Find experienced local fencing contractors in NSW

Repair to aluminium powder coated slat fence car gate. 8 slats need rewelding.

Garden gate has come off both top and bottom hinges. Hinges and screws need to be re-attached

Need picket garden fence or rapid fence installation for 15m length

My gate struggles to close. I think I we need to shave off some of the side.

a two year old fence has a 2 meter section that has been damaged and pushed out of line by the growing roots of a pine tree. I need the fence to be repaired. It will require the post that has been pushed to be stood up (which I have tried and failed to do) or replaced with other concreted posts.

I have an existing garden fence panel that needs to be moved circa 400 mm back to its original location. Accidentally moved during a renovation and bow blocks the electrical meter. Holes from original location already there, fence just needs to be taken down then moved back Can be done any day before 29/06/26. Probably 1 hours work. Back gate will be unlocked, no one will be home

Hi! I need someone to install a fence/barrier to block off a section of my backyard in Lane Cove. The area is roughly as marked in the photo – it’s a patch of garden/lawn that I need to keep my large dogs out of while a neighbour’s leak issue is being resolved. What I need: • Purchase and install a grid fence (the type available at Bunnings) to create a barrier around the marked area • It just needs to be sturdy enough to keep large dogs out. • Fence posts/stakes to be secured into the ground Location: Lane Cove, NSW Please include in your quote: • Your labour fee Ideally, for this task, it would be best if you could come to my property first and assess exactly what needs to be done. After that, you could go to the nearest Bunnings, which is only about eight minutes away, purchase the required materials (I will cover the cost of the materials), and then return to complete the work.

Need to fix the fallen garden gate.

I need approx 15m of fencing installed, 1.8m high and it will require some posts to attach the fencing I want on to. I will get all fencing gone before job starts. I need you to supply and install the fencing I have indicated which is the Ekodeck 219 by26mm by 3.6m. This is sold in Bunnings. My budget is firm and i can't exceed. If you cant do it between by budget of $3300 to $3700, kindly do not reply.

Supply and install a new garden gate about 1.5-2m width

need to remove the old fence, and place a new fence. about 20 meters.

Frontyard fencing and garden gates replacement. Please see attached.

A panel of fence has fallen down at the back of the property. It is very over grown with bush - I need to have the fence repaired so the property is fully enclosed.

Looking for an experienced handyman/landscaper to inspect and repair a leaning timber retaining fence in our garden. The fence is starting to tilt outward, and some of the timber posts/sleepers appear to have shifted or deteriorated (see photo). We need it properly repaired so it’s safe and structurally sound. What’s needed: • Inspect current condition • Advise on repair vs partial rebuild • Repair/replace any damaged posts or sleepers • Realign and reinforce the fence Open to quotes after inspection. 📅 Available for inspection: Tomorrow (13 April), ideally after 10am Please comment with your experience and availability, thank you !

Supply n install Fence, 2x gate, pedestrian gate, fence, auto gate, supply install 1.3m tall.

I need a new fence constructed from wood and installed, dimensions 70cm x 2m, install latch

Repair fallen metal garden gate by refixing it securely to the wall. Install two keyed locks on both garden gates (locks supplied – Deluxe S3 Gate Latch). Ensure proper alignment, smooth operation, and durability. Drilling into the metal frame may be required for secure fitting.

We have 3 panels of fencing to be repaired we have most of materials needed, some removal of rubbish will be required. Posts need to be installed and removal of the old fence also.

I have an existing fence and I’d like to add half a metre of height in a tasteful way ontop of existing structure.

