Find trusted local electricians in Tarneit

setting up pendant lights and sockets.

Replacement of 110mm LED Downlights (Supply & Install ) 90mm Tri colour LED downlight at new point (Supply & Install)

I need to install 5 double power point on first floor

I need 4 electric power points on my couch fixed and one recliner

We are looking for a licensed electrician to install four (4) new double power points in our newly built home in Tarneit. The power points should match the style shown in the attached photo. Work Requirements: * Install 4 new double GPOs (same style as the photo) * Ensure neat and professional wiring with minimal wall impact * All work must comply with Victorian electrical standards * Must provide an electrical compliance certificate and a warranty for workmanship * Clean up after installation About the Property: * Newly built home in Tarneit * Clear access to all installation locations Electrician Requirements: * Must be fully licensed and insured * Must provide proof of license when quoting Please share your experience, estimated cost, and availability. Looking to get this done as soon as possible.

Following work required at my home, 1. Floodlight wiring outside garage door(incl. Floodlight fitting) i have Ring Floodlight 2. Wiring for pendent light(single point) over kitchen bench. 3. Dual powerpoint in alfresco wall.

experienced handyman bird mesh needed for my house need to prevent the birds for damaging our solar panels only experienced people, who done this before, please send your offers to assign this task

I need quotation for install 4 scokits , power point (I will provide power point and equipment ).

4 LED Downlights (White color) need to be replaced in the lounge area, in a house on Fresh View Dr in Tarneit

Basic safety checks and repair in the house

Electrician needed to fix minor things in the house - wardrobe LED, OVEN connection - LEDs and ready installed , only need to connect and the new Oven is installed only need to connect

1. Install 4 ceiling fans (Portsea 132cm DC Ceiling Fan with LED Light & Remote Control) • 2 rooms already have junction boxes • For the other 2 rooms: either remove the existing light fittings and replace them with fan-with-light units using the same switch or advise on the most cost-effective option. 2. Living room: Fix a faulty light switch with incorrect wiring/connection. 3. Facade lighting: Replace 4 exterior lights (existing switches and wiring already in place). 4. Side area: Install a more powerful two-way light with a motion sensor 5. Install an additional exhaust fan in the ensuite.

Need best price quote for 12 downlights in eaves at front of house . Single story house with tile roof. Have switch already for light outside.

I am looking for a licensed electrician to complete several outdoor electrical jobs: • Install new power plugs outside • Run electrical wiring under a newly built verandah • Install new front lights once the cladding work is completed • A few other small electrical tasks around the house If you are experienced and available, please contact me for a quote. 📞 Please message or call me directly. Thanks!

Refit this socket in pic

Hi, I am looking for a estimate cost for electrical work. I’m planning a full house renovation, but since the house is occupied, I’ll be doing it one stage at a time. I’m looking for a rough estimate for the following: - Disconnection and rough-in ,fitout work in bathrooms,toilet and kitchen - Installation of a bathroom exhaust fan and heat lights etc - Any other necessary electrical work for the renovation if needed Could you please provide your approximate charges to help with budgeting? Location Tarneit. Thanks

6 new electrical plug sockets to be installed in my house.

Need to get my existing internet cable replaced from CAT 5e to CAT6/7 and also need 2 extra data points in my home

I have a switchboard that looks like the B&R horizon T22 switchboard (long). The 2 hinge parts on the right (that allows the door to open l) has broken due to wind action and an ajar door. The broken hinge part looks like the attached photo. Can someone provide 2 of the hinge parts and install/fix the door such that the switchboard can be closed again?

Install a power point next to the blind on the right.