Find trusted local electricians in West Footscray

I need electrical work to be done to new area 4 downlight and 1 power point on wall

1. Installation of 14 LED downlights, 5 circuits, 3 dimmers. Refer attached layout for the arrangement, most rooms have existing single light circuit which can be reused. 2. Installation of pendent linear light 3. Installation of an outdoor GPO, convert existing light to a GPO. as per the image. Dimmers and Downlights supplied by me.

I need to have a pendant light changed in my home, removing one and swapping it for another. Older light fitting to be replaced for new one in box.

Edit: I already have FTTC. Just need FTTP and NBN is unable to install NBN box further than the front entrance. Looking for an electrician to route the connection box for FTTP so it's not right at the house entrance as NBN technician is unable to do this. Only needs a small extension by 1-2 metres. Box not yet installed - getting wiring done first per advice from NBN

The light switch in the bathroom, does not turn on. It is a two switch unit, one for fan and one for light. The fan works, but you cant press the light switch down to turn on

PLEASE READ TASK DESCRIPTION. I WILL NOT HIRE ANY STOCK RESPONSES. Sensor light installation with light switch wired to enable manual mode (always on). Install three pos light switch (see pic). I currently have a sensor light installed, however not sure if it has a manual mode option, therefore have purchased ‘Brilliant Black Raptor III Twin Security Light with Sensor’ (see pic and manual). - 3 pos light switch supplied - Sensor light supplied You’ll need to run an additional wire from new 3 pos switch to sensor light. There are currently three wires running from light switch to current sensor light. Inside light switch is approx 3 metres from sensor light. Roof is tiled.

I have several power outlets in my home (living room and kitchen) that are not holding plugs properly. Whenever I try to plug in multiple devices in the kitchen they pop out, and the living room plugs won’t stay in at all anymore. I want a licensed electrician to: 1. Inspect the affected outlets. 2. Replace any worn or faulty outlets. 3. Ensure all outlets are safe and functioning correctly. Must be a licensed and insured electrician. Requirements: Provide a quote including labor, materials, and any call-out fees as well as estimated job time/availability Thank you 😊

We require a licensed electrician to attend to a burnt fuse issue. The main fuse at the property appears to have burnt out (see attached photos). Please inspect, provide a quote, and advise on any further safety upgrades needed. Cost of truck will be paid by us.

Need to replace some lights and potentially install dimmers. Looking for a quote at this stage l. I’d like to replace that first round pendant light with the IKEA 3 lamp pendant. I’d like to replace the other 3 globe pendant with just a single hanging pendant lamp (not chosen yet). I’m also considering installing some dimmers on the down lights. There are 2x rooms and 4 down lights in each. Finally I’d like to replace the ceiling lights with pendants. A single one is pictures but there are two along the hallway.

Removal of an old door bell system

Hi there, looking for help to fix a light fitting and plaster / paint that has been removed by hangings. Looking for the job to be done today afternoon or tomorrow morning.

Sensor light installation with light switch wired to enable manual mode (always on). Install three pos light switch (see pic). I currently have a sensor light installed, however not sure if it has a manual mode option, therefore have purchased ‘Brilliant Black Raptor III Twin Security Light with Sensor’ (see pic and manual). - 3 pos light switch supplied - Sensor light supplied

Raise water temperature in shower and upstairs (Heat pump) Here are the temperatures I noted (degrees celcius): Heat pump Panel temperature: 55 Water out of tank temperature: 53.1 Water out of tap (ground floor) temperature: 44.8 Water out of shower (first floor) temperature: 34.5 I would like the upstairs water temperature raised to 44.8 as it is currently too cold.

Need to replace a broken powerpoint. I will provide the part

I need a new battery to be put in, my current nbn system is saying it needs to be replaced. Payment includes paying for you to bring a battery(I don’t have one), as well as pop it in

I have a campervan with power output but can not find a power plug to fit. Campervan has a new battery.

Install 5 standard powerpoints, 2 powerpoint with usb, 1 line for cooktop, switchboard upgrade (replace trip switch to combine with new trip switch and add another switch for stovetop).

Air conditioner outdoor stopped working Sunday/Monday last week. Found that the circuit had tripped on our circuit board on Monday morning. Flipped the circuit back on and tried operating the air conditioner, but internal units turn themselves off after starting up. Found that the outdoor unit not operating, fan not moving, no noticeable activity. Appears to be an electrical fault. Looking for a service on Friday 31st Jan or as soon as possible. Can be available any time. Thanks Stephen

Air conditioner outdoor stopped working Sunday/Monday last week. Found that the circuit had tripped on our circuit board on Monday morning. Flipped the circuit back on and tried operating the air conditioner, but internal units turn themselves off after starting up. Found that the outdoor unit not operating, fan not moving, no noticeable activity. Appears to be an electrical fault. Looking for a service on Thursday 30th or Friday 31st Jan. Thank Stephen

Hi, I need to plug sockets replaced/fixed and a celling fan light bulb replaced. The two plug sockets - one sockets switches are sinking into the wall. The other is pushing the plug out when I put one into the outlet. I’m unable to get the light bulb cover off to change it.