Need a heat pump water heater supplied and installed with STC and NSW ESS rebates. Preferred brands are Sanden and Reclaim. Please quote - Due date: Flexible

Bought a Matrix electric desk from office works. Struggling to find the time to spend assembling it. Hoping to have it assembled asap. - Due date: Before Friday, 22 July 2022

Need power point in bathroom for bidet

Bathroom fan and light currently on same switch. Wanting to be able to use them separately so have them put onto separate switches.

Need someone to install another socket for the 2nd NBN (FTTN) connection and terminate it outside the wall/facia where the current NBN (FTTN) lead-in comes in. The distance between the outside junction box(? the one attached to the facia) and the first socket is about 2 metres. The property is a single-level brick-veneer house with reasonable clearance on both the attic and under crawl space. You can also inspect and quote for the home data cabling (running CAT cables, security camera points, etc.). I'd like to trial (speed and reliability) with the 2 FTTN connections for a few weeks before going ahead with the home wiring installation. If the internet connections don't improve with 2 FTTN connections, I may opt-in for NBN FTTP (TCP), and any home cabling has to accommodate that setup, hence the delay.

1. Install sockets, run CAT6 cables to all rooms, and terminate them at the central location - refer to attached photo for a rough layout. You need to supply all materials (cables, wall plates, keystones, parts etc.). Distance between wall plates and the number of data points: Study to Bed 1 - 10m; 2 sockets Study to Living - 6m; 4 sockets Study to Study - 3m; 2 sockets Study to Family - 15m; 4 sockets Study to Play - 15m; 2 sockets Roughly would need ~150m of cable, and the central point would need two wall plates/patch panel. 2. Additionally need to install another socket in the Living for the 2nd DSL connection and terminate it outside wall/facia where the current NBN (FTTN) lead-in comes in. Property is a single level brick-veneer house with reasonable clearance on both the attic and under crawl space. Need someone to do the work ASAP.

I have power going to my shed which is getting demolished but I want to keep power there so I have a small pole and hpm outdoor PowerPoint I want wired up (see pic). Must be licensed electrician. I will bolt it to the concrete and have power cable at the power point for wiring and sealing (if needed). Flexible with date and time, home almost all the time.

I need 4 power points installed. 2 for garage door, pulling current from current light switch. One outdoor power point. One indoor power point; I have one on opposite side so it could be used . One sensor for outdoor light.Date/time flexible Thanks

Require two new plug sockets: - One double socket in bedroom. None currently on particular wall. - One double socket in kitchen. Currently others on wall but not in required location. House is circa 1970. Thanks

2nd hand Panasonic split system to be installed. Model no K410A, CU-E24JKR.. My daughter traded up to haveing ducted aircon and so gave me this. It is probably about 10 yeras old but was working perfectly. I have put a cent slab down for the outside unit. It possibly needs a service too. Because it was removed from another house, the electric external wiring and the tube that runs from the inside unit to the outside inverter needs to be replaced. There is a power point where it needs to be installed on the inside. This unit is for the front room of a single story house.

Need electrician to trouble shoot power on boat and solar panels..its moored at Berowra. 2large batteries..an inverter 3solar panels..12volt and 240 v power

Hi i need someone to install a new oven which replaces and old unit already removed. New oven has 15amp power plug or can be hot wired to existing wires as per picture.

Looking for an electrician to install a new ceiling mounted light fitting in a bedroom and also separate 1 circuit into 2 if possible in a kitchen area (so hanging lights can be switched on independently of ceiling lights).

Replace 2 standard light switches with dimmer switches (already purchased) for LED downlights. Must be an electrician and be certified.

Need an electrician to Disconnect freestanding stove and reconnect new electric freestanding stove. New stove is on site ready for installation Assist with loading old stove in trailer for disposal. Job to be done on Thursday or Friday.

Emergency electrician: 2 led lights 2 spotlights 1 outdoor light 1 oyster light To be installed today no holes to be drilled; replacement lights.