Find trusted local electricians in Perth

Need qulaified person to diagnose and fix my generator Recently serviced cranks but wont start suspected fuel issue *new oil *new spark plug *new battery *fresh fuel Last person didn't fix issue need someone qualified will pay for parts needed

Hi, I’ve got an office with around 20 old 1200×300 fluorescent ceiling lights. Right now only 3 switches control everything. I want to add 3 new separate switches, fitted inside 3 different individual rooms. Each new switch will control the lights within its own respective room. Also please quote two options for upgrading: 1. Keep existing light frames, fit T8 LED tubes and bypass old ballasts 2. Swap everything for brand‑new integrated LED panel lights. Could you send me pricing for the switch re‑wire and both LED upgrade options? Thanks.

Looking for a licensed electrician to connect power to a small IP66 outdoor equipment cabinet mounted on my gate column. Trenching and conduits are already done by me (power, Cat 6 data, and an existing sprinkler line, all laid at correct depths and separation per AS/NZS 3000 and AS/CA S009). Cat 6 cable has also been pulled through. Scope required: Pull and terminate the mains power cable through the pre-laid conduit (open to either pulling it myself for you to inspect and terminate, or you doing the full pull - happy to discuss) Install DIN rail mounted GPO(s) inside the cabinet to power four low-draw devices (WiFi extender, network switch, security base station, smart lock gateway) Circuit protection and termination at the home switchboard Certificate of Electrical Compliance on completion

Looking for a qualified electrician to replace and install 10 exterior light fittings and investigate/fix one separate security light sensor. All replacement light fittings have already been purchased and will be supplied. No new light fittings need to be supplied by the electrician. All 10 fittings are replacing existing lights in the same locations. No new light points are required. Scope of work: • Replace 7 existing wall lights on exterior brick walls with new light fittings. All are approximately head height. • Replace 3 existing up/down lights mounted on metal poles with new light fittings. All are approximately head height. • Investigate and repair a separate sensor controlling a security light. The sensor is not operating correctly and the light currently stays on continuously. Please include labour and any standard installation materials required to complete the work. Located Mount Claremont, 6010

Several of the built in LED down lights in one system are flickering and then one in another system completely out. ?needs replacing

Replace electrical cord on a GHD hair straightener

Remove pendant light. Unsure if I’ll replace

Fuse to washer and dryer in electrical board has blown. Never tripped before. Assume it is just the fuse

Measure and drill four holes in the balcony ceiling to hang a grow light for my balcony garden

One AirCon control panel button not working. Carrier Comfort Zone II ducted reverse‑cycle air‑con. Main wall controller: only the Mode button is dead, all other buttons work perfectly. Cannot start air‑con. Require ARC‑licensed technician to repair button or source replacement panel. House is in City Beach.

Old switch has been removed and the new dimmer is ready to go in. Transco LED Dimmer Rotary (trailing edge, 350W max). Wiring is exposed at the wall. Needs the new unit connected.

Split system install from $700. Ducted system install. Get ready for summer to cool down your house. Aircon service and cleaning.

Four new downlights install in bedroom.

Existing switch buttons broken and need replacement in 3 power switch to oven/ fan/ light in kitchen . I will supply replacement part. Should be very quick and easy drive by job

URGENTLY NEED - Gas plumbing tradesman to check out a Vulcan 135L outdoor gas water heater which appears to be leaking from underneath - may lead to more if new gas water heater installation is needed

Requesting an elevated power point so that we can safely plug in a baby monitor for our little one

Old light switches are worn out and not functioning. They need replacement. There are two.

Need a new power point installed in brick cavity wall. Existing power point on otherside of wall which should allow easy connection.

2 specific power points/switches not working (photos attached: kitchen wall socket; no power; another wall socket). Other outlets in the house are fine. Switchboard photos also attached.

Townhouse in Northbridge. Need an electrician to remove the 2 existing light pendants in my living room and replace with 2 LED lights I have purchased online (see images provided), connecting them to the existing light switch.