Find experienced local fencing contractors in NSW

Install the front gate - Gate will be supplied just need installation and concrete to be poured. Cash in hand job no need invoice Quotation only by guess

Bring garden wire and screws/all materials including ladder Attach wire to facade, length approx 3.4m Trail climber through Height from ground approx 4.3m

Build and install lattice, trim away current hedging in the way.

We need a section of garden fence replaced as it is falling down. Circa 27.5 lineal meters. 1.8m high pails required.

Remove old fence and replace new fence about 19 meters with metal pillar every 2 meters

I need to construct a garden screen for my backyard boundary wall. I have the materials, I just need some help and expertise to get the framework installed securely and level and plum. I have Simpson Strong-Tie Concealed Post anchors to secure the 90mm square posts to the concrete slab and adjacent wall using Chemset 801xs and threaded studs.

Rear garden fence is leaning over due to small fig tree. Tree now removed and fence posts need a re pour of concrete or stakes to support and straighten. Fence is classic double Pailing and is 1.8m high with a 400mm lattice topping 3-4 posts will need stabilising and 1-2 2m lengths of lattice will need replacing as they have broken. Lean is very slight say 10-15 degrees Total length of fence is 15m but leaning component is 3-4 metres OFFER INCLUDES MATERIALS

We need a panel of fencing installed between a main fence through some overgrown bush area. We have the fencing panels.

A self sown tree ( about 1 metre) and a succulent have caused 3 palings to fall from a "fence" and are damaging a sandstone wall. I would like them removed and the palings replaced

Fix bamboo panel to fence

Need repair of metal garden gate latch. Gate is operational but latch needs fixing/replacement. Job requires drilling. Looking for quotes - gate located in Kingswood.

Install a garden gate for me, need to be able to cut through chip wood and either cut into little thin metal fence already there or remove the screws. All chip wood. No concrete.

We have approx. 30 wooden posts in our back garden which are hoping someone can use a chainsaw to make level with the retaining wall.

Need a new side gate (ideally aluminium) installed. 105 wide and 162 high.

Wooden Fence in backyard - on boundary. 1 side only about 7 metres long. Removal of old fence (only the trellis side to be removed - see pictures) as well. Front wooden fence in front yard - both boundary sides. around 3 metres each side.

I have an Omlet Chicken Fence (wire, poles, gate) which I need installed in the garden. I'd rather have someone who has experience with this kind of fence.

I need to install a gate between the house (can drill into brick) and the fence (colorbond fence) to secure dog. Ideally tall timer gate with latch for privacy. Approximately 180cm wide opening. Accurate measurements can be obtained from 17th January (property currently still leased to other tenant). Needs to be installed between 17th and 24th January.

Need to replace colourbond fencing 8 standard that are currently 1.5m panels with 1.8 height panels. Need 2 aluminium slat gates installed at front of property

See photos attached: 1) Removal of wood palings 2)Cut down steel fence into pieces with an angle grinder (you will need to provide the angle grinder) 3) These items to be placed in a skip bin which we will order Fence length: approx 7.5m; Fence height: approx 2.33m

Repair garden fence which is unstable,will need some timber and brackets to secure and cover gap Photos of front and back of fence attached

Needing to create a gated area for my dog which can keep him secured in a section on the property.

Hi my dogs have dug under my colorbond fence and escaped I'm needing help to block it off so they can't get out please

My puppy has decided he likes to escape and dig holes around our fence line. I need these holes filled and covered in chicken wire.

See pictures. I am looking for a carpenter to build a high quality dog gate that goes across a stairway (pictures 1+2). I have seen a dog gate made of nice timber with clear perspex. The purpose of the gate is to look attractive as it will sit at the top of a stairway (current gate and measurements pictures 3-5). Looking for a carpenter not a handyman.

We have a 6x2 m dog run that needs the wire installed on the frame, and a gate. The frame is built however it needs a few bracing pieces screwed in. All material and screws available you will just need your tools.

Hello, I need a dog enclosure built for my dog to run in. I have the fencing material

Handyman to repair backyard fencing to ensure it securely contains a dog – this includes: 1. Installing side door lock; 2. Shaving the wooden side door to allow it to close with ease; 3. Installing panels along the fence to stop dog escaping. See photos of the works required.

We live on a large property and need to fence off an area for our dogs. This would be approximately 70 m in total. You would be going around the garden amongst bushes and a shed. Materials will need to be considered in your quote

Although my yard is fully fenced, there are spaces where a dog can escape. I would like these spaces “patched” to ensure a small dog cannot escape. The job would involve inspecting the yard, buying materials and patching the fence.

