Find an experienced flooring expert in QLD

Quick step floorboard installation (tongue and groove) and skirting board installation for a 2.5 x2.5m room.

Lay Hybrid flooring to about 40m2 granny flat

Looking for quotes to install decking to an area of about 4-5m2 under stairs below a balcony. The area is uneven and there is a water heater that it will need to go around.

(Quote) Looking to get some hybrid installed, I have a enclosed trailer that's 18.5 sqm The planks that I have are 1.850 long by 230 wide 9 mm thick" commercial grade" you're covering the area a lot faster. Respectfully, if you can't do a "professional job"please don't bother!

I need someone to lay 50sqm of Hybrid flooring in my living room, kitchen, hall way.

VW Transporter – Remove carpet & install hard-wearing flooring (MTB use) Description: I have a VW Transporter with carpet flooring in the rear. I’m looking for someone experienced to: • Remove existing carpet and adhesive • Prep/clean the floor properly • Supply and install a durable hard floor suitable for MTB use (mud, water etc) • Ideally install a plywood subfloor + waterproof vinyl or similar finish • Seal edges so it’s fully protected This is for practical use (bikes in and out), not a luxury camper finish. Please include: • What materials you recommend • Total price including materials • Photos of similar work (if available) Located in Surfers Paradise Flexible on timing.

Entire house house to have vinyl planks layed and skirting. Room with red circle may need sub floor (maisonite or equivalent) Room are prepped and ready All product to be supplied

I scored a new box of laminate flooring and used so I have more then enough for my bedroom needing done (carpet been ripped up) my problem is I have no idea how to do it! I also need under layer. the room is 3.4x2.6m in a house in worongary needing just the one room done. Feel free to ask anymore questions

Flooring installation – Burleigh Heads (labour only) Looking for an experienced flooring installer to install click-lock laminate or hybrid flooring in a small room. Details: - Location: Burleigh Heads - Room size: approx. 14m² (L-shaped – see photo) - Subfloor: concrete slab (level and clean) - Flooring: already purchased (click-lock system) - Job type: labour only

Looking for a hybrid floor installer, to give Quote to lay new flooring on my enclosed trailer that's 18.5 sqm, the planks that I have are 1.850 long by 230 wide 9 mm thick so you're covering the area a lot faster. NO underlay needed on these planks as there is padding on the back of them, they not cheap planks!!!! Respectfully, if you can't do a "professional job"please don't bother wasting my time. Cheers

Qualified floorboard installer needed for a ensuite (includes a walk in wardrobe). All materials will need to be included. -Floorboards -Underlay -Scotia -Door transition strip. Can organise a day for a quote/consultation and then set up a day for it to be completed. The room will need to be completed to a similar color to the rest of the rooms. Hoping to have one day for consult and day two for work and completion.

I have 9 sq m of hardwood flooring that needs to be laid over new sub floor. It's 12mm tongue and groove hardwood. I have the new boards. I'm after a professional carpenter/ flooring installer. You will need your own secret nailer. If you can sand and Seal too please let me know. Existing is poly matte finish.

Roughly 15-20 m2 out door area of new built. Wanting composite decking done. The asked price is not actual. Will negotiate and come to agreement upon discussion. The dirt in photos will be removed and the ground will be graded. Looking for someone to install the frame and composite decking.

Lounge room and kitchen needed floating floor boards laid materials supplied ready to go.

Install vinyl plank flooring in toilet. Approx 1 meter sq. Exact measurement is 1.8 metres by 90 cms. Remove old linoleum tiles.

Replace the carpet with wood or laminate flooring. Supply and install. I am not sure which material to get so please give me few options with material + installation cost. The room is about 3.5m x 3.1m with 2 little cutouts.

