Find trusted local electricians in Melbourne Western Suburbs

Looking for a fully licensed electrician to install 1 new double power point (GPO) on a plasterboard wall in my room. I have a brand-new standard double GPO plate ready. You will supply the cabling, standard mounting clip/bracket, and handle the wiring. Cable Run Options: Option A: Extend from nearby outlet (~2.5 to 3 meters). Option B: Drop down from ceiling cavity access if easier/shorter for you. I’m open to whichever method is easiest and quickest on the day! Key Details: Scope: Wiring & installation of 1 double GPO. Materials: I supply the GPO outlet faceplate. Electrician supplies cabling and mounting clip. Photos: Attached (shows room layout). Requirements: Must be a licensed and insured electrician. Please include your license number with your offer. Flexible on date/time.

Remove Pavers and cut concrete Dig Trench Appoximately 10Lm from existing conduit to new pool pump location Connect power to existing switch board and at unit and install new power supply at pump location Provide Electrical Compliance Certificate

Two LED ceiling downlights are failing. Require supply of hew downlights and install (to match as closely as possible).

Need roughly 40 downlights. Most of the house already has old style downlights but some rooms need new installed. Need only certified electrician who can provide certificate and some warranty. There are some other electrical work that we can discuss once the task is assigned.

I need the attached pendent light installed in the dinning room. We already have a bulb there, we need it replaced. Beacon lights are charging $225 for the install. I’m here to find out if it’s going to cost me less. Thank you

Hi need to install chandelier, it’s not heavy , ceiling height is 6 metre! Need proper support ladder for 6 metre ceiling, need to take off old lamp and install new

Need to do extra lighting on the right and left as you can see in the picture. Extra power point for fridge. Need one data point upstairs

Remove wired smoke alarm and replace with a new unit I have already purchased. I have low ceilings .

Need to replace entire house ceiling lights, any wiring necessary. Old light is globe in the middle and require downlights throughout. Aprrox 30 downlights. Certificate is a must

Water heater went off, not turning on Used a lighter to turn on the pilot but letting go off the pilot button turns the pilot off

Need an electrician to installa ceiling light. I have attached the photo and dimensions including weight. It need to be installed on ground floor of a Double Storey house. Please quote.

I have purchased a pendant light - https://www.beaconlighting.com.au/api/pdf/colette-3-light-pendant-in-bronze-with-fluted-natural-linen/with-price?srsltid=AYCX9vKxySUiQNgjUJV9RU1riJcjukBdtNz35v_VVsoejQ1Wo2owLEc2 Need to install it in the dining area. See photos attached. Also a bathroom exhaust fan is broken so need to get that replaced. I will buy the fan from bunnings and just need the installation . Only licensed electrician needed. If you’re not licensed, please don’t bother sending an offer. Inspections welcome. Cheers

We already have the wiring in the spot where the doorbell needs to be installed. We need a certified electrician to install the new door bell (shown in pic).

Hi there, I am after an electrician to install 2 * 10 amp out door sockets on a brick wall, in my alfresco area. There is an existing 2*10 amp indoor socket on the other side of the wall, at the same level ( as shown in photos ). Please quote as supply and install scope, including a CoES certificate

New garage door installed which currently has an extension cord running from unit to the power point. Need cord to be run through conduit? and then another power point installed as I only have a single one which means I can't operate two things at once.

Two small, straightforward jobs at one property — both licensed electrical work. I already have both products, and I'll provide the wiring diagrams and manuals once you accept. Should be quick for anyone experienced with smart switches. Job 1 — Single gang smart light switch for pendant lights: Swap out an existing single-gang light switch and fit a new Matter smart push-button dimmer in its place, running two dimmable LED pendants. It's a 2-wire dimmer (no neutral — red to active in, red to load out, grey and black leads not used). Job 2 — Bathroom fan run-on timer: Fit a Clipsal 31ROFT run-on timer behind an existing 3-gang switch so the exhaust fan keeps running for a few minutes after it's switched off — the two light switches on that plate stay exactly as they are. It's a small unit that tucks in behind the fan switch; I'll leave the wiring detail to you on the day. Happy to answer questions — please quote for both jobs in one visit.

Need to fix and correct install a switcher for my bathroom which turns on the lights and the fan. This is an apartment and not a house.

Looking for a licensed electrician to supply and install 1 × double power point. The electrician will need to supply the double power point switch/socket and any other required materials for the installation. Please include parts, labour, installation and testing in your quote. I would also like an invoice/receipt after completion. Thanks!

Need 15 down lights replaced to Led -Existing ones are hardwired- please quote for install with surface outlet plug base - quote for install only-product supplied. Don’t need any certificate Also have a one year old door bell not working if could fix that too.

Looking for a licensed electrician in Fraser Rise to complete the following: * Supply and install 6 x downlights & a dimer switch * Supply and install 1 x new power point * Install my BYD 7kW single-phase EV charger I already have the BYD charger. Looking for everything else to be supplied and installed, including any required cabling, safety switch/RCBO and electrical certificate.