Find trusted local electricians in Armadale WA

All electrical ports are available but need two new 15Amp GPO switches connection. Might need to draw wires from existing cabling within the building.

Hi there, I am looking for a licensed electrician to supply and install a dedicated 15-amp power socket in my garage for electric vehicle charging. Job requirements: Install 1 x 15A power point (surface mounted or flush, depending on the wall). Run a new dedicated circuit back to the main switchboard. Install an appropriate RCBO / safety switch on the switchboard for this circuit.

INVOICE NEEDED MUST BE DONE FROM 2 AUG AND NEED TO FINISH BY 5 AUG 3BEDROOM HOUSE SINGLE FLOOR CHANGING ALL LIGHTS TO DOWNLIGHTS NEED ALL INCLUSIVE QUOTE WIRING HOLE CUTTING... TARGET PRICING IS 60 PER DOWNLIGHT MINIMUM OF 25 DOWNLIGHTS NEEDED. TO PAY EXTRA IF ACTURAL NUMERBER ABOVE 25

Water heater replacement

Hi, I need a qualified electrician to come and inspect and sign off certificate of compliance for my offgrid solor system. As it is an offgrid system neither the equipment or the certifier need to be cec accredited.

Double power point installed near toilet in the ensuite and a power point in the laundry

Hi ,change of plans since last post , needing 3 power points and 2 fluro lights in a garage

Mount a tv in the theater and living room. Add socket unit to the living room and Alfreso.

Air con is leaking water

Power adaptors to be connected to electric gate

The rangehood switches needs to be replaced Euro ERC60S

I have a old aircon system. I have had to turn it on from the main power supply as it was coming on and off its self and i could not control it from the wall unit. Looking to have it serviced or repaired.

More than once when we use the toaster the power in the sockets goes off. The lights are still there .

Change a small 0.37KW Single phase electrical motor. Uncouple motor from pump Put in a new motor couple back

Fully renovating old house. Qualified electrician required. - Remove old switches and install new switches - Remove old power points and install new - Remove old fan and switch - Install Ethernet internet access (2 port ethernet plugs) 2 x locations - Inspect all old cables and ensure compliance and safety

Just need someone to replace blown light bulbs in four down lights in bathroom

Need to remove 3 bayonet light fittings and install sockets ready for LED down lights once ceilings are repainted. One or 2 external lights also need looking at

I need an electric connection from the house to the shed

Doing a full reno. New for old mostly. Install only replacement of 9 ceiling oyster lights, same locations, wall linings will be off, then slight relocation of laundry power outlet, bathroom power outlet likely to stay in the same place but add a wall light above it, and kitchen outlet in the same location outlet, change current pendant to a new pendant, same location, exhaust fan install in bathroom, more complex stuff is run separate power for new electric oven and cooktop (15amp is required)(which is currently gas but want to switch it over) new oven and cooktop to be installed. Would be 2 separate days. Day 1 has to be the 3rd of april, day 2 a week or so after. Thanks

1 Aircon is not blowing out cold air 1 Aircon is showing E9 I’m pretty sure last time that happened it was something to do with water in the switch board