Hi, I’m looking for someone to repair a metal frame garden gate. The gate has come loose as the screws/hinges have pulled out due to strong wind. Scope of work: Refix and secure the gate properly Replace screws/hinges if required Reinforce the fixing so it doesn’t come off again Ensure gate opens/closes properly Details: Metal frame gate Likely needs new screws/bolts or hinge adjustment Looking for a strong and long-lasting fix

There is two access points to our clothes line. One is behind a pool feature and the other is from behind the garage. There was gates there before. Solid anchor point. Height 1.5 x 1 meter wide approx. supply and install

Looking for someone experienced with Colorbond fencing/gates to: Adjust/repair side gate so it closes and latches properly. Dog-proof gaps underneath existing Colorbond fencing for a very small Chihuahua. Fence is approximately 16 panels × 2.3 m (37 m total). Around 10 panels have gaps roughly 8–12 cm underneath that need blocking. The remaining ~6 panels have smaller/occasional gaps (under ~8 cm) that should only need minor patching. I was thinking treated timber slats/plinths along the bottom, but I'm open to other neat, durable and reasonably priced options. Please include materials and labour in your offer. Wallsend

Erect 32 metres of dog fence

My balcony has a fence of about 9metres in length. I need to install a Perspex barrier of about 50cm high to prevent my dog from falling off. Job includes purchasing the Perspex and full installation

The post has become unstable so now the sticker won't catch. Also self closer needs replacing

Build a dog fence/ gate from the side of the house to the fence. Just something she can’t jump over. Approx 3 meters

Need part of fence raised

Electric dog fence needs to be fitted/installed around 350 metre property. It’s a Dogwatch 1200FMD. Just needs a handyman

Need someone to put up a temporary mesh fence along my back boundary approx 30 m

Two gaps tightly filled in the fence line

Supply & install galvanised steel welded dog mesh (rigid not rolls), preferably black or brown, openings 50mm x 50mm, wire diameter 3-4mm. Attach to existing metal balustrade fence to prevent dog escape. Length approx 12m, height 1.0-1.1m from top of concrete at base to top of horizontal fence top.

Need someone to get some metal mesh from bunnings and just come install it on my current gate fence so that my dogs stop escaping

Roughly 20 meters of cyclone fencing that needs to be installed with a gate. Will need top rail and bottom rail. Black coloured fencing.

Rectification of pool barrier defects identified in the Pittwater Pool Certification – Notice of Swimming Pool Non‑Compliance (Inspection Date: 8 January 2026, Property: 41 Therry Street, Avalon Beach). Works required: 1) Clear vegetation/leaf litter to restore 1800 mm fence height. 2) Remove vegetation and wires from NCZ5 and close fence gap to <100 mm. 3) Install 60° capping to oversize posts and horizontal rails on timber screens. 4) Modify retaining timber (remove or 60° cut) where it reduces barrier height. 5) Supply and install a compliant CPR sign

I need to install a metal gate on the side entrance of the house for the pet, about 1.5 meter wide and 1 metre high.

Need a basic fence installed to keep a dog inside the garden. The edge for fence has a bush going along but he is finding ways through. Open to suggestions on best method and type of fence for aesthetic as well as effectiveness. Thanks

Gardeners have whipper snipped a wire it just needs to be wired back together

Install in ground pet fence system at front of house

Provide an install dog fencing

Install a dog gate before going upstairs

Gate repair – hinges, stopper and LockLatch installation, stopper hinges and Lokklatch can be supplied I need a side gate repaired and upgraded due to strong wind causing the current latch to break and the gate not staying securely closed. Work required: * Remove/replace the existing damaged hinges if required and install heavy-duty outdoor gate hinges suitable for the gate. * Install a gate stopper/stop plate so the gate cannot swing too far in the wind. * Install a new LockLatch (or suitable heavy-duty gate latch) to securely close and hold the gate. * Adjust and align the gate so it opens and closes smoothly and latches properly. * Ensure the stopper and latch are positioned correctly to handle windy conditions.

Replace 2 colourbond panels in fence

A section of the colorbond fenced has cone out from the frame due to heavy winds and needs to be secured

I need 9 m fence and One m gate 1.8m

You are quoting to install 8 x extension panels on top of colour bond fence My fence is the cottage green one. Photo of extension panels from Screenline pic attached. I already have the 8 x extension panel kits from Screenline.

