Find trusted local electricians in Blacktown

I am looking for an electrician who can - replace the Chandelier (approx 470cm height) -can put 2 pendants in the bedroom (need to extend connection) - and while doing the chandelier replacement can hang an art on the side wall! See photos

We had an aircon installed but now need it to connect to the power. Please send me a quote to discuss further.

Need to get 3 air conditioners cleaned/serviced. 1x Split ~3kw 2x Window <1kw

Looking for a licensed plumber to install a dual-outlet garden tap by teeing off the cold water line located beside my heat pump hot water system. Job Details: • Existing power point and water line already accessible next to the hot water unit. • Short pipe run (approx. 0.5–1 m) to new tap location. • Include a ball valve shut-off for isolation and ensure a neat, secure installation. • The property already has a main backflow prevention device (bidets installed in all toilets), so additional backflow prevention at this tap is not required. • Tap will supply a hydroponic vertical garden (permanently connected) and general garden hose use. • All fittings, pipework, and a solid brass dual outlet tap to be supplied and installed by the plumber. • Ensure the work meets AS/NZS 3500 compliance standards and provide a Certificate of Compliance after completion. • Ground-level access, clear workspace, and close proximity to the existing plumbing line. • No wall chasing or complex routing expected. Site Conditions: • Fully accessible outdoor area. • Power and water available at the location. • Concrete base beside hot water unit with wall for tap mounting.

Change 2 downlights in my apartment kitchen

Water flow got suddenly low ,advised that the valves replacement will fix the issue

need to install a pendant light in dining area. provision for light installation already available .

Move hot water tank from blackthorn to mortdale

2.7kW Reverse Cycle 687x420x62mm Window Vertical Opening

Hello, We are looking for a licensed electrician to attend our retail store, in Westfield Mount Druitt, to diagnose and repair a faulty track light. The Issue: One of the black, cylindrical track spotlights on our main sales floor is flashing/flickering. This is a potential safety concern and is very disruptive to the store environment. The Job: The task is to find the cause of the flashing and perform the necessary repair to ensure stable, constant light. The scope of work includes: 1. Safely accessing the high ceiling track system (a suitable ladder is required). 2. Diagnosing the cause of the fault (likely a failed LED unit or a faulty driver). 3. Supplying and installing a new, like-for-like replacement track light fitting. 4. The required model is a Sydney Vision Lighting, ZOOM TRACK 1 CIRCUIT, Code: ZOO1533B-1, 15W 3000K. Please see the attached photo of the product label for all specifications. 5. Testing the new light to confirm it is fully operational and the flashing has stopped. Please note: The successful contractor MUST be able to source and supply the specific light fitting. The cost for this item must be included in your final offer. Requirements: - MUST be a fully licensed and insured NSW Electrician. - You must have your own tools, including an appropriate A-frame ladder suitable for a high commercial ceiling. - Experience with diagnosing faults in commercial LED track lighting systems is essential. Location & Timing: Location: Westfield Mt. Druitt Cnr Carlisle Avenue & Luxford Road. Mt Druitt NSW 2770 (exact location will be provided once the task is assigned). When: The job can be completed at your earliest convenience. Please state your availability in your offer. Please provide a comprehensive quote for the complete job. Your offer should include all labour costs AND the cost of supplying the one specified track light fitting. Thank you.

Task: Electrical Works – GPO Relocations, New Power Points & Decommissioning Location: Minchinbury NSW ⸻ Scope of Works (All works must be completed by a NSW Licensed Electrician and a Certificate of Compliance for Electrical Work (CCEW) must be provided.) 1. Move existing GPO down – supply & install new Double Power Point (DPP). 2. Remove existing GPO – supply & install new DPP and re-attach to wall. 3. Remove existing GPO – supply & install new DPP and re-attach to wall. 4. Remove existing GPO and reinstall lower down – supply & install new DPP. 5. Decommission existing GPO permanently 6. Install new DPP – take feed from GPO directly behind wall. 7. Install new DPP – take feed from GPO directly behind wall. 8. Relocate existing GPO – and supply/install additional new DPP. 9. Cut off redundant GPO cables including relocating earthing cable as required. ⸻ Notes • Total approx. 7x new/repositioned DPPs + 1x decommission + earthing work. • Standard white Tesla DPP (or equivalent) outlets acceptable unless otherwise agreed. • All work to comply with AS/NZS 3000 Wiring Rules, NSW regulations, and safety standards. • Must clean up work area after completion. ⸻ Requirements • Must be a licensed NSW electrician (please provide licence number when quoting). • Must supply compliance certificate (CCEW) after completion. • Must provide all tools, materials, and fittings (unless otherwise agreed). ⸻ Photos (Attached in post for clarity – numbered references included in scope.) ⸻ Please quote inclusive of labour, materials, GST, and certificate. Budget flexible for the right person.

Bathroom - Remove 2x down lights and 1x long light and replace with new ones I have already purchased. Changing from gold to white

Need to get the following done: 1. Remove old and fit new exhaust with heat lamps in bathroom- have got the product 2. install new sensor lights in the backyard - can buy the product or you bring after consultation 3. ⁠install fairy light series on the front of house using gutter hooks - got the product 4. ⁠new 2 power sockets installation on the inside of cabinet Refer to pics to get an idea. 1. House pic shown for fairy light installation 2. New Exhaust and heat lamp 2. Cabinet shown for power sockets

Replace light switch in bedroom (1 switch), bathroom (5 switches) and garage (2 switches)

Replace 3 downlights, will need small ladder

Qualified electrician needed to replace 2 X smoke alarms. Existing smoke alarms are hardwired - I need these two to be replaced with new hardwired smoke alarms. I will supply the smoke alarms - clipsal

We need an electrician to install the following: 1. Remove 1 square light and install light piece in its spot. 2. Remove 1 square light and install approx. 2 down lights in its spot. 3. Install 3 down lights outside and one sensor light. This is a standard one storey house. We’re available all day today or until mid day tomorrow. Kindly provide price as accurate as possible.

Need to replace 2 switch boards and replace 3 downlights and change ring camera LEd is possible

Install only First Floor Bathroom Two IXL IXL units will be supplied Front of house wall lights Remove existing four lights and replace with four Martec Crew lights Martec Crew lights will be supplied Licenced Electricians only to quote the job Thanks

The light fitting has come away from ceiling on rental property and need to be fixed back up. please see photo.