Find trusted local electricians in Werribee

Power point to be installed at back wall of garage. Closest power point is on the next room but not same wall. Also there is one power point on the ceiling for garage door motor. Single storey house.

Needs brand new downlights with surface sockets and wiring if necessary including lights. Currently using a e27 screw globes that goes into traditional socket system. This is old property. By Installing new lights. Hope the rooms are much brighter. Photos attached for the current lights and how they are fitted. Install and supply of all parts please.

Out outdoor wall lights don't work. Lights are less than 2 years old. Suspect its the power switch that's faulty. Need a licenced electrician to check/fix the issue.

Need more lighting in the house preferably in the lounge. The light socket I currently have are blocking the light. It doesn't allow light to spread around. How can I get more lighting. May be new form of light sockets. Photo shared. I am open to advise regarding it. Also I need to install new sensor lights in my backyard. The ones I have are broken. Photo shared I am unsure how much it will cost me. Perhaps it's better to visit my property first and give me a quote with your recommendations.

Need tri-color downlights (90mm) installed in 1 room, 4 in total, with a dimmer. Also need warranty and certificate of work in case of any issues with the electrical work. Currently there is only single switch to turn on and off the lights. Might need 40" tv installed as well, but not sure at the moment.

Double power point in kitchen needs to be replaced.

Replace old solar+gas boosted system.

Need Qualified electrician to replace single baton lights at Upstairs rooms with LED down lights to First floor. Plan attached. Total Downlights required 36 in level 1 can be provided. Beacon Classic 4 9W LED Downlight. - 36Nos. Pls provide a quote .

Hook up 2 new PowerPoints (wiring done) to live power and extend the wiring on an existing point

fix led mirror in powder room tiled wall with existing junction box

Hello, We are looking for a licensed Electrician to correct a lighting circuit issue at our retail store, at Pacific Werribee. The Issue: Our newly installed advertising lightboxes have been incorrectly wired to the same switch that controls our 'pre-testing' lights. This means every time our staff use the pre-test lights, the main promotional lightboxes on the sales floor turn off, which is disruptive and looks unprofessional. The goal is to separate the lightboxes onto their own dedicated switch. The Job: The task is to re-wire the lighting circuits so that the new lightboxes and the pre-testing lights operate independently. The scope of work will involve: 1. Attending the site and tracing the wiring at the relevant switch location. 2. Safely isolating power to the circuits. 3. Re-configuring the wiring at the switch plate. The store has noted there are spare/unused switches available at the same location, which should be used to control the lightboxes. 4. Testing both lighting groups (lightboxes and pre-test lights) to confirm they now operate on separate, independent switches. Requirements: - MUST be a fully licensed and insured A-Grade Electrician in Victoria. - You must have your own diagnostic tools and a suitable ladder to access any ceiling wiring if required. - Experience with commercial fit-outs and lighting circuits is essential. Location & Timing: Location: Level 1, Pacific Werribee, Cnr Derrimut and Heaths Roads, Werribee VIC 3030 (exact location will be provided once the task is assigned) When: The job can be completed at your earliest convenience. Please state your availability in your offer. Please provide a comprehensive quote for the complete job. Your offer should cover your call-out fee and all labour required to complete the re-wiring as described. Thank you.

I need a electrician to install an outdoor double power socket Please quote for: 1. Installation including the socket, and 2. Installation without the socket (I’ll supply it).

Air conditioner can be turned on and off but does not cool or heat properly

Hello, Need an electrician for the following with the compliance certificate: 1. Move the electrical power point near the cooktop to behind the rangehood cover. 2. Move the electrical power point near the sink to the right-hand side above the microwave oven cabinet. 3. Install a double electrical power point inside the microwave cabinet. Images attached.

Hi there, i have a VW Amarok 2014. I need a dash cam and rear camera installed. Also need rear LED on tub rack connected to reverse lights but also able to be turned on/off as required when camping 2 x side LEDs connected to 2nd battery in tub. Additional accessory connections from the dual battery and ignition wire back to fuse box. Would you please quote and let me know when you're available? I have most of the equipment but not all of the wiring and connections that might be required. Regards David

I had a Starlink satellite delivered to my house and I need someone to install it somewhere where it can have unimpeded sky access. I have roof access via a skylight if needed or it can go on top of the lower garage roof or whatever you think is best.

I require a registered Electrician to move a couple of power points. One is a little further along a wall, the other is to the opposite side of the wall (from bedroom to inside walk-in)

Looking for someone to supply & install a power point outside on our balcony, double story house. See attached electrical plan, Bed 1 Balcony - red circle is the preferred location.

Add 2x power point and ethernet point at the back of the TV to hide the cables at the back. Currently the power points and ethernet are down below 300mm from near the floor and we need to add/raised those points at around 1600mm to be kept at the back.

Sparky here, just moving my nbn box however when pulling back my fibre cable I have damaged the connector. I need someone who can reterminate the fibre to connect back into my nbn box. I don’t have the correct tools.