Find trusted local electricians in South East Perth

Looking for a quote to install 4x 1.5kw split AC units. 28c ceilings Wall mounted outdoor units Will supply units. Electrical + Refrigeration.

Need an electrician to replace Floro tube light ballast. Or change it to an Led tube setup. The could be in the roof. Job is in Belmont, WA

I’m seeking help with (1) a severe vibration/resonance issue on my existing split system, and (2) a quote to supply and install 3 new split systems for the bedrooms at my property in Wilson (Perth). 1. Existing AC – Severe Vibration/Resonance (Outdoor Unit) * The outdoor unit is wall-mounted on a weatherboard exterior wall. * Fan-only mode is quiet, but when cooling/heating starts (compressor running), the unit vibrates heavily and produces a strong low-frequency hum. * The vibration/resonance transmits through the wall/timber frame into the adjacent bedroom and is disturbing sleep. Could you please inspect and advise the best fix? I’m open to solutions such as: * identifying/eliminating any pipe contact points or mounting issues * installing proper anti-vibration isolators/mounts (suitable for low-frequency vibration) * reinforcing/reworking the bracket if required * relocating the outdoor unit to a ground slab/stand if that’s the most effective option 2. New Install – Quote for 3x Bedroom Split Systems I’d like to install 3 split systems in the bedrooms. Could you please provide: * an estimated supply + installation quote (and any size recommendations for typical bedrooms) * what is included (electrical works, condensate drain, wall brackets/stands, pipe runs, commissioning, etc.) * warranty details and any ongoing servicing recommendations Site Visit / Access I work FIFO on an 8:6 roster, so I’m generally only at home during my 6 days off. Please let me know your availability for a site visit/quote and I’ll coordinate access. Thanks and I look forward to your response.

1. Install 1 new power point next to the newly installed nbn box Location: Above a built-in storage cupboard has ceiling access 2. Relocate an existing power point Move approximately 10 cm to the left or to the door trim which ever is easier (No ceiling access this part of house) 3. Disconnect one power point and internet socket point just cover so it sits flat to the wall, putting a wardrobe there so don't need any plaster work Can you please list the earliest possible time to do the work, thanks.

Inspect smoke alarm and RCD unit and provide electrical compliance certificate if appropriate

I’m looking for someone experienced and licensed to help with the following electrical work at my property: Install 3 light sensors Install 1 light switch Install 4 wall power sockets (GPOs) Please let me know: Your experience with similar electrical work Whether you are insured If materials are included or need to be supplied Your quote and availability Location: Kewdale Flexible with timing but prefer this done soon. Thank you 😊

Hey there, my late father home built in 10950's has old wiring. I want to check it out up there as I'm trying to find some family paper work my dad stored, I have a feeling it might me up there. Looking for a professional willing to come up with me and help me out, in terms of where best to step etc. Open to rate please advice accordingly. House is two bedroom lounge and kitchen.

Hi, I need a qualified electrician or licensed data cabler to install and terminate a Cat6 RJ45 wall socket in my garage in Wattle Grove. Job details: • Property: Residential house • Location: Wattle Grove, Perth • NBN type: FTTP (NBN box already installed in garage) • Cable run: Approx. 1 metre • Task: • Terminate Cat6 cable into RJ45 wall socket • Connect correctly to NBN UNI-D port • Secure wall plate neatly • Test connection to ensure working internet The cable run is very short and straightforward. Looking for: • Licensed electrician or registered cabler (please confirm) • Proper termination using punch-down tool • Cable testing after install • Clean, neat finish Please provide: • Your quote (including call-out if applicable) • Your availability (preferred within the next few days) Thanks l

Fix light in common bathroom Prefer to clarify while quoting if you have a call out fee or not. Prefer no call out fee. light is hard wired

House has tripped 2 times when the air con and hot water was on. Want an electrician to get that checked and fixed

Multi job, wire and install new power point. Replace existing downlight with pendant light. Repair faulty power point.

Replace fluro with 2 x downlights

Need to install around 10 down light and 2 power point inside house in cannington

I’m based in Sydney and have had Synergy and WA power say power is working fine for my new build. I’ve had cleaners and gardeners say they can’t get power going, and require someone with electrician skills to assess why power power isn’t turning on. It’s only 5 months old site, and need skills of troubleshooting and if possible fixing the issue.

I need someone to go into my attic and replace 10 LED downlights with 10 new downlights. All downlights come with plugs. No wiring nor any other electrical works. Happy to supply the ladder and give a hand from ground level.

NBN technicians advised that a conduit is required for the NBN box to be installed in a specific room. It needs to be run through the roof or along the wall. Possible 10m

Install reticulation controller which I have purchased.

1. Install two ceiling fans with lights into existing light fixtures 2. Install 5 LED 60cm batten lights in garage into existing wiring. Just replacing fluro’s. 3. Check on outside fans in patio area. They don’t appear to be making a difference. 2 fans may need maintenance.

I have an old split system that needs to be replaced. Brackets and isolator switch are in place. I have a Kogan 2.6 kW system I have ordered and needs to be installed. Should be very straightforward installation.

Plumber removed the connection for solar water heater a while back. Just looking at getting this system removed from the roof to free up space.