Find experienced local fencing contractors in NSW

Build and install Windsor pine white fence in the front and back garden. 27 linear metres in total. 1 metre high. The locations are both on retaining walls. The front garden is 16.5 linear metres plus gate. The back garden is 10.5 linear metres, no gate. Materials to be supplied. The cost can be excluding the materials to be determined.

Garden fence has slipped out of line and one panel has fallen down. Needs to be repaired

We need large garden pots moved to allow access to replace the side fence

Wanted help in setting up a trellis on this frame. The length is around 6mts and there will be 5 horizontal rows. Would need two more rows of wire so the total rows will be 7. The ends need to have the turnbuckle for tension.

Hi, we are looking to get an iron fence in our front garden (currently brick wall) to match our neighbours. The wall is c5m in length and we are located in Newtown. I have attached some pictures of our wall and the neighbours fence and wondered if you could confirm whether this is something you can assist with and whether you can provide a rough quote based on the information provided or if you want to come out to see the house.

Get and install two side gates between house and side fences

Install 2x 1.8m high x 0.9m wide timber gates side by side on side of house. I will supply gates, gate latch, gate hinges , posts and screws for you to install.

Install 2x 1.8m high x 0.9m wide timber gates side by side on side of house. I will supply gates, gate latch, gate hinges and screws for you to install. You provide and install posts and bolts/anchors for posts

I need a fence installed along the front, a garden or front yard fence.

Build & paint timber paling fence We are looking to get a timber paling fence built at the end of our garden. • Dimensions: approx. 6 metres wide x 3–4 metres high • Style: lapped & capped paling fence (flat along the top) • Height to match the highest point on the left-hand side • Fence to be painted white to match the rendered side walls (we can provide paint if required) • Built with treated timber suitable for outdoor use • Timing: ideally within the next couple of weeks (sooner the better)

Need 13-15 metres of timber fencing installed. 1.8-2 metres in height. Will be mounted on top of a low brick wall; requires core holes drilled and galvanised metal posts into brick wall. Current bamboo screen will be removed.

Garden fence to be installed in the front of the property total length is 7.45m long x 1.2m high with 0.5m return.

I have a fencing job I'd like to have completed and. I'd like to replace 4 green fake panels and have something similar to the wooden panel out in its place. 3 large panels size 240cm x 90cm and 1 small panel 90cm x 94cm. The wooden panels in that photos are examples of what I would like to have replace the green sections of that current fencing. Budget is for time only. I will pay for material as you may quote to build the wooden panels or source them already made to fit the fence. I don’t mind either way. Many thanks. Paul.

I bought these panels and want someone to help me to add them to the existing fence.

I want help installing a garden fence. Need to look nice and secure. Length 10m including gate Height 1.2m

I want new fence and gate for my garden.

Need to remove the existing fence and install new Timber fencing Approximately 17 meters of length

Require experience with pool fence certification. A few small fixes around the pool fence. Will require a trip to Bunnings at Dural for wood section and stake and maybe screws. Ideally a handyman/gardener with experience meeting pool compliance rules: - use a shovel to level out the ground under pool fence in 4 small some sections of fence, where the ground is too high. - hammer wooden stake/plank in one small section (50cm section) where gap under fence is too large - check around the fence for any loose screws. See images of the pool certification fixes needed. Should take 1 hour.

21.5 in Length Need new metal posts with timber sleepers

Hi there, We have just rendered and painted our external wall and had to remove our garden gate in the process. We have restored the gate and now want to reinstall. The brackets are very old so we may need to buy new hardware and a lockable latch. We are away and have Airbnb guests coming Sunday. We would love for you to go and look at the gate to see what hardware is needed, then go to Bunnings to purchase, the come back to install. We will of course pay for the required hardware. Would love for you to install tomorrow :-)

Hi I am looking for something easy and cheap to put in place down the side of my house to keep my 2 small dogs through the day , can any one help me I don't want it put into the ground needs to go towards brick work or fence line. I have a wooden one up atm but its falling apart.i want something like that but stronger and need to be able to push open

t-post and wire dog mesh fencing for property on bush with some hilly terrain

We require a dog fence for our rental property in federal. The fence needs to be 92metres approx around the perimeter of the house. A height of 90cm-1m will be sufficient and will need a basic entry gate, simple and galvanised steel vs coloured preferred to be cost effective. Previously the dog has had an old goat wire fence and it’s worked well. You will need to supply the materials and we are hoping to get it done as soon as possible. I have a video of the perimeter I can send through. Thanks!

The rental we are in has mesh (wire) laid over a gap near the fence around the perimeter of the house (approx 8- 10 metres to secure). It is not secured down along the outer edge and is starting to curl up and lift in places. The wire is very sharp and dangerous for our dogs and it looks unfinished/messy. We are not sure what the best option would be so open to suggestions - we were thinking maybe some raised planter boxes (example pic as last one) to cover or some treated timber edging that matches the fence.

1. Fix/replace existing pool fence to make it compliant 2. Provide pool compliance certificate 3. Remove any rubbish/material aftet the job is done

We are looking to block our dog from accessing carpeted areas of the house. We need two timber dog gates which would be hinged from a wall and latched on the other side to a timber stair case post. The two openings are approx 860 wide and 915 wide. The gates would be shorter than the stair handrail. I'd estimate we need them approx 800mm high. p.s. we have tried the adjustable aluminium baby gates before and they damaged the wall. We're looking for something longer lasting, better looking and more integrated with the stair balustrade.

