Find trusted local electricians in Preston Lower

Hello there, I need an electrician to replace a light fitting which I have already in the living room. I also need the lighting and heating unit to be fixed/replaced in the bathroom

I’m seeking a licensed electrician. I need three LED downlights replaced (they’re wired in). I also need my rangehood’s lighting unit assessed for repair/replacement (it’s not the bulbs). Also, the electrical sparks on my gas stove randomly trigger when the stove is not in use. Thanks

Install two Electrical GPOs with USB C charging in plasterboard, existing circuit available on opposite side. Low wattage use for phone charging, LED spotlight, vacuuming. Total wiring length between two new GPOs is 3 metres, plus allow an extra two metres to access circuit.

Bedrooms x 2 need an additional power point, only have one in each room and all are poorly positioned. Would also like to hide wires from TV in loungeroom with new point if possible.

After an electrician to complete the following: 1. Install two fans (pic 1) where pre exisiting batten lights are. 2. Make safe two powerpoints (pic 2) prior to removal of pre exisiting stone 3. Replace a couple of powerpoints

I would like to get some quotes to upgrade the house to three phase power and add additional power points in different parts of the house. This is a Victorian worker cottage house, currently on cosmetic repairs.

We've just moved into our new place and when I went to use the mounted air-conditioning control panel some of the wires snapped (very effortlessly). I've attached a photo, but I think they just need to be stripped slightly and reinserted.

I have purchased an oyster light for my bathroom (see image). I need an electrician to remove existing heat lamp (see image) and replace with new oyster light. I have made sure the oyster light will fit over the hole left behind from the heat lamp. Thanks!

We have a tv that we would like to have mounted on and into / flush with the wall. We also would like to have dimmers placed on existing ceiling rail spotlights, and lighting in bathroom.

I would like a split system unit removed from one wall and re connected on the wall next to it

Hi need to connect some cc cameras and run some cables at my cafe for coffee machine and combo oven . Thankyou

I need an electrician to remove two existing fluoro lights and replaced with twonew light fittings. Can be done today if you can? Or tomorrow.

Am looking for an electrician to either raise or install 2 powerpoints - 1 in the loungeroom and 1 in the bedroom and to wall moint two tvs (already have tv brackets)

We need someone with a very tall ladder (we have high ceilings) to reinstall some smoke alarms. This needs to be done by tomorrow evening at the latest.

I want classy fairy lights installed externally in front of hour and backyard - no flashing or brightness And I also need some decorations placed in front yard and on roof Bonus if you can decorate a Christmas tree - just want fair lights and red ribbons only on it

My nest thermostat has died, have no way of turning on my hydronic boiler, need electrician with HVAC understanding to come have a look

I have had a new roof exhaust fan replaced in the bathroom. There seems to be an issue with that particular wire and isn’t working. The fan is new and has been tested at a different point & is fine. The electrical wire at that point only will need to be replaced. It’s located in the bathroom right next to the man hole so very easy access.

Two LED downlights are flickering (one in the kitchen and one in the living area). I need someone to isolate lighting circuit. Remove existing light fitting. Test the light circuit for suitability. Install replacement Downlights. Pls see the attached photo. Pls quote for both material and labour.

We need to terminate a powerpoint and remove it from the skirting board so we can move a wardrobe to cover the area

I need a licensed electrician to install a new power point in the toilet so I can connect a bidet (above the tiles) • The toilet and laundry share a wall (see attached photos). • There is an existing power point in the laundry. • The new power point should be installed inside the toilet, ideally close to the toilet for easy bidet connection. • Must comply with safety standards and compliance, licensed. Requirements: • Licensed electrician only • Must provide tools and materials •