Find local air source heat pump installation & repair in Blacktown

Putting a heat pump dryer onto the washing machine

I have a Beko heat pump dryer model BDP710MG which has stopped heating. Either thermostat or heat element not functioning. Request quote for parts and labour, prefer no service call out fee. Please respond be email in first instance.

Brand is SOLT, makes grinding/scraping noises when turn spinning

Water is not draining from the Samsung heat pump dryer during operation. While drying clothes, the internal tank fills up with water, causing the cycle to stop. An error message appears instructing to empty the tank before restarting. The issue repeats even after emptying the tank

Remove old heat pump which is ducted. Replaced it with modern energy efficient air cons system. Already have ducted zoning in place. Single story house easy access. Need price for supply and install.

Looking for a licensed plumber to install a dual-outlet garden tap by teeing off the cold water line located beside my heat pump hot water system. Job Details: • Existing power point and water line already accessible next to the hot water unit. • Short pipe run (approx. 0.5–1 m) to new tap location. • Include a ball valve shut-off for isolation and ensure a neat, secure installation. • The property already has a main backflow prevention device (bidets installed in all toilets), so additional backflow prevention at this tap is not required. • Tap will supply a hydroponic vertical garden (permanently connected) and general garden hose use. • All fittings, pipework, and a solid brass dual outlet tap to be supplied and installed by the plumber. • Ensure the work meets AS/NZS 3500 compliance standards and provide a Certificate of Compliance after completion. • Ground-level access, clear workspace, and close proximity to the existing plumbing line. • No wall chasing or complex routing expected. Site Conditions: • Fully accessible outdoor area. • Power and water available at the location. • Concrete base beside hot water unit with wall for tap mounting.

Error code 63 showed up couple of times before, I used to turn it off/on and it starts working. But now the error is constant.

2 Drains from heat pump to be merged with existing outlet

Dryer stopped working doesn’t heat everything else works I believe it has to do with the heat pump.

we currently have a gas water heater. heard there are NSW /Federal incentives to change to energy efficient hot water systems. we are very interested. - Due date: Flexible

Hard wire SensaHeat 24kw pool heat pump. Pump is already in place and plumbed in. House is on 3 phase power. Existing wiring in place for the pool filter and chlorinator. I’m unsure if it is heavy duty enough to take the Heat Pump as well. This will need to be assessed. Photo of board added. I will be having solar installed in the next month so upgrade to a smart meter will be completed. Run from the meter box to the pump location is from the front left as you look at the house (switchboard mounted exterior of garage) to the rear right adjacent to the pool. Access via roof cavities is good with initial access above the garage then up to the main roof cavity which has good manhole access from an upstairs bedroom. - Due date: Flexible

My Bosch hear pump dryer is not drying. Probably a heating issue. Need an expert to fix it at a reasonable price.