15 Electricians in Cammeray

Hello. I would like someone qualified to change an old outdoor light to a new one. It is on the balcony and is easy with just a step ladder to get to. I have the light and the drill if needed. I have attached what the old outdoor light looks like. Thanks

Rangehood fan and light not working

Please help to disconnect the stove from electric. I have bought a new oven and need to move the old stove out.

I need 2 down lights changed, however the ceiling is very high and a ladder is needed. See photo.

I need help with a fan light that is no longer switching on. I also have a stairwell light that is no longer switching on. I have attached photos of the fan and the stairwell light. Thanks!

I need a floor lamp rewired, it may need a new lamp holder. Ideally I would prefer a foot operated on/off switch although an in line hand with might do (which I have).

Need someone to come and replace all the lights switches to modern digital ones. ( about 15 of these around the house. Also replace all of the old power points with the new modern ones ( about 15 of these )

I have a vintage lamp. The fitting that the light globe goes into broke and needs replacing.

New lights and power points to be installed.

We have some lights in our home in Cammeray which will require an electrician to help us update: Hanging ceiling light 2 x wall lights Update 30 halogen ceiling spot lights (hard wired) with our new LEDs All new fittings have been purchased, with required base plugs etc as needed.

I need someone to replace two outdoor wall lights with two brighter options. Looking at replacing the below with duel par 38 led floodlights. Lights will be provided. Only labour required. Simple job for a qualified sparky. Slightly dangerous for a simpleton like me.

I need three light fittings removed that are wired in. See photos. Two are the same and one bigger one. Lights need to be working after fittings are removed until I get new ones.

Need HFC cable neatly run into the ground floor unit from the front door. Cable stops in conduit above front door.

Hello, our 2 yo tumble dryer has recently started making a loud clanking noise when turned on, and now doesn’t dry clothes anymore. Please can you come and fix it for us? Thanks!

Qualified electrician required for the following: 1. Piggyback additional PowerPoint on adjacent wall to existing point, to go inside shaving cabinet 2. Loop existing light circuit to create 2 gang switch with wiring to adjacent wall for LED strip light to be installed around shaving cabinet. Walls are currently bare, but will require channels created in single brick wall. All materials to be supplied by tasker, however I will provide switch, PowerPoint and led strip.

Recently renovated my bathroom, an electrician has allowed all wiring, just needs to be connected at the light switch. The outcome is to be: 1 switch for ceiling lights (existing wired) 1 switch for an LED strip around my shaving cabinet Per the attached photo, the wire coming out of the ceiling (barely visible above the tiling) comes from the circuit to the wall switch cutout, and the wire poking out of the tiles up high also comes to the wall switch. This circuit is to be finished. Disregard the lower wire poking out from tiles Note - all materials supplied by me. task to be completed Saturday afternoon, Sunday, or any day next week

I have an issue where turning on a particular light switch (2 way) for outdoor lights (3 on the circuit) is tripping the safety switch. I’d prefer for a licensed electrician to investigate and resolve, rather than risking my own life. I’ll be home most of tomorrow, or Thursday night!

We have two Brivis heater controllers in our home (one upstairs and one downstairs). Our downstairs unit has recently changed on the display and is no longer operating. Our other brivis controller is fine and the heating in that zone is unaffected. We need someone to come and fix the controller and get our heating working again downstairs.

I’m not sure exactly what the problem is but the lamp is a “touch” lamp where you tap it to turn it on & off and that feature no longer works.it might be the plug or the lamp itself

I have a Power point in one of my bathrooms which my daughter says she can feel an electric current through. I just want it checked to make sure it is safe and to repair it if needed.