I have two sections of Colorbond fencing that are slightly leaning and need to be straightened and properly reinforced. The fence is generally in good condition and does not need full replacement. Scope of work: * Straighten the two leaning fence sections * Check the existing fence posts and footings * Re-align and secure the posts/fence * Reinforce the posts as required (including additional concrete/support if necessary) * Make sure the fence is straight, strong and stable after repair * Supply all necessary materials and tools * Clean up after completion Photos attached. Please quote for labour + materials. Looking for someone experienced with Colorbond fence repairs.

Looking for someone experienced with Colorbond fencing/gates to: Adjust/repair side gate so it closes and latches properly. Dog-proof gaps underneath existing Colorbond fencing for a very small Chihuahua. Fence is approximately 16 panels × 2.3 m (37 m total). Around 10 panels have gaps roughly 8–12 cm underneath that need blocking. The remaining ~6 panels have smaller/occasional gaps (under ~8 cm) that should only need minor patching. I was thinking treated timber slats/plinths along the bottom, but I'm open to other neat, durable and reasonably priced options. Please include materials and labour in your offer. Wallsend

I need two Colorbond gates repaired. Both are currently damaged and need to be straightened/repaired so they open and close properly. Looking for someone experienced with Colorbond gates/fencing who can supply any required materials and complete the repairs. Please provide a quote and let me know your availability. Will require straightening of a post and new d lock hatches

Around 10 m Color bond fencing needed , flat surface Happy to pay 90$/m

Hi there. We need someone fence extension done and x 2 gates. Gates are 1.35m x 1.8m includes locks and latches! Install to brick wall. Extension 600 to 900mm (whatever is bigger and not a custom cut!). x 4 panels in surfmist colour. Extension 600mm to 900mm whatever is bigger and not custon cut, x 6 panels in monument. Located bexley 2207.

I need a quote on the removal of an old colourbond fence and a new one installed.

Hi guys, I need someone professional to build and install a colorbond gate to replace an existing one. Dimensions are 880w x 1820h Im currently completing work on a property which gate needs to be replaced. I would like an all inclusive price. Existing lock to be reinstated. Colour is mission brown Rear lane access to drop off materials however parking would be in front of property so access is very good. Let me know what you need to know I would like it completed this week.

Need someone to assist in securing my yard. Need 1.8m colourbond gate to left hand side of house. (Photo with the monument colour colourbond fence) space is about 1-1.5m wide. Down side of garage need colourbond fence to block from fence to garage (about 1.8m high and 1m wide) needs to be able to be removed. Between house and garage (about 3m wide. 1.8m high) needs to be able to be removed. To do renovations. The corner fence between the new colourbond fence and older style fence I need piece of corner metal drilled into it temporarily until I replace fence (I have done it to the opposite side)

Need to extend colorbond fence by 30 cm in height. Length of work - each fence 2.36 m wide (total 15 fences and 15 colorbond sheets) Each colorbond sheet needs to be cut in 3 pieces and then fitted into frames. All material already purchased and available. Tools and labour needed. Need a handyman with drill machine and cutter for colorbond sheets and to help with the work. Pls quote for tools and labour. Also quote for whole task not individual fences. Mention time constraints if any.

A section of Colourbond fencing has fallen over approximately 2500 mm wide. The posts and panels are still there but I think the screws are missing at the top. I need someone to reassemble the fence.

Need someone experienced with Colorbond fence repairs to rectify a leaning fence (Approx. 2 panels) on the side of my house. Soil ground, no concrete breaking needed for posts. Looking for repair only, not full replacement. Please quote with availability and experience.

The bottom of the panel in our gate has corroded through and will need replaced. It looks like the gate frame needs to be taken apart for the new panel to be put in, then welded back in place. Likely a quick job if you have the necessary equipment.

Need to screw in the holder that enables locking for the colourbond gate

Attache two gates on both sides of house as colour bond 1.5 green colors. Thanks as shown in the photo graphs. Supply and instal thanks please. Sorry i am not sure about the cost or prices help me great. VJ

Colour bond sheets and channel rusted and materials are supplied just come and fix the fence all need replacing