I need 1 panel replaced on colorbond fence

Recently moved in to a new place & need to prevent my dog from escaping. I need 2 tall side gates to be build and a section of wire fence to be built along side of driveway. Also need current fence to be checked and possibly repaired in sections, perhaps heightened. Also hoping to have help to install a dog door at back door

Need someone to put mesh up on the fence out the front of our house so the dogs can go outside and not run on the road. Net mesh provided

I need a steel picket dog proof/dog mesh fence installed around my house and garden, i need two vehicle gates installed, one with a remote control opener.

We have a fence at the front and at the side but the dog is escaping through the garden area in between. We need someone to inspect, buy the appropriate product from Bunnings and secure the area by running wire fencing from one fence to the other.

I need help remove the fence.

Ordered a pre fabricated aluminium fence, install on concrete terrace, require tools to install Dyna bolt posts into concrete

Supply ( I’m happy to buy it under advice) and fitting of strong mesh on verandas to fence off, contain dog to one area and stop dog jumping over railing. Approx measurements 4.5 m by 2.5 . By 2.5. Ideally would like this set up to be easy to put up take down.

We have a small outdoor area which we would like secured for our dog. Am putting $5 in budget as not sure at all of a price yet.

I will need to have a wire barrier installed underneath the house, to keep the dogs from getting out. I have two metal gates which might be good option, they will need to cut to size. It will need to be secured to the piers.

hey just need a fence/cage built for my dog, all instructions and materials all included

I just need an extra fence built in for privacy but more for my pet dog, something not to pricey but secure it would be medium height the person who accepts this job either must supply the fence or I can give extra funds so they are able to buy the fence must come out and do measurements first before picking a fence, can also upload some pictures to give you a rough idea please and thank you

Need a dog gate installed outside on right side of the house in front of a big manual gate..width of gate is 130cm...can be just screwed on type of gate or no drill type. Will need handyman to purchase and install the gate.

Job Details: • Fence 1: Straight panel, approx. 1.5m wide • Fence 2: L-shaped, approx. 2.4m x 1.2m • Each enclosure needs one entry gate • Must include painting/staining in light natural timber colour (we can provide paint/stain or reimburse if needed) • you need to buy materials • Installation to be done at our premises (address will be shared with the assigned Tasker) Requirements: • Experience with timber fencing or carpentry • Must bring your own tools • Attention to detail and clean workmanship • Must complete both enclosures securely and safely for pets

Need to take down old fence and put new colour bond fence down one side of property

I am looking for color bond fencing for my new new home. Length 12.5m + 3m =15.5 m Gate = 1.4m

Supply & install 15.0 meters of 1.8 colour bond fence. 7 meters on level & 8 meters rake. Also 1.3 of pool fence to top of retaining wall.

42 metres of colorbond fencing to be done in a house in Cherrybrook. 1.2m high fence. Willing to pay $100 per metre including material cost.

new a quotation colorbond boundary fence 10m-15m

The fence has been gradually leaning into my property and I want to see if it is feasible to get it straightened without going into the neighbours property. Because of the plants the photos don't show the true state of it.

Need to do side fencing

Colorbond fence has partially collapsed and panels need replacing.

3 panels have been blown out of my Colorbond fence and need to be put back in. Fee negotiable

Side gate 1.8 high 1.2 wide Fence to wall 1280

My colorbond fence has been fitted with a dodgey lock . I need someone to come out today , remove the old one and fit a new secure one asap please

Hi I have a side access gate made of colourbond 2m high by about 1m wide. The latch has come away and needs to be re fitted ( with rivets I expect)

Stall a lockable latch on colourbond fence gate. I will purchase the lock. Lock will be D&D Technologies Lokklatch Deluxe S3 Gate Latch

A colourbond gate has fallen and needs repairing with new sheets and posts

Fix star pickets into ground and reattach two colourbond fence panels

I need my 4 colourbond fence panels at the back straightened out - currently they’re slanting. May need 1 or 2 posts sorted out (in that case I can supply 2 x 20kg bags cement) but this might not be needed and you might want to check during inspection. I also have approx 2m of colourbond fencing needed at the front to be installed to the brickwork- would require you to supply the material and I can reimburse for it. Please quote for your labour to fix the back 4 panels and install 2 colourbond fence panels at the front including the materials.

Colorbond fence gate collapse after strong wind. Reuse existing frames and sheets since it is still in good condition. Screws all gone and need to be replaced. Reattached the gate.

leaning colourbond fence

Hi, I’m looking for someone experienced in bricklaying and fencing (Colorbond) to inspect a boundary fence that’s currently being rebuilt between our property and the neighbour’s. The rebuild includes both a brick base and Colorbond panels. The job was arranged between the neighbour, my brother, and my ex (carpenter) — but I wasn’t part of the agreement or planning process. Now that the work is underway, our side looks: • Mismatched (bricks don’t line up or match existing ones) • Uneven and rushed compared to the neighbour’s • Potentially unsafe or not up to a proper standard I’d like someone to: • Inspect our side only (no access to neighbour’s required) • Check for any faults: poor alignment, uneven footing, rough bricklaying, etc. • Let me know if the job was done fairly, safely, and up to standard • Provide a short written summary + photos for documentation This is for peace of mind and clarity, so I can decide what to do next if necessary. Need someone flexible with timing, even if workers are still on-site. Budget: $60–$100 Open to offers within this range depending on experience & detail level. I’ve attached a couple of photos for reference — not the full job, just key sections to highlight visible issues. The rest has been left out to protect privacy. More details can be discussed after acceptance.

Need infill sheet replaced for colorbond gate. 2.8m W x 1.8m H. Install drop bolt, safety latch keyed lock. Gate to be raised by 50-60mm while refixing. End posts, stiles, frames etc are all reusable.