There is a school fence along my backyard and I want chicken wire (that I have) attached to the fence with cable ties (which I have) - then cover the chicken wire with some used shade cloth that I have - this is to prevent a small dog from exiting nor seeing out of the yard into the school behind me.

I am looking to build a dog house like this

I need to put fencing indoors at my factory. I already have the panels. They have just been taken out for my floors to get epoxied

I have Houdini dogs and have just noticed that a fence panel is loose. Need the panel fixed - doesn’t need replacement.

Need a quote done for pool fence & Install. For council certificate.

Need a gate put in at side of house to keep dog in back yard. Just something from Bunnings and installed.

Install cat fence in small yard. Two sections of wooden fencing of approximately 10m each.

I need a good looking barrier/dog gate for my new dog put up so he can’t escape. See pics

I have about 20 holes in Brushwood Fencing that I need patched. The holes are caused from dogs and foxes. I need the holes patched with brushwood or alternative. The Patch only needs to last about 12 months until the entire fence is replaced. Attached are some example photos. Job in West Pennant Hills

I have two side access that need gates to dog proof our property. You will need to get all supplies and install please. You’ll likely need to come and measure.

Two gates need fixing where rust has broken metal fence

Need a competent labourer to assist with rebuilding a Colorbond fence. Includes replacing the panels and rails and adding extensions as well as building a couple of additional panels and one gate. Atleast one full day. Friday and possibly Saturday. Please let me know your hourly rate.

In need of a quote for colorbond double gate supplied 1.8high I think the colour is domain or primrose refers to photo for length don’t need it fitted or poles just a latch I’ll install myself

One or two panels collapsed as a tree fell with the rain. Need them to be re erected and fixed. Tree has been removed as you can see the panels came off.

Looking for quote to hand a gate at side of house. I have colourbond gate and posts. Width of gate is ~1500mm

Need fence replaced after cyclone .

Quote to Remove and install 50meters of domestic fence quote for colour bond and pine wood double lapped steel post timber rail 6 ft. Easy access. Thanks Dean

Have the fence (panels, etc) sand and cement for 7.2 metre fence. You will just need the screws and put it all together. Replacing exisiting wooden fence which I will remove. Happy to answer questions and/or arrange a site visit.

Hi, I need help fixing a Colorbond gate. The bottom of the gate is scraping the ground, and one of the posts is loose. I’d like to trim the bottom slightly and secure the post so the gate opens smoothly and stays stable. I can send you a video of the issue, or you’re welcome to come inspect it before quoting. My budget is up to $200. If any extra work is needed, please let me know upfront and provide a fixed quote before proceeding. I do not accept unexpected add-on charges during the job. Thanks!

Need infill sheet replaced for colorbond gate. 2.8m W x 1.8m H. Install drop bolt, safety latch keyed lock. Gate to be raised by 50-60mm while refixing. End posts, stiles, frames etc are all reusable.

30 metre of colour bond fence installed and supplied (1800 high in monument)

Hi there – please see pics attached! I want to match my left-hand front fence to the right. This would involve: 1. Relocating the ‘sloped’ panel to the front. 2. Replacing the 4 x existing panels with higher ones. The dimensions of the panels I want to replace my current ones with, are approx.. 187cm high and 237cm wide. See pic attached/below!! *note: I have since had an arborist remove the overhanging branches in the pics, so there is clear access to install now. ****happy to discuss costs, $1k is just placeholder****

I have a milkcan 13line clothesline that needs to be installed onto my colourbond fence

Full replacement of current colorbond fence & gate which has had its day (as pictured) with new colourbond fence & gate - Length 5.4metres.

Two bent c posts need to be removed and replaced with new concrete footing to be poured for posts.

The bins got burnt, this happened next to the fence, the color bond fence got discolouration because of this incident. The estate agent wants us to get this fixed, it required a repaint or the panels to be replaced, there are 2 panels perpendicular to each other - Due date: Flexible

I need this fence to be screwed back in as it has fallen out of place during recent winds

Simple repair job to secure one section of a Colourbond fence. The section has three panels which need to be re-attached. Just needs a patch up job as the fence will need to be replaced soon but needs to be made secure in the meantime

A small panel of the colourbond fence has detached

Urgent please I have all the parts I just need help putting together. This is an existing colourbond fence the top plates have been replaced. as the old ones were bent and panels had popped out. I have tried to do it on my own. my son was going to help me he has gone camping instead. I need to get it done so my dog doesn't escape.

1.remove and dispose existing timber fence 2. Install new green colorbond fencing 3. 1x Colorbond gate