Hey guys I will be buying the hybrid flooring hopefully this week. Roughly 43/45m square hybrid flooring to lay. I will be purchasing 47m square for excess. Show me some offers. Cheers

Small job required today or any day next week that suits Small lounge Even smaller kitchen Measurements in photo 1 Flooring removed already Job is to take flooring to tip & instal new flooring Everything has been measured & brought to measurements Ready to go now Job location Zillmere road Zillmere $600

Job Title: Lay 65sqm of Laminate Floorboards Details: Looking for an experienced flooring installer to lay 65 square metres of laminate floorboards, and underlay. • Subfloor is prepared/flat. • Work must be completed neatly with attention to detail, including clean cuts around edges and door frames. • Tasker to supply own tools. Materials (floorboards, underlay, if required) will be provided. Location: Coombabah Timing: Flexible – likely week beginning 6 October 2025 Experience required: Prior laminate or timber flooring installation experience.

Need the house floor laid on Monday. The planks are the easy way decking and we have the floor cutter. We were going to lay it but have work commitments tomorrow so hoping someone else is available. Preferably someone that has done flooring. It’s on a concrete subfloor we have just prepped.

7-8m2 floor polishing to blend into existing

We have a shop with polished concrete floor, we need it re done

match existing pine flooring. kitchen cabinets removed, couple of pipe holes also require filling. thx.

We need our desk sanded and polished. It’s approx 25 sqm

Minor scruff marks on the timber floor wax, i'd like to have this covered and repaired.

Commercial space needing cement floor levelled and polished- roughly 100sqm

Floors were cork, all cork and Masonite have been removed except around cabinets in kitchen. Need someone with access to a toe kick saw to cut the cork boards under the kitchen cabinets, I can remove cork and staples myself. From there I need someone to sand and polish the floors.

Hi, I need someone to clean, sand and polish our wooden deck. Please see pics for reference.

Need someone to sand and polish timber floorboards in a 3 bedroom house. Total area approx 75m2. Half of the area has been previously polished and oiled and half is bare timber boards with carpet on it. Need the whole area sanded and 3 coats applied with a solvent based polyurethane. Need someone fully qualified and need a valid tax invoice.

Need original hardwood flooring sanded and polished. 15 squared metres was under vinyl so it has some residue glue on top, plus 23 squared metres is already polished and good but would probably benefit from light sanding and polish at same time to match colour (they are next to each other). Total floor space is 38 squared metres. Current polish is polyurethane Matt finish.

Looking for a quote to remove old carpet which is laid over chipboard secured to old timber floor. We will then need the timber floor sanded & polished. There may be a couple of broken planks to be replaced or patching required. The area is roughly 55sqm (3 bedrooms, hallway, lounge room).

Polish / buff flooring,main areas. Kitchen, dining, hallway and 2 bedrooms.

Floor sanding and polishing

I need an experienced flooring professional for a two-stage job in my kitchen in Aspley (QLD). Stage 1 – URGENT (before 17 Feb): • Remove existing cork flooring and cement sheet underlay • Deal with nails/staples properly • Leave timber boards clean and ready for kitchen renovation This part must be done before 17 February. Stage 2 – After kitchen renovation: • Sand and polish the timber floor • Match the finish to the rest of the house (appears gloss, but to be confirmed) • Open to professional advice on finish type to ensure a good match Area size: Approx. 2.4m x 2.4m What I’m looking for: • Experience with older timber floors • Own tools and sanding equipment • Ability to match existing floor finishes • Clean, professional workmanship Kitchen renovation is underway — sanding/polishing will be scheduled once installation is complete.

We are looking for a professional and experienced person to finish a small 10sqm Merbau wooden deck. The deck is already installed, and the job involves proper brushing and surface preparation, light sanding or polishing if needed, applying an even deck stain, and finishing with quality timber oil to achieve a neat, rich look. This is a small but detail-focused task, so experience with Merbau decking is important. We are just looking for someone who can complete the job today. Please share your experience, availability, and quote. Photo attached for reference.

I’m after a reasonable, competitive quote. Please respond with your experience, availability, and whether you offer free quotes.

