Find a fence repair professional in NSW

Delve fallen off due to the high wind. 7.5 meters length 3 posts that are broken (refer photo) Fix the same fallen fence back to normal state Make it sturdy so that it shouldn’t fall again

Our fence has blown over during the high winds. The task is really urgent as our dogs can't go outside until it is fixed. Details as follows: - Approx. 8 metres to be fixed/replaced/erected - Steel fences - We have steel posts to use as posts, however, we need them to be concreted in and secured - Photos show existing fence (the other half that is OK). This is the type of fencing we need to replace with the old fence. eg. glavanised roll top wire I think it is called? We need approx. 5 panels to replace the rusted ones that have been blown over. They are 1200 high and 2.4 wide. - We are available for you to come and quote and can be flexible to suit your availability - Task is urgent please - Photos of existing and collapsed fence included in this task

old rural fence to be repaired to make stock proof about 1 km long

Fencing door broken due to excessive wind . Need help to repair it .

Gate needs either replacement or fixed

Strong winds have broken a panel of our colorbond fencing. We still have the panel. Repair required asap.

fence and hinges fell off and need to secure with new post and hinges can fencer pls help repair pictures attached

A panel of colourbond fence fell off in the wind. (The neighbours pool wood is pushing on the fence making it weak in that spot) it’s happened before. Apparently you need special tools to be able to fix this as the screws are different. So I need someone with experience.

Back yard Wooden fence need fix or some panel need to be replaced

Need to fix four pannel colourbond fence

The gate latch needs repairs. All tools need to be supplied by you. Location in Fairlight.

Two jobs: 1. Fix nails (replace) coming up out of deck; 2. Replace rotten fence top railings

Repair the falling fence extension, rescue it and provide reinforcement for the fence extension to ensure it will not be falling

Fence got hit and pushed needs to restore

New Colourbond fence has been backed into and split. Hoping it can be welded instead of needing a replacement.

Updated task (changed from below) Take off gate, repair bottom edge where broken/rotted, repaint and rehang with hardware (new provided if needed) a bit higher so doesn’t drag ground (is there something we can put on bottom edge like a little castor to keep it from reaching ground) ————————— Original post 1. Refurbish / repurpose this gate. Remove and use parts plus new wood pieces to make a single (but wide) smaller gate and 2 side panels (like example in photo). The gate has some rot at the bottom due to dragging the ground and rain (see photo). 2. Strip/sand/repaint in Woodland Grey (Dulux colour) exterior paint. This would involve removing the hardware. New hardware will be sourced for rehanging. You can do this job onsite here or take gates away if you prefer to do at your workshop. See photo of what I want the end result to be similar to (but not colour). We have a fencer coming in a couple weeks who can then install new posts and hang it. I have just put an amount in here to post, please quote as you see fit.

To repair 4 gates (2 fences, 2 pool side) that doesn’t close properly

Want to fix fence panels and posts. Half day job. i have panels and post. Need someone do this job on weekend

- Remove damaged timber rail / fence on front porch and replace with new rail /fence - best match existing.- New bolts. - Discard old timber

A section of timber fence, around 15 meters long, become tilting towards one side. It is because of excessive soil being deposited to the other side. You will need to put back the fence at correct straight position with extra poles, but I don't want to change to new fence.