an existing raised garden bed on my deck (see photos) and I’d like to convert it into a bench seat by installing a solid timber top. The structure is already built (Merbau finish)— I just need someone experienced to: • Measure and confirm sizing • Supply a suitable top panel (~700mm x 3400mm) • install top panel and ensure it is strong enough to sit on (load-bearing)

I have approximately 12 cubic meters of soil that needs to be moved from my driveway into plan a box of spread around my backyard I have wheelbarrows and shovels there is a couple of steps however I have ramps to go down them.

I’d like some planter boxes to near my decking at the same address . Also if they can be restored that would be good too Images for reference

I would like to paint my garage door white + paint my planter box monument black. If you have pictures of your old work will help us feel confident.

Build timber around metal planter boxes. 7 are on a sloped driveway (the structure underneath is already built). 3 are on the dirt. Just need the 4 rows of timber, around the boxes on all 4 sides. See photos for measurements. Soil is already in the the metal container but the metal planter boxes buckled so timber is just to make it look better. I will paint them. One box has been constructed, would like to continue with similar design. I need you to purchase the supplies and bring to location. I don’t have anything (and no tools).

Size 1200x500x600mm (Depth). Total height can be 700mm 3 sets needed.

Wooden boxes have rotted. Walls need to be rebuilt with second hand materials. About 15 boxes to be repaired. Walls are only about 50cm high and made with corrugated iron and secured to Corner posts. About 1 week’s work.

Needing a plantar box along the fence with bench in between , size of 6mx0.6m