I want to polish and varnish my current stair treads. Want them to look brighter, similar to oak color. I've taken all out, twelve in total, dimensions of each are: 900 x 235 x 45 There are some nails and staples due to the carpet I removed. Two of the stairs are partly broken, I attach some pictures so you can see. I have the existing parts and the balustrade if needed. I can bring all the stairs to your place. Thanks

I need a bedroom to be sanded and polished. The room is 3.6m x 3.6m This room was originally carpeted, and I have ripped up the carpets and am now looking for this to match the remainder of the house

Need someone to do a neat polish on my wooden deck

Area is roughly 110m2, looking someone who can give quote.

Hi there, We have Merbau decks that need to be machine sanded back ( we will hire sander from Bunnings for you) but first the nails need punching in a bit to allow sander over. Then it needs restraining. At Toowong. Thanks!

Timber floor repair / sand and refinish small damaged patch I need someone experienced in timber floor repair to inspect and fix a small damaged/discoloured patch on polished timber flooring near the skirting board. The area has surface wear / sanding marks / finish removed, so I need someone who can: assess the damage properly advise whether it needs spot sanding and colour matching re-stain / recoat / refinish the affected section so it blends with the surrounding floor as closely as possible

Looking for someone to sand back and refinish my outdoor timber bench seat, then seal it with a durable natural matte finish. Bench seat is removable and can be taken away to complete off site. I would like pickup and return included. Size Approx 3.0m long x 0.4m wide. Finish required Natural matte, low sheen. Prefer the most durable option for outdoor use. Happy to follow your recommendation, but I am leaning toward a quality exterior decking oil in a natural matte finish for longevity and easy maintenance. Scope of work: - Transport off site - Sand back to an even finish (top and edges, tidy up the ends, bottom if needed) - Prep and clean properly before coating - Apply stain if needed to even out colour, otherwise, clear natural is fine - Apply exterior grade protective finish in natural matte (2 to 3 coats as required, coat all faces including: top, edges, and ends and bottom if recommended) - Return Please include in your offer • Total price including materials and pickup and return • Product system you will use (brand and type if possible) • Estimated turnaround time • Photos of similar outdoor timber refinishing work Timing Flexible, ideally within 7 to 14 days.

Approx 26,60sqm of decking needs to be sanded down and refinished at my place. Divided in 2 different areas (front and back balconies). Easy access, floor level, timber in fair condition, no damage. Please send me an estimate or quote. Needs to be done before end of Jan 2026 but as soon as possible really. Cheers.

We need a floor sanded and refinished in Wynnum - about 14m2

This is just for 1 average sized bedroom. Summary of the jobs that need to be done: 1. Disassembly (partial) of bed and moved to another room - I will help with this 2. Removal and disposal of carpet and crap underneath, I can also help with this 3. Sanding and refinishing the floorboards and finding the correct stain and varnish to match the floorboards around the rest of the house. I will of course pay for the varnish and any materials needed for this. I also have random orbital sander if this helps. The part that I really need help with is refinishing the floorboards after the carpet is removed, and making sure the new varnish perfectly matches the other floorboards in the house.

Full sand and stain required for our original hard wooden floorboards. We have renovated our house and kitchen floor had vinyl so there’s glue and marks to be removed. Cabinets and kitchen will be complete by end of May, so 10th June start date would be good. Realise in person quote will be required prior to starting job.

Kitchen is being renovated and section of floor needs to be removed and replaced to suit new design. We have the material ready to go - Due date: Before Thursday, 29 February 2024

We need carpets ripped up and the floorboards underneath sanded and polished in 3 bedrooms, hallway and loungeroom - Due date: Needs to be done on Wednesday, 7 June 2023

hardwoord floor sanding and sealing

I Need to refinish my Matte finish wooden floor to satin finish - Due date: Needs to be done on Wednesday, 6 July 2022